參數資料
型號： AD604ARZ
廠商： Analog Devices Inc
文件頁數： 7/33頁
文件大小： 0K
描述： IC AMP VGA DUAL ULN 40MA 24SOIC
標準包裝： 31
系列： X-AMP®
放大器類型： 可變?cè)鲆?br>
電路數： 2
轉換速率： 170 V/µs
-3db帶寬： 40MHz
電流 - 輸入偏壓： 400nA
電流 - 電源： 32mA
電流 - 輸出 / 通道： 40mA
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 24-SOIC（0.295"，7.50mm 寬）
供應商設備封裝： 24-SOIC W
包裝： 管件
產品目錄頁面： 774 (CN2011-ZH PDF)
配用： AD604-EVALZ-ND - BOARD EVAL FOR AD604 AMP
AD604
Rev. G | Page 14 of 32
PREAMPLIFIER
The input capability of the following single-supply DSX (2.5 ± 2 V
for a +5 V supply) limits the maximum input voltage of the
preamplifier to ±400 mV for the 14 dB gain configuration or
±200 mV for the 20 dB gain configuration.
The preamplifier gain can be programmed to 14 dB or 20 dB by
either shorting the FBK1 node to PAO1 (14 dB) or by leaving
the FBK1 node open (20 dB). These two gain settings are very
accurate because they are set by the ratio of the on-chip resistors.
Any intermediate gain can be achieved by connecting the
appropriate resistor value between PAO1 and FBK1 according
to Equation 2 and Equation 3.
()
6
5
||
7
R
V
G
EXT
IN
OUT
+
=
(2)
()
[]
() ()
6
5
6
7
6
5
6
R
G
R
G
R
EXT
+
×
×
+
×
=
(3)
Because the internal resistors have an absolute tolerance of ±20%,
the gain can be in error by as much as 0.33 dB when REXT is 30 Ω,
where it is assumed that REXT is exact.
Figure 38 shows how the preamplifier is set to gains of 14 dB,
17.5 dB, and 20 dB. The gain range of a single channel of the
AD604 is 0 dB to 48 dB when the preamplifier is set to 14 dB
(Figure 38a), 3.5 dB to 51.5 dB for a preamp gain of 17.5 dB
(Figure 38b), and 6 dB to 54 dB for the highest preamp gain of
20 dB (Figure 38c).
FBK1
PAO1
COM1
PAI1
FBK1
PAO1
COM1
PAI1
FBK1
PAO1
COM1
PAI1
R6
8
R5
32
R7
40
a. PREAMP GAIN = 14dB
b. PREAMP GAIN = 17.5dB
c. PREAMP GAIN = 20dB
R10
40
R7
40
R5
32
R6
8
R7
40
R5
32
R6
8
00
54
0-
03
8
Figure 38. Preamplifier Gain Programmability
For a preamplifier gain of 14 dB, the 3 dB small signal bandwidth
of the preamplifier is 130 MHz. When the gain is at its maximum
of 20 dB, the bandwidth is reduced by half to 65 MHz. Figure 39
shows the ac response for the three preamp gains shown in
Figure 38. Note that the gain for an REXT of 40 Ω should be
17.5 dB, but the mismatch between the internal resistors and
the external resistor causes the actual gain for this particular
preamplifier to be 17.7 dB. The 3 dB small signal bandwidth of
one complete channel of the AD604 (preamplifier and DSX) is
40 MHz and is independent of gain.
To achieve optimum specifications, power and ground manage-
ment are critical to the AD604. Large dynamic currents result
because of the low resistances needed for the desired noise
performance. Most of the difficulty is with the very low gain
setting resistors of the preamplifier that allow for a total input
referred noise, including the DSX, as low as 0.8 nV/√Hz. The
consequently large dynamic currents have to be carefully
handled to maintain performance even at large signal levels.
20
19
10
GA
IN
(
d
B
)
18
17
16
15
14
13
12
11
OPEN
SHORT
50
40
150
8
32
IN
40
100M
10M
1M
100k
FREQUENCY (Hz)
REXT
VIN
00
54
0-
03
9
Figure 39. AC Response for Preamplifier Gains of 14 dB, 17.5 dB, and 20 dB
The preamplifier uses a dual ±5 V supply to accommodate large
dynamic currents and a ground referenced input. The preamplifier
output is also ground referenced and requires a common-mode
level shift into the single-supply DSX. The two external coupling
capacitors (C1 and C2 in Figure 37) connected to the PAO1 and
+DSXx, and –DSXx, nodes and ground, respectively, perform
this function (see the AC Coupling section). In addition, they
eliminate any offset that would otherwise be introduced by the
preamplifier. It should be noted that an offset of 1 mV at the
input of the DSX is amplified by 34.4 dB (× 52.5) when the gain
control voltage is at its maximum; this equates to 52.5 mV at the
output. AC coupling is consequently required to keep the offset
from degrading the output signal range.
The gain-setting preamplifier feedback resistors are small
enough (8 Ω and 32 Ω) that even an additional 1 Ω in the
ground connection at Pin COM1 (the input common-mode
reference) seriously degrades gain accuracy and noise performance.
This node is sensitive, and careful attention is necessary to
minimize the ground impedance. All connections to the COM1
node should be as short as possible.
The preamplifier, including the gain setting resistors, has a
noise performance of 0.71 nV/√Hz and 3 pA/√Hz. Note that a
significant portion of the total input referred voltage noise is
due to the feedback resistors. The equivalent noise resistance
presented by R5 and R6 in parallel is nominally 6.4 Ω, which
contributes 0.33 nV/√Hz to the total input referred voltage noise.
相關PDF資料
PDF描述
TSW-104-14-G-D CONN HEADER 8POS .100" DUAL GOLD
AD526BDZ IC AMP PGA 10MA 16CDIP
53324-0760 CONN HEADER 2MM 7POS PCB TIN
TSW-129-08-T-S CONN HEADER 29POS .100" SNGL TIN
AD524ADZ IC AMP INST 1MHZ PREC LN 16CDIP
相關代理商/技術參數
參數描述
AD604ARZ 制造商:Analog Devices 功能描述:IC AMP VARIABLE GAIN
AD604ARZ-RL 功能描述:IC AMP VGA DUAL ULN 40MA 24SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:X-AMP® 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR)
AD604-EB 制造商:Analog Devices 功能描述:
AD604-EVAL 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual, Ultralow Noise Variable Gain Amplifier
AD604-EVALZ 功能描述:BOARD EVAL FOR AD604 AMP RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:X-AMP® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:-
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*