- 您現在的位置：買賣IC網 > PDF目錄6022 > AD604ARZ (Analog Devices Inc)IC AMP VGA DUAL ULN 40MA 24SOIC PDF資料下載
參數資料
| 型號： | AD604ARZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/33頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP VGA DUAL ULN 40MA 24SOIC |
| 標準包裝： | 31 |
| 系列： | X-AMP® |
| 放大器類型： | 可變增益 |
| 電路數： | 2 |
| 轉換速率： | 170 V/µs |
| -3db帶寬： | 40MHz |
| 電流 - 輸入偏壓： | 400nA |
| 電流 - 電源： | 32mA |
| 電流 - 輸出 / 通道： | 40mA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 24-SOIC W |
| 包裝： | 管件 |
| 產品目錄頁面： | 774 (CN2011-ZH PDF) |
| 配用： | AD604-EVALZ-ND - BOARD EVAL FOR AD604 AMP |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
AD604
Rev. G | Page 18 of 32
APPLICATIONS INFORMATION
The basic circuit in Figure 43 shows the connections for one
channel of the AD604. The signal is applied at Pin 5. RGN is
normally 0, in which case the preamplifier is set to a gain of 5
(14 dB). When FBK1 is left open, the preamplifier is set to a
gain of 10 (20 dB), and the gain range shifts up by 6 dB. The ac
coupling capacitors before DSX1 and +DSX1 should be selected
according to the required lower cutoff frequency. In this example,
the 0.1 μF capacitors, together with the 175 Ω seen looking into
each of the DSXx input pins, provide a 3 dB high-pass corner
of about 9.1 kHz. The upper cutoff frequency is determined by
the bandwidth of the channel, which is 40 MHz. Note that the
signal can be simply inverted by connecting the output of the
preamplifier to DSX1 instead of +DSX1; this is due to the fully
differential input of the DSX.
12
11
10
9
8
1
2
3
4
7
6
5
13
16
15
14
24
23
22
21
20
19
18
17
AD604
VGN
RGN
+2.5V
+5V
–5V
OUT
–DSX1
+DSX1
PAI1
FBK1
PAO1
COM1
COM2
PAI2
FBK2
PAO2
+DSX2
–DSX2
VGN1
VREF
VPOS
GND1
OUT1
VNEG
VPOS
GND2
OUT2
VOCM
VGN2
0.1F
VIN
0.1F
RL
500
00
54
0-
04
3
Figure 43. Basic Connections for a Single Channel
In Figure 43, the output is ac-coupled for optimum performance.
For dc coupling, as shown in Figure 52, the capacitor can be
eliminated if VOCM is biased at the same 3.3 V common-mode
voltage as the analog-to-digital converter, AD9050.
VREF requires a voltage of 1.25 V to 2.5 V, with between 40 dB/V
and 20 dB/V gain scaling, respectively. Voltage VGN controls
the gain; its nominal operating range is from 0.25 V to 2.65 V
for 20 dB/V gain scaling and 0.125 V to 1.325 V for 40 dB/V
scaling. When VGNx is grounded, the channel powers down
and disables its output.
COM1 is the main signal ground for the preamplifier and needs
to be connected with as short a connection as possible to the input
ground. Because the internal feedback resistors of the preamplifier
are very small for noise reasons (8 Ω and 32 Ω nominally), it is
of utmost importance to keep the resistance in this connection
to a minimum. Furthermore, excessive inductance in this
connection can lead to oscillations.
Because of the ultralow noise and wide bandwidth of the
AD604, large dynamic currents flow to and from the power
supply. To ensure the stability of the part, careful attention to
supply decoupling is required. A large storage capacitor in
parallel with a smaller high-frequency capacitor connected at
the supply pins, together with a ferrite bead coming from the
supply, should be used to ensure high-frequency stability.
To provide for additional flexibility, COM1 can be used to
disable the preamplifier. When COM1 is connected to VP, the
preamplifier is off, yet the DSX portion can be used independently.
This may be of value when cascading the two DSX stages in the
AD604. In this case, the first DSX output signal with respect to
noise is large and using the second preamplifier at this point
would waste power (see Figure 44).
相關PDF資料 |
PDF描述 |
|---|---|
| TSW-104-14-G-D | CONN HEADER 8POS .100" DUAL GOLD |
| AD526BDZ | IC AMP PGA 10MA 16CDIP |
| 53324-0760 | CONN HEADER 2MM 7POS PCB TIN |
| TSW-129-08-T-S | CONN HEADER 29POS .100" SNGL TIN |
| AD524ADZ | IC AMP INST 1MHZ PREC LN 16CDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD604ARZ | 制造商:Analog Devices 功能描述:IC AMP VARIABLE GAIN |
| AD604ARZ-RL | 功能描述:IC AMP VGA DUAL ULN 40MA 24SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:X-AMP® 標準包裝:2,500 系列:Excalibur™ 放大器類型:J-FET 電路數:1 輸出類型:- 轉換速率:45 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:20pA 電壓 - 輸入偏移:490µV 電流 - 電源:1.7mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| AD604-EB | 制造商:Analog Devices 功能描述: |
| AD604-EVAL | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual, Ultralow Noise Variable Gain Amplifier |
| AD604-EVALZ | 功能描述:BOARD EVAL FOR AD604 AMP RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:X-AMP® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
發布緊急采購，3分鐘左右您將得到回復。