- 您現在的位置：買賣IC網 > PDF目錄8969 > AD5547CRUZ (Analog Devices Inc)IC DAC 16BIT PAR DUAL 38TSSOP PDF資料下載
參數資料
| 型號： | AD5547CRUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/20頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 16BIT PAR DUAL 38TSSOP |
| 設計資源： | Precision, Unipolar, Inverting Conversion Using AD5547/57 DAC (CN0026) Precision, Unipolar, Noninverting Configuration for the AD5547/57 DAC (CN0027) Precision, Bipolar, Configuration for AD5547/AD5557 DAC (CN0028) |
| 標準包裝： | 1 |
| 設置時間： | 500ns |
| 位數： | 16 |
| 數據接口： | 并聯 |
| 轉換器數目： | 2 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 55µW |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 38-TFSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 38-TSSOP |
| 包裝： | 管件 |
| 輸出數目和類型： | 2 電流，單極；2 電流，雙極 |
| 采樣率（每秒）： | 2M |
| 產品目錄頁面： | 783 (CN2011-ZH PDF) |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁
AD5547/AD5557
Data Sheet
Rev. D | Page 12 of 20
CIRCUIT OPERATION
DAC SECTION
The AD5547/AD5557 are 16-/14-bit, multiplying, current-
output, parallel input DACs. The devices operate from a single
2.7 V to 5.5 V supply and provide both unipolar (0 V to –VREF
or 0 V to +VREF) and bipolar (±VREF) output ranges from –18 V
to +18 V references. In addition to the precision conversion RFB
commonly found in current output DACs, there are three addi-
tional precision resistors for 4-quadrant bipolar applications.
The AD5547/AD5557 consist of two groups of precision R-2R
ladders, which make up the 12/10 LSBs, respectively. Furthermore,
the 4 MSBs are decoded into 15 segments of resistor value 2R.
Figure 18 shows the architecture of the 16-bit AD5547. Each of
the 16 segments and the R-2R ladder carries an equally weighted
current of one-sixteenth of full scale. The feedback resistor RFB
and 4-quadrant resistor ROFS have values of 10 k. Each 4-quadrant
resistor, R1 and R2, equals 5 k. In 4-quadrant operation, R1,
R2, and an external op amp work together to invert the reference
voltage and apply it to the VREF input. With ROFS and RFB
connected as shown in Figure 2, the output can swing from
VREF to +VREF.
The reference voltage inputs exhibit a constant input resistance
of 5 k ± 20%. The impedance of IOUT, the DAC output, is code
dependent. External amplifier choice should take into account
feedback resistance in parallel with the DAC ladder resistance
dominates output voltage noise. To maintain good analog
performance, it is recommended that the power supply is
bypassed with a 0.01 F to 0.1 F ceramic or chip capacitor in
parallel with a 1 F tantalum capacitor. Also, to minimize gain
error, PCB metal traces between VREF and RFB should match.
Every code change of the DAC corresponds to a step function;
gain peaking at each output step may occur if the op amp has
limited GBP and excessive parasitic capacitance present at the
inverting node of the op amp. A compensation capacitor, therefore,
may be needed between the I-to-V op amp inverting and output
nodes to smooth the step transition. Such a compensation capacitor
should be found empirically, but a 20 pF capacitor is generally
adequate for the compensation.
The VDD power is used primarily by the internal logic to drive
the DAC switches. Note that the output precision degrades if
the operating voltage falls below the specified voltage. Users
should also avoid using switching regulators because device
power supply rejection degrades at higher frequencies.
04452-
0
1
2R
80k
R
40k
2R
80k
2R
80k
2R
80k
2R
80k
2R
80k
R
40k
2R
80k
R
2R
80k
R
2R
80k
R
2R
80k
R
2R
80k
2R
80k
R
40k
R2
5k
R1
5k
VREF
2R
80k
R
40k
2R
80k
R
40k
2R
80k
R
40k
2R
80k
R
40k
2R
80k
R
40k
2R
80k
RCOM
R1
ADDRESS DECODER
DAC REGISTER
INPUT REGISTER
LDAC
WR
RS
4 MSB
15 SEGMENTS
8-BIT R2R
4-BIT R2R
15
8
4
LDAC
WR
D15
D14
D0
RS
10k 10k
ROFS
RFB
IOUT
AGND
RA
RB
Figure 18. 16-Bit AD5547 Equivalent R-2R DAC Circuit with Digital Section, One Channel Shown
相關PDF資料 |
PDF描述 |
|---|---|
| VE-20T-MY-F4 | CONVERTER MOD DC/DC 6.5V 50W |
| VE-20R-MY-F3 | CONVERTER MOD DC/DC 7.5V 50W |
| VE-20P-MY-F4 | CONVERTER MOD DC/DC 13.8V 50W |
| AD7249ARZ | IC DAC 12BIT SRL W/REF 16-SOIC |
| VE-20N-MY-F2 | CONVERTER MOD DC/DC 18.5V 50W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5547CRUZ-REEL7 | 功能描述:IC DAC 16BIT PAR DUAL 38TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| AD5547-EP | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual-Current Output, Parallel Input |
| AD5547SRU-EP | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual-Current Output, Parallel Input |
| AD5551 | 制造商:AD 制造商全稱:Analog Devices 功能描述:5 V, Serial-Input Voltage-Output, 14-Bit DACs |
| AD5551_10 | 制造商:AD 制造商全稱:Analog Devices 功能描述:2.7 V to 5.5 V, Serial-Input, Voltage-Output, 14-Bit DACs |
發布緊急采購，3分鐘左右您將得到回復。