參數資料
型號: AD5432YRM
廠商: ANALOG DEVICES INC
元件分類: DAC
英文描述: 8-/10-/12-Bit High Bandwidth Multiplying DACs with Serial Interface
中文描述: SERIAL INPUT LOADING, 0.09 us SETTLING TIME, 10-BIT DAC, PDSO10
封裝: 3 X 5 MM, MSOP-10
文件頁數: 18/32頁
文件大?。?/td> 860K
代理商: AD5432YRM
AD5429/AD5439/AD5449
ADDING GAIN
In applications in which the output voltage is required to be
greater than V
IN
, gain can be added with an additional external
amplifier, or it can be achieved in a single stage. Be sure to take
into consideration the effect of temperature coefficients of the
thin film resistors of the DAC. Simply placing a resistor in series
with the R
FB
resistor causes mismatches in the temperature
coefficients, resulting in larger gain temperature coefficient
errors. Instead, the circuit of Figure 41 is a recommended
method of increasing the gain of the circuit. R
1
, R
2
, and R
3
should all have similar temperature coefficients, but they need
not match the temperature coefficients of the DAC. This
approach is recommended in circuits in which gains of > 1
are required.
Rev. 0 | Page 18 of 32
DIVIDER OR PROGRAMMABLE GAIN ELEMENT
Current-steering DACs are very flexible and lend themselves to
many different applications. If this type of DAC is connected as
the feedback element of an op amp, and R
FB
is used as the input
resistor, as shown in Figure 42, then the output voltage is
inversely proportional to the digital input fraction D. For
D
= 1 2
n
the output voltage is
(
IN
IN
OUT
V
D
V
V
/
/
)
n
=
=
2
1
As D is reduced, the output voltage increases. For small values
of the digital fraction D, it is important to ensure that the
amplifier does not saturate and also that the required accuracy
is met. For example, an 8-bit DAC driven with the binary code
0 × 10 (00010000)—that is, 16 decimal—in the circuit of
Figure 42 should cause the output voltage to be 16 × V
IN
.
However, if the DAC has a linearity specification of ±0.5 LSB,
then D can, in fact, have a weight in the range 15.5/256 to
16.5/256, so that the possible output voltage is in the range
15.5 V
IN
to 16.5 V
IN
with an error of +3%, even though the DAC
itself has a maximum error of 0.2%.
DAC leakage current is also a potential error source in divider
circuits. The leakage current must be counterbalanced by an
opposite current supplied from the op amp through the DAC.
Because only a fraction D of the current into the V
REF
terminal
is routed to the I
OUT
1 terminal, the output voltage has to change
as follows:
Output Error Voltage Due to DAC Leakage = (Leakage × R)/D
where R is the DAC resistance at the V
REF
terminal. For a DAC
leakage current of 10 nA, R = 10 k and a gain (that is, 1/D) of
16, the error voltage is 1.6 mV.
V
DD
R
FB
I
OUT
1
I
OUT
2
C1
GND
V
DD
V
REF
NOTES:
1. ADDITIONAL PINS OMITTED FOR CLARITY.
2. C1 PHASE COMPENSATION (1pF TO 2pF) MAY BE REQUIRED
IF A1 IS A HIGH SPEED AMPLIFIER.
8-/10-/12-BIT
DAC
V
IN
R2
R3
R2
V
OUT
R1 =
R2R3
R2 + R3
GAIN =R2R2
0
Figure 41. Increasing Gain of Current Output DAC
V
IN
NOTE:
1. ADDITIONAL PINS OMITTED FOR CLARITY.
V
REF
V
DD
V
DD
R
FB
I
OUT
1
I
OUT
2
GND
V
OUT
0
Figure 42. Current-Steering DAC Used as a Divider
or Programmable Gain Element
相關PDF資料
PDF描述
AD5432YRM-REEL 8-/10-/12-Bit High Bandwidth Multiplying DACs with Serial Interface
AD5432YRM-REEL7 8-/10-/12-Bit High Bandwidth Multiplying DACs with Serial Interface
AD5440 Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface
AD5443 Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface
AD5444 Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface
相關代理商/技術參數
參數描述
AD5432YRM-REEL 制造商:Analog Devices 功能描述:DAC 1-CH R-2R 10-bit 10-Pin MSOP T/R 制造商:Analog Devices 功能描述:DAC 1CH R-2R 10-BIT 10MSOP - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:10-IOUT DAC WITH SERIAL ITF I.C. - Tape and Reel
AD5432YRM-REEL7 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散(最大):- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率(每秒):*
AD5432YRMZ 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散(最大):- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP,8-MSOP(0.118",3.00mm 寬) 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓,單極 采樣率(每秒):* 產品目錄頁面:1398 (CN2011-ZH PDF)
AD5432YRMZ-REEL 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP,MICROWIRE?,QSPI?,串行,SPI? 轉換器數目:1 電壓電源:單電源 功率耗散(最大):- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型,TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流,單極;1 電流,雙極 采樣率(每秒):2.7M
AD5432YRMZ-REEL7 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:8 電壓電源:單電源 功率耗散(最大):2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP(4x3) 包裝:管件 輸出數目和類型:8 電壓,單極 采樣率(每秒):*