- 您現在的位置：買賣IC網 > PDF目錄373880 > AD5432YRM (ANALOG DEVICES INC) 8-/10-/12-Bit High Bandwidth Multiplying DACs with Serial Interface PDF資料下載
參數資料
| 型號： | AD5432YRM |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | DAC |
| 英文描述： | 8-/10-/12-Bit High Bandwidth Multiplying DACs with Serial Interface |
| 中文描述： | SERIAL INPUT LOADING, 0.09 us SETTLING TIME, 10-BIT DAC, PDSO10 |
| 封裝： | 3 X 5 MM, MSOP-10 |
| 文件頁數： | 17/32頁 |
| 文件大小： | 860K |
| 代理商： | AD5432YRM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
AD5429/AD5439/AD5449
SINGLE-SUPPLY APPLICATIONS
Voltage-Switching Mode
Figure 39 shows the DACs operating in voltage-switching mode.
The reference voltage, V
IN
, is applied to the I
OUT
1 pin, I
OUT
2 is
connected to AGND, and the output voltage is available at the
V
REF
terminal. In this configuration, a positive reference voltage
results in a positive output voltage, making single-supply
operation possible. The output from the DAC is voltage at a
constant impedance (the DAC ladder resistance). Therefore, an
op amp is necessary to buffer the output voltage. The reference
input no longer sees a constant input impedance, but one that
varies with code. So, the voltage input should be driven from a
low impedance source.
Rev. 0 | Page 17 of 32
Note that V
IN
is limited to low voltages, because the switches in
the DAC ladder no longer have the same source-drain drive
voltage. As a result, their on resistance differs and this degrades
the integral linearity of the DAC. Also, V
IN
must not go negative
by more than 0.3 V or an internal diode turns on, exceeding the
maximum ratings of the device. In this type of application, the
DAC’s full range of multiplying capability is lost.
POSITIVE OUTPUT VOLTAGE
The output voltage polarity is opposite to the V
REF
polarity for
dc reference voltages. To achieve a positive voltage output, an
applied negative reference to the input of the DAC is preferred
over the output inversion through an inverting amplifier
because of the resistor’s tolerance errors. To generate a negative
reference, the reference can be level-shifted by an op amp such
that the V
OUT
and GND pins of the reference become the virtual
ground and 2.5 V, respectively, as shown in Figure 40.
V
OUT
V
DD
GND
V
IN
I
OUT
2
I
OUT
1
R
FB
V
DD
V
REF
R
2
R
1
0
NOTES:
1. ADDITIONAL PINS OMITTED FOR CLARITY.
2. C1 PHASE COMPENSATION (1pF–2pF) MAY BE REQUIRED
IF A1 IS A HIGH SPEED AMPLIFIER.
Figure 39. Single-Supply Voltage-Switching Mode
V
OUT
= 0V TO +2.5V
V
DD
= +5V
GND
I
OUT
2
I
OUT
1
R
FB
V
DD
V
REF
C
1
GND
V
IN
V
OUT
ADR03
+
5V
–5V
1/2 AD8552
1/2 AD8552
8-/10-/12-BIT
DAC
–2.5V
0
NOTES
1. ADDITIONAL PINS OMITTED FOR CLARITY.
2. C1 PHASE COMPENSATION (1pF–2pF) MAY BE REQUIRED
IF A1 IS A HIGH SPEED AMPLIFIER.
Figure 40. Positive Voltage Output with Minimum Components
相關PDF資料 |
PDF描述 |
|---|---|
| AD5432YRM-REEL | 8-/10-/12-Bit High Bandwidth Multiplying DACs with Serial Interface |
| AD5432YRM-REEL7 | 8-/10-/12-Bit High Bandwidth Multiplying DACs with Serial Interface |
| AD5440 | Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface |
| AD5443 | Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface |
| AD5444 | Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5432YRM-REEL | 制造商:Analog Devices 功能描述:DAC 1-CH R-2R 10-bit 10-Pin MSOP T/R 制造商:Analog Devices 功能描述:DAC 1CH R-2R 10-BIT 10MSOP - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:10-IOUT DAC WITH SERIAL ITF I.C. - Tape and Reel |
| AD5432YRM-REEL7 | 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:2,400 系列:- 設置時間:- 位數:18 數據接口:串行 轉換器數目:3 電壓電源:模擬和數字 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:36-TFBGA 供應商設備封裝:36-TFBGA 包裝:帶卷 (TR) 輸出數目和類型:* 采樣率（每秒）:* |
| AD5432YRMZ | 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
| AD5432YRMZ-REEL | 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP，MICROWIRE?，QSPI?，串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型，TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:2.7M |
| AD5432YRMZ-REEL7 | 功能描述:IC DAC 10BIT MULTIPLYING 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。