- 您現在的位置：買賣IC網 > PDF目錄22175 > AD532KDZ (Analog Devices Inc)IC MULTIPLIER 10V 14CDIP PDF資料下載
參數資料
| 型號： | AD532KDZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MULTIPLIER 10V 14CDIP |
| 標準包裝： | 1 |
| 功能： | 模擬乘法器/除法器 |
| 位元/級數： | 四象限 |
| 封裝/外殼： | 14-CDIP（0.300"，7.62mm） |
| 供應商設備封裝： | 14-CDIP SB |
| 包裝： | 管件 |
AD532
Rev. D | Page 11 of 16
AD532 PERFORMANCE CHARACTERISTICS
Multiplication accuracy is defined in terms of total error at 25°C
with the rated power supply. The value specified is in percent of
full scale and includes XIN and YIN nonlinearities, feedback and
scale factor error. To this must be added such application-
dependent error terms as power supply rejection, common-
mode rejection and temperature coefficients (although worst
case error over temperature is specified for the AD532S). Total
expected error is the rms sum of the individual components
because they are uncorrelated.
Accuracy in the divide mode is only a little more complex. To
achieve division, the multiplier cell must be connected in the
feedback of the output op amp as shown in Figure 17. In this
configuration, the multiplier cell varies the closed loop gain of
the op amp in an inverse relationship to the denominator voltage.
Therefore, as the denominator is reduced, output offset, band-
width, and other multiplier cell errors are adversely affected.
The divide error and drift are then εm × 10 V/X1 X2) where εm
represents multiplier full-scale error and drift, and (X1 X2) is
the absolute value of the denominator.
NONLINEARITY
Nonlinearity is easily measured in percent harmonic distortion.
The curves of Figure 6 and Figure 7 characterize output distortion
as a function of input signal level and frequency respectively,
with one input held at plus or minus 10 V dc. In Figure 7, the
sine wave amplitude is 20 V (p-p).
AC FEEDTHROUGH
AC feedthrough is a measure of the multiplier’s zero suppression.
With one input at zero, the multiplier output should be zero
regardless of the signal applied to the other input. Feedthrough
as a function of frequency for the AD532 is shown in Figure 8.
It is measured for the condition VX = 0, VY = 20 V (p-p) and
VY = 0, VX = 20 V (p-p) over the given frequency range. It
consists primarily of the second harmonic and is measured in
millivolts peak-to-peak.
COMMON-MODE REJECTION
The AD532 features differential X and Y inputs to enhance its
flexibility as a computational multiplier/divider. Common-mode
rejection for both inputs as a function of frequency is shown in
10 V dc and Y1 = Y2 = 20 V (p-p), (X1 X2) = 10 V dc.
DYNAMIC CHARACTERISTICS
The closed loop frequency response of the AD532 in the multiplier
mode typically exhibits a 3 dB bandwidth of 1 MHz and rolls
off at 6 dB/octave, thereafter. Response through all inputs is
essentially the same as shown in Figure 10. In the divide mode,
the closed loop frequency response is a function of the absolute
value of the denominator voltage as shown in Figure 11.
Stable operation is maintained with capacitive loads to 1000 pF
in all modes, except the square root for which 50 pF is a safe
upper limit. Higher capacitive loads can be driven if a 100 Ω
resistor is connected in series with the output for isolation.
POWER SUPPLY CONSIDERATIONS
Although the AD532 is tested and specified with ±15 V dc supplies,
it may be operated at any supply voltage from ±10 V to ±18 V
for the J and K versions, and ±10 V to ±22 V for the S version.
The input and output signals must be reduced proportionately
to prevent saturation; however, with supply voltages below ±15 V,
as shown in Figure 12. Because power supply sensitivity is not
dependent on external null networks as in other conventionally
nulled multipliers, the power supply rejection ratios are improved
from 3 to 40 times in the AD532.
NOISE CHARACTERISTICS
All AD532s are screened on a sampling basis to assure that output
noise will have no appreciable effect on accuracy. Typical spot
noise vs. frequency is shown in Figure 13.
相關PDF資料 |
PDF描述 |
|---|---|
| AD536AJD | IC TRUE RMS/DC CONV 14-CDIP |
| AD636KHZ | IC CONV TRUE RMS/DC TO-100-10 |
| IDT71016S15PH8 | IC SRAM 1MBIT 15NS 44TSOP |
| AD637JRZ | IC RMS/DC CONV PREC WB 16-SOIC |
| VE-J1D-CX-F4 | CONVERTER MOD DC/DC 85V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD532KH | 制造商:Analog Devices 功能描述:Analog Multiplier/Divider 4-Bit 10-Pin TO-100 Tube 制造商:Rochester Electronics LLC 功能描述:MULITPLIER/DIVIDER IC - Bulk 制造商:Analog Devices 功能描述:MULTIPLIER/DIVIDER |
| AD532KH/+ | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| AD532KHZ | 功能描述:IC MULTIPLIER TRIMMED TO-100-10 RoHS:是 類別:集成電路 (IC) >> 線性 - 模擬乘法器，除法器 系列:- 標準包裝:25 系列:HA 功能:模擬乘法器 位元/級數:四象限 封裝/外殼:16-CDIP（0.300"，7.62mm） 供應商設備封裝:16-CDIP 側面銅焊 包裝:管件 |
| AD532S | 制造商:AD 制造商全稱:Analog Devices 功能描述:Internally Trimmed Integrated Circuit Multiplier |
| AD532SCHIP | 制造商:AD 制造商全稱:Analog Devices 功能描述:Internally Trimmed Integrated Circuit Multiplier |
發布緊急采購，3分鐘左右您將得到回復。