- 您現在的位置：買賣IC網 > PDF目錄375230 > AD1851 (Analog Devices, Inc.) 16-Bit, 16×Fs PCM Audio DACs(16位,單片PCM音頻D/A轉換器) PDF資料下載
參數資料
| 型號： | AD1851 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | 16-Bit, 16×Fs PCM Audio DACs(16位,單片PCM音頻D/A轉換器) |
| 中文描述： | 16位，16 × Fs的PCM音頻數模轉換器（16位，單片的PCM音頻的D / A轉換器） |
| 文件頁數： | 6/12頁 |
| 文件大?。?/td> | 210K |
| 代理商： | AD1851 |
AD1851/AD1861
Analog Circuit Considerations
REV. A
–6–
GROUNDING RE COMME NDAT IONS
T he AD1851/AD1861 has two ground pins, designated Analog
and Digital ground. T he analog ground pin is the “high quality”
ground reference point for the device. T he analog ground pin
should be connected to the analog common point in the system.
T he output load should also be connected to that same point.
T he digital ground pin returns ground current from the digital
logic portions of the AD1851/AD1861 circuitry. T his pin
should be connected to the digital common point in the system.
As illustrated in Figure 2, the analog and digital grounds should
be connected together at one point in the system.
DGND
AGND
5V
+
AD1851/AD1861
5V
–
ANALOG
GROUND
DIGITAL
GROUND
3
16
1
2
12
+5V
+V
L
+V
S
–V
S
Figure 2. Recommended Circuit Schematic
POWE R SUPPLIE S AND DE COUPLING
T he AD1851/AD1861 has three power supply input pins. T he
±
V
S
supplies provide the supply voltages to operate the linear
portions of the DAC including the voltage reference, output am-
plifier and control amplifier. T he
±
V
S
supplies are designed to
operate at
±
5 V.
T he +V
L
supply operates the digital portions of the chip includ-
ing the input shift register and the input latching circuitry. T he
+V
L
supply is designed to operate at +5 V.
Decoupling capacitors should be used on all power supply pins.
Furthermore, good engineering practice suggests that these ca-
pacitors be placed as close as possible to the package pins as
well as to the common points. T he logic supply, +V
L
, should be
decoupled to digital common, while the analog supplies,
±
V
S
,
should be decoupled to analog common.
T he use of three separate power supplies will reduce feedthrough
from the digital portion of the system to the linear portion of the
system, thus contributing to improved performance.
However, three separate voltage supplies are not necessary for
good circuit performance. For example, Figure 3 illustrates a
system where only a single positive and a single negative supply
are available.
In this example, the positive logic and positive analog supplies
must both be connected to +5 V, while the negative analog sup-
ply will be connected to –5 V. Performance would benefit from
a measure of isolation between the supplies introduced by using
simple low pass filters in the individual power supply leads.
+V
L
DGND
2
AGND
AD1851/AD1861
–V
S
ANALOG
GROUND
DIGITAL
GROUND
3
16
+V
S
1
12
–5V
+5V
+5V
Figure 3. Alternate Recommended Schematic
As with most linear circuits, changes in the power supplies will
affect the output of the DAC. Analog Devices recommends that
well regulated power supplies with less than 1% ripple be incor-
porated into the design of any system using the AD1851/AD1861.
OPT IONAL MSB ADJUST ME NT
Use of an optional adjustment circuit allows residual differential
linearity error around midscale to be eliminated. T his error is
especially important when low amplitude signals are being re-
produced. In those cases, as the signal amplitude decreases, the
ratio of the midscale differential linearity error to the signal am-
plitude increases, thereby increasing T HD.
T herefore, for best performance at low output levels, the op-
tional MSB adjust circuitry shown in Figure 4 may be used to
improve performance. T he adjustment should be made with a
small signal input (–20 dB or –60 dB).
15
14
1
TRIM
470k
100k
200k
MSB
ADJUST
–V
S
Figure 4. Optional THD Adjust Circuit
相關PDF資料 |
PDF描述 |
|---|---|
| AD1892JR | Integrated Digital Receiver/Rate Converter |
| AD1892JRRL | Integrated Digital Receiver/Rate Converter |
| AD1892 | Integrated Digital Receiver/Rate Converter(數字音頻接收器/采樣率轉換器) |
| AD1893JN | Low Cost SamplePort 16-Bit Stereo Asynchronous Sample Rate Converter |
| AD1893JST | Low Cost SamplePort 16-Bit Stereo Asynchronous Sample Rate Converter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD1851N | 制造商:Analog Devices 功能描述:DAC 1-CH R-2R 16-bit 16-Pin PDIP Tube 制造商:Rochester Electronics LLC 功能描述:IC, MONO 16-BIT AUDIO DAC - Bulk 制造商:Analog Devices 功能描述:16BIT DAC PCM AUDIO 1851 DIP16 |
| AD1851N-J | 制造商:Analog Devices 功能描述:DAC 1-CH R-2R 16-bit 16-Pin PDIP Tube 制造商:Rochester Electronics LLC 功能描述:IC, MONO 16-BIT AUDIODAC - Bulk |
| AD1851NZ | 制造商:Rochester Electronics LLC 功能描述:IC, MONO 16-BIT AUDIO DAC - Bulk 制造商:Analog Devices 功能描述:16BIT DAC PCM AUDIO 1851 DIP16 |
| AD1851NZ | 制造商:Analog Devices 功能描述:16BIT DAC PCM AUDIO 1851 DIP16 |
| AD1851NZ-J | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。