- 您現在的位置：買賣IC網 > PDF目錄67356 > ACPM-7813-BLK 824 MHz - 849 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER PDF資料下載
參數資料
| 型號： | ACPM-7813-BLK |
| 元件分類： | 放大器 |
| 英文描述： | 824 MHz - 849 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| 封裝： | 4 X 4 MM, 1.10 MM HEIGHT, SMT, 10 PIN |
| 文件頁數： | 20/20頁 |
| 文件大?。?/td> | 214K |
| 代理商： | ACPM-7813-BLK |
9
cdma 2000 1xRTT Characterization
System Description
CDMA2000 is the TIA’s standard for third generation
(3G) technology and is an evolution of the IS-95 CDMA
format. CDMA2000 includes 1X RTT in the single-carrier
mode and 3X RTT in the multi-carrier mode. This paper
describes the CDMA2000 1X RTT approach and its
performance with Avago Technologies 4x4 CDMA PAs,
ACPM-7813. CDMA2000 1X RTT, being an extension of
the IS-95 standard, has a chip rate of 1.2288Mchip/s.
However, in 1xRTT, the reverse link transmits more than
one code channel to accommodate the high data rates.
Specification
Spread Rate1
ERP at Maximum
Lower limit +23 dBm
Output Power
Upper limit +30 dBm
Minimum Controlled Output Power
-50 dBm/1.23 MHz
Waveform Quality Factor and Frequency Accuracy
>0.944
SR1, Band Class 0(Cellular band)
SR1, Band Class1(PCS band)
885 kHz to 1.98 MHz
1.25 MHz to 1.98 MHz
Less stringent of -42 dBc/30 kHz
or -54 dBm/1.23 MHz
1.98 MHz to 3.125 MHz
1.98 MHz to 2.25 MHz
Less stringent of -54 dBc/30 kHz
Less stringent of -50 dBc/30 kHz
or -54 dBm/1.23 MHz
3.125 MHz to 5.625 MHz
2.25 MHz to 6.25 MHz
-13 dBm/100 kHz
-13 dBm/1 MHz
Spurious Emission at
Maximum RF output
power offset frequency
within the range
The minimum configuration consists of a reverse pilot
(R-Pilot) channel for synchronous detection by the Base
Transceiver System (BTS) and a reverse fundamental
channel (R-FCH) for voice. Additional channels such as
the reverse supplemental channels (R-SCHs) and the
reverse dedicated channel (R-DCCH) are used to send
data or signaling information. Channels can exist at
different rates and power levels.
Table 1 shows the transmitter specification in
CDMA2000 reverse link.
Table 1. Transmitter Specification in Reverse Link.
Typical channel configurations below are based on the transmitter test
condition in the reverse link.
1) “Basic” Voice only configuration
– R-PICH @ -5.3 dB
– R-FCH @ -1.5 dB 9.6 kbps
2) Voice and Data configuration
– R-PICH @ -5.3 dB
– R-FCH @ -4.54 dB 9.6 kbps
– R-SCH1 @ -4.54 dB 9.6 kbps
3) Voice and Control configuration
– R-PICH @ -5.3 dB
– R-FCH @ -3.85 dB 9.6 kbps
– R-DCCH @ -3.85 dB 9.6 kbps
4) Control channel only configuration
– R-PICH @ -5.3 dB
– R-DCCH @ -1.5 dB 9.6 kbps
相關PDF資料 |
PDF描述 |
|---|---|
| ACPM-7833 | 1850 MHz - 1910 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| ACPM-7881-TR1 | 1920 MHz - 1980 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| ACPM-7886-BLK | 2010 MHz - 2025 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| ACPM-7886-TR1 | 2010 MHz - 2025 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| AD22100ARZ-REEL7 | ANALOG TEMP SENSOR-VOLTAGE, 0.47-3.28V, RECTANGULAR, SURFACE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ACPM-7813-TR1 | 功能描述:射頻放大器 CDMA Amp 824-849MHz RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| ACPM-7821 | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:4 x 4 Power Amplifier Module for J-CDMA (898 - 925 MHz) |
| ACPM-7821-BLK | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:4 x 4 Power Amplifier Module for J-CDMA (898 - 925 MHz) |
| ACPM-7821-TR1 | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:4 x 4 Power Amplifier Module for J-CDMA (898 - 925 MHz) |
| ACPM-7822 | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:JCDMA 4x4 Power Amplifier Module (898-925MHz) |
發布緊急采購，3分鐘左右您將得到回復。