- 您現在的位置：買賣IC網 > PDF目錄67356 > ACPM-7813-BLK 824 MHz - 849 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER PDF資料下載
參數資料
| 型號： | ACPM-7813-BLK |
| 元件分類： | 放大器 |
| 英文描述： | 824 MHz - 849 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| 封裝： | 4 X 4 MM, 1.10 MM HEIGHT, SMT, 10 PIN |
| 文件頁數： | 10/20頁 |
| 文件大?。?/td> | 214K |
| 代理商： | ACPM-7813-BLK |
18
Input
Vdd1
Passive
Input
Match
On Chip
Inter-stage
Match
Bias Circuit
Passive
Output
Match
Vdd2
Output
Vcntl
Single control bias setting for low Idq
and 40% PAE at Pout = 28.5 dBm
Vbias
Modulation: OQPSK
Chip Rate: 1.2288 Mcps
High Crest: On
Filter: Std
Phase Polarity: Invert
- ACPR Measurement
The ACPR (and channel power) is measured using
an Avago Technologies 4406 VSA with
corresponding ACPR offsets for IS-98c and JSTD-8.
Averaging of 10 is used for ACPR measurements.
- DC Connection
A DC Connector is provided to allow ease of
connection to the I/O’s. Wires can be soldered to
the connector pins, or the connector can be
removed and I/O’s contacted via clip leads or direct
soldered connections. The wiring of I/O’s are listed
in Figure 1 through 3 and Pin configuration table.
The Vdd sense connections are provided to allow
the use of remote-sensing power supplies for
compensation of PCB traces and cable resistance.
- Device Operation
1) Connect RF Input and Output for the band
under test.
2) Terminate all unused RF ports into 50 Ohms.
3) Connect Vdd1 and Vdd2 supplies (including
remote sensing labeled Vdd1 S and Vdd2 S on
the board). Nominal voltage is 3.4V.
4) Connect Vcntl supply and set reference voltage
to the voltage shown in the data packet. Note
that the Vcntl pin is on the back side of the
demonstration board. Please limit Vcntl to not
exceed the corresponding listed “DC Biasing
Condition” in the Data Packet. Note that
increasing Vcntl over the corresponding listed
“DC Biasing Condition” can result in power
decrease and current can exceed the rated limit.
5) Apply RF input power according to the values
listed in “Operation Data” in Data Packet.
6) Power down in opposite sequence.
2) Circuit Operation
The design of the power module (PAM) provide bias
control via Vcntl to achieve optimal RF performance
and power control. The control pin is labeled Vref
(Vcntl). Please refer to Figure 26 for the block diagram
of this PAM.
Typical Operation Conditions
(Vdd1=Vdd2=Vbias = 3.0V)
Parameter
ACPM-7813
Frequency Range
824 – 849 MHz
Output Power
28.5 dBm
Vcntl
2.5 V
3) Maximum Ratings
Vdd 5.0V
Drain Current 1.5A
Vcntl 3V
RF input
10 dBm
Temperature -30 to 85°C
Please Note: Avoid Electrostatic Discharge on all I/
O’s.
4) Heat Sinking
The demonstration PC Board provides an adequate
heat sink. Maximum device dissipation should be
kept below 2.5 Watts.
5) Testing
- Signal Source
The CDMA modulated signal for the test is
generated using an Agilent Technologies ESG-
D4000A (or ESG-D3000A) Digital Signal Generator
with the following settings:
CDMA Setup : Reverse
Spreading: On
Bits/Symbol: 1
Data: PN15
Figure 26. Power Module Block Diagram.
相關PDF資料 |
PDF描述 |
|---|---|
| ACPM-7833 | 1850 MHz - 1910 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| ACPM-7881-TR1 | 1920 MHz - 1980 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| ACPM-7886-BLK | 2010 MHz - 2025 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| ACPM-7886-TR1 | 2010 MHz - 2025 MHz RF/MICROWAVE NARROW BAND MEDIUM POWER AMPLIFIER |
| AD22100ARZ-REEL7 | ANALOG TEMP SENSOR-VOLTAGE, 0.47-3.28V, RECTANGULAR, SURFACE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ACPM-7813-TR1 | 功能描述:射頻放大器 CDMA Amp 824-849MHz RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel |
| ACPM-7821 | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:4 x 4 Power Amplifier Module for J-CDMA (898 - 925 MHz) |
| ACPM-7821-BLK | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:4 x 4 Power Amplifier Module for J-CDMA (898 - 925 MHz) |
| ACPM-7821-TR1 | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:4 x 4 Power Amplifier Module for J-CDMA (898 - 925 MHz) |
| ACPM-7822 | 制造商:AVAGO 制造商全稱:AVAGO TECHNOLOGIES LIMITED 功能描述:JCDMA 4x4 Power Amplifier Module (898-925MHz) |
發布緊急采購，3分鐘左右您將得到回復。