參數資料
型號： A49FL004TX-33
廠商： AMIC Technology Corporation
英文描述： 4 Mbit CMOS 3.3Volt-only Firmware Hub/LPC Flash Memory
中文描述： 4兆位的CMOS 3.3Volt只固件集線器/ LPC快閃記憶體
文件頁數： 6/36頁
文件大?。?/td> 713K
代理商： A49FL004TX-33
A49FL004
PRELIMINARY (September, 2005, Version 0.0)
5
AMIC Technology, Corp.
Table 1: Pin Description
Notes: IN=Input, I/O=Input/Output.
Interface
FWH
Descriptions
Symbol
Type
A/A
LPC
A[10:0]
IN
X
Addresses Inputs: For inputting the multiplex address in A/A Mux mode. Row
and column address are latched during a read or write cycle controlled by
pin.
C
R/
I/O[7:0]
I/O
X
Data Inputs/Outputs: Used for A/A Mux mode only, to input command/data
during write operation and to output data during Read operation. The data pins
float to tri-state when OE is high.
OE
IN
X
Output Enable: Control the device’s output buffers during a read cycle.
OE is a active low.
WE
IN
X
Write Enable: Active the device for write operation.
WE
is active low.
IC
IN
X
X
X
Interface Configuration Select: This pin determines which mode is selected.
When pulls high, the device enters into A/A Mux mode. When pulls low,
FWH/LPC mode is selected. This pin must be setup during power-up or system
reset, and stays no change during operation. This pin is internally pulled down
with a resistor between 20-100 K
.
INIT
IN
X
X
Initialize: This is the second reset pin for in-system use.
INIT
andRST pin are
internally combined and initialize a device reset when driven low.
ID[3:0]
IN
X
These four pins are part of the mechanism that allows multiple FWH devices to
be attached to the same bus. The strapping of these pins is used to identify the
component. The boot device must have ID[3:0]=0000b and it is recommended
that all subsequent devices should use sequential up-count strapping. These
pins are internally pulled-down with a resistor between 20-100 K
.
GPI[4:0]
IN
X
X
FWH/LPC General Purpose Inputs: Used to set the GPI_REG for system design
purpose only. The value of GPI_REG can be read through FWH interface. The
state of these pins can be read immediately at boot, through FWH/LPC internal
registers. These pins should be set at desired state before the start of the PCI
clock cycle for read operation and should remain on change until the end of the
Read cycle. Unused GPI pins must not be floated.
TBL
IN
X
X
Top Block Lock: When pulls low, it enables the hardware write protection the
state for top boot block. When pulls high, it disables the hardware write
protection.
FWH[3:0]
I/O
X
FWH Address and Data: The major I/O pins for transmitting data, address and
command code in FWH mode.
CLK
IN
X
X
FWH/LPC Clock: To provide a synchronous clock for FWH and LPC mode
operations.
FWH4
IN
X
FWH Input: To indicate the start of a FWH memory cycle operation. Also used to
abort a FWH memory cycle in progress.
RST
IN
X
X
X
Reset: To reset the operation of the device and return to standby mode.
WP
IN
X
X
Write Protect: When pulls low, it enables the hardware write protection to the
memory array except the top boot block. When pulls high, it disables hardware
write protection except the top boot block.
C
R/
IN
Row/Column Select: To indicate to the row or column address in A/A Mux mode.
When this pin goes low, the row address is latched. When this pin goes high, the
column address is latched.
LAD[3:0]
I/O
X
LPC Address and Data: The major i/o pins for transmitting data, addresses and
command code in LPC mode.
LFRAME
IN
X
LPC Frame: To indicate the start of a LPC memory cycle operation. Also used to
abort a LPC memory cycle in progress.
RES
X
X
Reserved. Reserved function pins for future use.
VDD
X
X
X
Device power supply.
VSS
X
X
X
Ground.
NC
X
X
X
No Connection.
相關PDF資料
PDF描述
A49LF004TX-33C 4 Mbit CMOS 3.3Volt-only Firmware Hub Flash Memory
A49LF004TL-33C 4 Mbit CMOS 3.3Volt-only Firmware Hub Flash Memory
A49LF004 4 Mbit CMOS 3.3Volt-only Firmware Hub Flash Memory
A49LF040A 4 Mbit CMOS 3.3Volt-only Low Pin Count Flash Memory
A49LF040ATL-33 4 Mbit CMOS 3.3Volt-only Low Pin Count Flash Memory
相關代理商/技術參數
參數描述
A49FL004TX-33F 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4 Mbit CMOS 3.3Volt-only Firmware Hub/LPC Flash Memory
A49LF004 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4 Mbit CMOS 3.3Volt-only Firmware Hub Flash Memory
A49LF004TL-33C 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4 Mbit CMOS 3.3Volt-only Firmware Hub Flash Memory
A49LF004TX-33C 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4 Mbit CMOS 3.3Volt-only Firmware Hub Flash Memory
A49LF040 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4 Mbit CMOS 3.3Volt-only Low Pin Count Flash Memory
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*