- 您現在的位置：買賣IC網 > PDF目錄25548 > 97SD3248RPMI (MAXWELL TECHNOLOGIES) 32M X 48 SYNCHRONOUS DRAM, 6 ns, QFP132 PDF資料下載
參數資料
| 型號： | 97SD3248RPMI |
| 廠商： | MAXWELL TECHNOLOGIES |
| 元件分類： | DRAM |
| 英文描述： | 32M X 48 SYNCHRONOUS DRAM, 6 ns, QFP132 |
| 封裝： | STACK, QFP-132 |
| 文件頁數： | 9/40頁 |
| 文件大小： | 758K |
| 代理商： | 97SD3248RPMI |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
97SD3248
M
em
o
ry
17
All data sheets are subject to change without notice
2004 Maxwell Technologies
All rights reserved.
1.5Gb (8-Meg X 48-Bit X 4-Banks) SDRAM
03.25.04 Rev 1
Mode Register Configuration
The mode register is set by the input to the address pins (A0 to A12, BA0 and BA1) during mode register set
cycles. The mode register consists of five sections, each of which is assigned to address pins.
BA0, BA1, A11, A10, A12, A9, A8: (OPCODE): The SDRAM has two types of write modes. One is the burst
write mode, and the other is the single write mode. These bits specify write mode.
Burst read and burst write: Burst write is performed for the specified burst length starting from the column
address specified in the write cycle.
Burst read and single write: Data is only written to the column address specified during the write cycle,
regardless of the burst length.
A7: Keep this bit Low at the mode register set cycle. If this pin is high, the vender test mode is set.
A6, A5, A4: (LMODE): These pins specify the CAS latency.
A3: (BT): A burst type is specified.
A2, A1, A0: (BL): These pins specify the burst length.
相關PDF資料 |
PDF描述 |
|---|---|
| 97SD3248RPMK | 32M X 48 SYNCHRONOUS DRAM, 6 ns, QFP132 |
| 97U870AKIT | 97U SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), QCC40 |
| 97U870AH | 97U SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PBGA52 |
| 97U870AHIT | 97U SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), PBGA52 |
| 97U870AKT | 97U SERIES, PLL BASED CLOCK DRIVER, 10 TRUE OUTPUT(S), 0 INVERTED OUTPUT(S), QCC40 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 97SD3248RPQE | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:1.5Gb SDRAM 8-Meg X 48-Bit X 4-Banks |
| 97SD3248RPQH | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:1.5Gb SDRAM 8-Meg X 48-Bit X 4-Banks |
| 97SD3248RPQI | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:1.5Gb SDRAM 8-Meg X 48-Bit X 4-Banks |
| 97SD3248RPQK | 制造商:MAXWELL 制造商全稱:Maxwell Technologies 功能描述:1.5Gb SDRAM 8-Meg X 48-Bit X 4-Banks |
| 97SG-1 | 制造商:EECO Switch 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。