參數資料
型號： 935263122557
廠商： NXP SEMICONDUCTORS
元件分類： 微控制器/微處理器
英文描述： 8-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP80
封裝： PLASTIC, QFP-80
文件頁數： 40/76頁
文件大?。?/td> 567K
代理商： 935263122557
Philips Semiconductors
Product specification
P83C557E4/P80C557E4/P89C557E4
Single-chip 8-bit microcontroller
1999 Mar 02
45
6.13.4
Seconds Timer
This counter provides an overflow signal every second, when the
32kHz oscillator is running.
The overflow output sets the interrupt flag SECINT. This interrupt
can be disabled/enabled by ENSECI. If SECINT is enabled, it is
logically ORed with INT1 (external interrupt 1).
Seconds interrupt and INT1 therefor share the same priority and
vector. The software has to check both flags SECINT (PLLCON.5)
and IE1 (TCON.3), to distinguish between the two interrupt sources.
SECINT can only be cleared via writing a ‘0’ to this bit .
The external interrupts INT0 , INT1 or the seconds interrupt can
Wake-up the PLL oscillator and the microcontroller as described in
chapter “Wake-up from Power-down Mode”.
For a Wake-up via INT1 or seconds interrupt, IE1 must be enabled
and level-sensitive.
A further function of the seconds timer is to control the start-up
timing of the microcontroller after Reset or after Wake-up from
Power-down. It controls the stretching of the reset pulse to the
microcontroller and controls releasing the system clock to the
microcontroller.
A RSTIN signal of 1us at minimum will reset the microcontroller.
In case of Reset or Wake-up with halted 32kHz oscillator: From
RSTIN falling edge or Wake-up interrupt it takes 560ms at maximum
for the start-up of the 32kHz oscillator itself and the stabilization of
the PLL’s.
In case of Wake-up with running 32kHz oscillator: From Wake-up
interrupt it takes about 1ms for the stabilization of the PLL’s.
After this start-up time, the microcontroller is supplied with the
system clock and – in case of a reset – the internally stretched reset
signal overlaps about 45us, to guarantee a proper initialization of the
microcontroller.
For further information refer to section
6.11 Power reduction modes.
XTAL3
Figure 45. Block diagram PLL
Oscil-
lator
32.768 KHz
C1
32 kHz
Phase
comparator
Loop
filter
CCO
PD
Internal Bus
SECONDS TIMER
PLLCON
RSTIN
Programmable
divider
system clock
Reset to controller
’Seconds’
Interrupt
request
PD = power down
Stretched
Reset
RUN32 PD
Rf
C2
XTAL4
相關PDF資料
PDF描述
935263156557 8-BIT, FLASH, 16 MHz, MICROCONTROLLER, PQFP80
935263261557 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP80
935263206557 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP80
935268065557 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP80
935263263557 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP80
相關代理商/技術參數
參數描述
935264217557 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935267356112 制造商:NXP Semiconductors 功能描述:IC TEA1507PN
935268081112 制造商:NXP Semiconductors 功能描述:SUB ONLY IC
935268721125 制造商:NXP Semiconductors 功能描述:Buffer/Line Driver 1-CH Non-Inverting 3-ST CMOS 5-Pin TSSOP T/R
935269304128 制造商:ST-Ericsson 功能描述:IC AUDIO CODEC W/TCH SCRN 48LQFP
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*