- 您現在的位置：買賣IC網 > PDF目錄67335 > 5962-9214103MPX (MAXIM INTEGRATED PRODUCTS INC) 0.45 A SWITCHING REGULATOR, 65 kHz SWITCHING FREQ-MAX, CDIP8 PDF資料下載
參數資料
| 型號： | 5962-9214103MPX |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.45 A SWITCHING REGULATOR, 65 kHz SWITCHING FREQ-MAX, CDIP8 |
| 封裝： | CERAMIC, DIP-8 |
| 文件頁數： | 3/17頁 |
| 文件大?。?/td> | 894K |
| 代理商： | 5962-9214103MPX |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁
NC_) and COM_ so that signals pass equally well in
either direction.
Positive Fault Condition
When the signal on NO_ (or NC_) exceeds V+ by about
150mV, the high-fault comparator output is high, turn-
ing off FETs N1 and P1. This makes the NO_ (or NC_)
input high impedance regardless of the switch state. If
the switch state is “off”, all FETs are turned off and both
NO_ (or NC_) and COM_ are high impedance. If the
switch state is “on”, clamp FET P2 is turned on, sourc-
ing current from V+ to COM_.
Negative Fault Condition
When the signal on NO_ (or NC_) exceeds V- by about
150mV, the low-fault comparator output is high, turning
off FETs N1 and P1. This makes the NO_ (or NC_) input
high impedance regardless of the switch state. If the
switch state is “off”, all FETs are turned off and both
NO_ (or NC_) and COM_ are high impedance. If the
switch state is “on”, clamp FET N2 is turned on, sinking
current from COM_ to V-.
Transient Fault Response and Recovery
When a fast rise-time or fall-time transient on NC_ or
NO_ exceeds V+ or V-, the output (COM_) follows the
input to the supply rail with only a few nanoseconds
delay. This delay is due to the switch on-resistance and
circuit capacitance to ground. When the input transient
returns to within the supply rails, however, there is a
700ns output recovery delay time. These values
depend on the COM_ output resistance and capaci-
tance, and are not production tested or guaranteed.
The delays are not dependent on the fault amplitude.
Higher COM_ output resistance and capacitance
increase recovery times.
COM_ and IN_ Pins
FETs N2 and P2 can source about ±15mA from V+ or
V- to COM_ in the fault condition. Ensure that if the
COM_ pin is connected to a low-resistance load, the
absolute maximum current rating of 40mA is never
exceeded both in normal and fault conditions.
MAX4711/MAX4712/MAX4713
Fault-Protected, Low-Voltage,
Quad SPST Analog Switches
______________________________________________________________________________________
11
V+
NO_
(NC_)
IN_
GND
V-
HIGH
FAULT
LOW
FAULT
ON
N1
P1
P2
COM_
N2
NC SWITCH
-ESD DIODE
NORMALLY OPEN SWITCH CONSTRUCTION
Figure 1. Block Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| 5962-9216501MPA | 1 CHANNEL, VIDEO AMPLIFIER, CDIP8 |
| 5962-9216501MXA | 1 CHANNEL, VIDEO AMPLIFIER, CDSO10 |
| 5962-9216701MXX | 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, BFM4 |
| 5962-9216701MXA | 3 A SWITCHING REGULATOR, 52 kHz SWITCHING FREQ-MAX, MBFM2 |
| 5962-9216801MXA | 3 A SWITCHING REGULATOR, 52 kHz SWITCHING FREQ-MAX, MBFM2 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 5962-9214104MPA | 功能描述:直流/直流開關調節器 NULL RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| 59629214701M2A | 制造商:TI 功能描述:SNJ54ABT244FK |
| 5962-9214701M2A | 制造商:Texas Instruments 功能描述:Buffer/Line Driver 8-CH Non-Inverting 3-ST BiCMOS 20-Pin LCCC Tube 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:BFFR/LINE DRVR 8CH NON-INV 3-ST BICMOS 20LCCC - Rail/Tube |
| 5962-9214701MRA | 制造商:Texas Instruments 功能描述:Buffer/Line Driver 8-CH Non-Inverting 3-ST BiCMOS 20-Pin CDIP Tube 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Texas Instruments 功能描述:BFFR/LINE DRVR 8CH NON-INV 3-ST BICMOS 20CDIP - Rail/Tube |
| 59629214701MSA | 制造商:TI 功能描述:SNJ54ABT244W |
發布緊急采購，3分鐘左右您將得到回復。