- 您現在的位置：買賣IC網 > PDF目錄371605 > 522932B Dual/Triple Ultra-Low-Voltage SOT23 µP Supervisory Circuits PDF資料下載
參數資料
| 型號： | 522932B |
| 英文描述： | Dual/Triple Ultra-Low-Voltage SOT23 µP Supervisory Circuits |
| 中文描述： | 集成電路 |
| 文件頁數： | 6/16頁 |
| 文件大?。?/td> | 141K |
| 代理商： | 522932B |
6
LTC 690/LTC 691
LTC 694/LTC 695
PI FU CTIO S
PFO:
Power Failure Output from C3. PFO remains high
when PFI is above 1.3V and goes low when PFI is below
1.3V. When V
CC
is lower than V
BATT
, C3 is shut down and
PFO is forced low.
RESET:
Logic Output for
μ
P Reset Control. Whenever V
CC
falls below either the reset voltage threshold (4.65V,
typically) or V
BATT
, RESET goes active low. After V
CC
returns to 5V, reset pulse generator forces RESET to
remain active low for a minimum of 35ms for the LTC690
/LTC691 (140ms for the LTC694/LTC695). When the
watchdog timer is enabled but not serviced prior to a
preset time-out period, reset pulse generator also forces
RESET to active low for a minimum of 35ms for the
LTC690/LTC691 (140ms for the LTC694/5) for every
preset time-out period (see Figure 11). The reset active
time is adjustable on the LTC691/LTC695. An external
push-button reset can be used in connection with the
RESET output. See Push-Button Reset in Applications
Information section.
RESET:
RESET is an active high logic ouput. It is the
inverse of RESET.
LOW LINE:
Logic Output from Comparator C1. LOW LINE
indicates a low line condition at the V
CC
input. When V
CC
falls below the reset voltage threshold (4.65V typically),
LOW LINE goes low. As soon as V
CC
rises above the reset
voltage threshold, LOW LINE returns high (see Figure 1).
LOW LINE goes low when V
CC
drops below V
BATT
(see
Table 1).
WDI:
Watchdog Input, WDI, is a three level input. Driving
WDI either high or low for longer than the watchdog time-
out period, forces both RESET and WDO low. Floating WDI
disables the watchdog timer. The timer resets itself with
each transition of the watchdog input (see Figure 11).
WDO:
Watchdog Logic Output. When the watchdog input
remains either high or low for longer than the watchdog
time-out period, WDO goes low. WDO is set high whenever
there is a transition on the WDI pin, or LOW LINE goes low.
The watchdog timer can be disabled by floating WDI (see
Figure 11).
CE IN:
Logic input to the Chip Enable gating circuit. CE IN
can be derived from microprocessor’s address line and/or
decoder output. See Applications Information section and
Figure 5 for additional information.
CE OUT:
Logic Output on the Chip Enable Gating Circuit.
When V
CC
is above the reset voltage threshold, CE OUT is
a buffered replica of CE IN. When V
CC
is below the reset
voltage threshold CE OUT is forced high (see Figure 5).
OSC SEL:
Oscillator Selection Input. When OSC SEL is
high or floating, the internal oscillator sets the reset active
time and watchdog time-out period. Forcing OSC SEL low,
allows OSC IN be driven from an external clock signal or
external capacitor be connected between OSC IN and
GND.
OSC IN:
Oscillator Input. OSC IN can be driven by an
external clock signal or external capacitor can be connected
between OSC IN and GND when OSC SEL is forced low. In
this configuration the nominal reset active time and
watchdog time-out period are determined by the number
of clocks or set by the formula (see Applications Information
section). When OSC SEL is high or floating, the internal
oscillator is enabled and the reset active time is fixed at
50ms typical for the LTC691 and 200ms typical for the
LTC695. OSC IN selects between the 1.6 seconds and
100ms typical watchdog time-out periods. In both cases,
the time-out period immediately after a reset is 1.6 seconds
typical.
相關PDF資料 |
PDF描述 |
|---|---|
| 522933X | IC |
| 522935G | Dual/Triple Ultra-Low-Voltage SOT23 µP Supervisory Circuits |
| 522936E | IC |
| 522938A | Dual/Triple Ultra-Low-Voltage SOT23 µP Supervisory Circuits |
| 522939X | IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 522-93-323-21-005001 | 功能描述:SKT PGA WRAPOST 制造商:mill-max manufacturing corp. 系列:* 零件狀態:在售 標準包裝:50 |
| 522-93-323-21-005002 | 功能描述:SKT PGA WRAPOST 制造商:mill-max manufacturing corp. 系列:* 零件狀態:在售 標準包裝:50 |
| 522-93-323-21-005003 | 功能描述:SKT PGA WRAPOST 制造商:mill-max manufacturing corp. 系列:* 零件狀態:在售 標準包裝:50 |
| 522-93-324-18-000001 | 功能描述:SKT PGA WRAPOST 制造商:mill-max manufacturing corp. 系列:* 零件狀態:在售 標準包裝:50 |
| 522-93-324-18-000002 | 功能描述:SKT PGA WRAPOST 制造商:mill-max manufacturing corp. 系列:* 零件狀態:在售 標準包裝:50 |
發布緊急采購，3分鐘左右您將得到回復。