參數資料
型號: 20-101-0788
廠商: Rabbit Semiconductor
文件頁數: 20/90頁
文件大?。?/td> 0K
描述: COMPUTER SGL-BOARD OP6600 W/SRAM
標準包裝: 1
系列: SBC
模塊/板類型: 單板計算機模塊
適用于相關產品: OP6600
User’s Manual
23
3.2.1 RS-232
The Intellicom’s RS-232 serial channel is connected to an RS-232 transceiver, U11. U11
provides the voltage output, slew rate, and input voltage immunity required to meet the
RS-232 serial communication protocol. Basically, the chip translates the Rabbit 2000’s 0
V to +Vcc signals to RS-232 signal levels. Note that the polarity is reversed in an RS-232
circuit so that +5 V is output as approximately -10 V and 0 V is output as approximately
+10 V. U11 also provides the proper line loading for reliable communication.
The maximum baud rate is 115,200 bps. RS-232 can be used effectively at this baud rate
for distances up to 15 m.
3.2.2 RS-485
The Intellicom has one RS-485 serial channel, which is connected to the Rabbit 2000
serial port B through U10, an RS-485 transceiver. The chip’s slew rate limiters provide for
a maximum baud rate of 250,000 bps, which allows for a network of up to 1200 m (or
4000 ft). The half-duplex communication uses the Rabbit 2000’s PC0 pin to control the
data enable on the communication line.
The RS-485 signals are available on pins 3 and 4 of header J7, and on J5, the RJ-12 jack.
The Intellicom can be used in an RS-485 multidrop network. Connect the 485+ to 485+
and 485– to 485– using single twisted-pair wires (nonstranded, tinned) as shown in
Alternatively, the RS-485 multidrop network may be hooked up using cables with RJ-12
plugs. Note that the RJ-12 jack has +RAW_485 and GND, which means that only one
Intellicom needs to be connected to an external power source via an AC adapter. When
doing so, ensure that the AC adapter has sufficient capacity for the network — each Intel-
licom unit nominally draws 100 mA at 24 VDC.
CAUTION: If you plan to connect a power supply to more than one
Intellicom unit
in an RS-485 network using the RJ-12 jacks, rework the RS-485 cables so they do not
connect +RAW_RS485 through the RJ-12 jack to the boards in the network.
NOTE: The RS-485 port is available only in the factory default configuration. The RS-485
port will not be available when you select the configuration option for both 3-wire
RS-232 ports or one 5-wire RS-232 port.
相關PDF資料
PDF描述
20-101-1068 MODULE RABBITCORE RCM3315
20-101-1131 MODULE RCM4200 RABBITCORE
20-101-1139 RCM4310 RABBITCORE
20-101-1154 MODULE RCM4120 RABBITCORE
20-101-1197 MODULE RABBITCORE RCM3910 ROHS
相關代理商/技術參數
參數描述
201-0108-01 功能描述:印刷電路板和試驗板 RJ11/45 and USB Connector RoHS:否 制造商:3M Electronic Solutions Division 產品:Jumper & Insulated Wires 描述/功能:Jumper wire, 22 AWG 0.1 inch 長度:0.1 in 寬度:
20-101-0818 功能描述:單板計算機 BL2100 Fric Lk 512K RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm
20-101-0820 功能描述:COMPUTER SGL-BD BL2000 SRAM/FLSH RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器或微處理器模塊 系列:SBC 產品目錄繪圖:DLP-245SY-G 標準包裝:1 系列:USB 模塊/板類型:開發板 適用于相關產品:USB 其它名稱:813-1006
20-101-0841 功能描述:模塊化系統 - SOM BL2000 FRICT LOCK W/ RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in
20-101-0847 功能描述:模塊化系統 - SOM BL2121 LOCK RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in