- 您現在的位置：買賣IC網 > PDF目錄1887 > 101-0435 (Rabbit Semiconductor)MODULE RABBITCORE RCM2110 PDF資料下載
參數資料
| 型號： | 101-0435 |
| 廠商： | Rabbit Semiconductor |
| 文件頁數： | 48/100頁 |
| 文件大?。?/td> | 0K |
| 描述： | MODULE RABBITCORE RCM2110 |
| 標準包裝： | 1 |
| 系列： | RabbitCore® |
| 模塊/板類型： | 單板計算機模塊 |
| 適用于相關產品： | RCM2110 |
| 其它名稱： | Q1220189 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁當前第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁
User’s Manual
45
6.2 TCP/IP Primer on IP Addresses
Obtaining IP addresses to interact over an existing, operating, network can involve a num-
ber of complications, and must usually be done with cooperation from your ISP and/or
network systems administrator. For this reason, it is suggested that the user begin instead
by using a direct connection between a PC and the RCM2100 board using an Ethernet
crossover cable or a simple arrangement with a hub. (A crossover cable should not be con-
fused with regular straight through cables.)
In order to set up this direct connection, the user will have to use a PC without networking,
or disconnect a PC from the corporate network, or install a second Ethernet adapter and set
up a separate private network attached to the second Ethernet adapter. Disconnecting your
PC from the corporate network may be easy or nearly impossible, depending on how it is
set up. If your PC boots from the network or is dependent on the network for some or all
of its disks, then it probably should not be disconnected. If a second Ethernet adapter is
used, be aware that Windows TCP/IP will send messages to one adapter or the other,
depending on the IP address and the binding order in Microsoft products. Thus you should
have different ranges of IP addresses on your private network from those used on the cor-
porate network. If both networks service the same IP address, then Windows may send a
packet intended for your private network to the corporate network. A similar situation will
take place if you use a dial-up line to send a packet to the Internet. Windows may try to
send it via the local Ethernet network if it is also valid for that network.
The following IP addresses are set aside for local networks and are not allowed on the
Internet: 10.0.0.0 to 10.255.255.255, 172.16.0.0 to 172.31.255.255, and 192.168.0.0 to
192.168.255.255.
The RCM2100 board uses a 10Base-T type of Ethernet connection, which is the most
common scheme. The RJ-45 connectors are similar to U.S. style telephone connectors,
except they are larger and have 8 contacts.
An alternative to the direct connection using a crossover cable is a direct connection using
a hub. The hub relays packets received on any port to all of the ports on the hub. Hubs are
low in cost and are readily available. The RCM2100 board uses 10 Mbps Ethernet, so the
hub or Ethernet adapter must be either a 10 Mbps unit or a 10/100 unit that adapts to either
10 or 100 Mbps.
In a corporate setting where the Internet is brought in via a high-speed line, there are typi-
cally machines between the outside Internet and the internal network. These machines
include a combination of proxy servers and firewalls that filter and multiplex Internet traf-
fic. In the configuration below, the RCM2100 board could be given a fixed address so any
of the computers on the local network would be able to contact it. It may be possible to
configure the firewall or proxy server to allow hosts on the Internet to directly contact the
controller, but it would probably be easier to place the controller directly on the external
network outside of the firewall. This avoids some of the configuration complications by
sacrificing some security.
相關PDF資料 |
PDF描述 |
|---|---|
| 101-0453 | MODULE RABBITCORE RCM2300 |
| 101-0494 | MODULE RABBITCORE RCM2250 |
| 101-0518 | MODULE RABBITCORE RCM3110 |
| 101-0521 | MODULE RABBITCORE RCM3210 |
| 101-0525 | COMPUTER SINGLE-BOARD LP3500 FOX |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 101-0435-000 | 制造商:ITT Interconnect Solutions 功能描述:INSUL CA-KE18-4S RR / 101-0435-000 / Circular |
| 101-0436 | 功能描述:模塊化系統 - SOM RCM2120 RABBITCORE RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in |
| 101-0437 | 功能描述:單板計算機 SR9205 16 in/8 out RoHS:否 制造商:Ampro By ADLINK 外觀尺寸:EPIC 處理器類型:Intel Atom D510 頻率:1.66 GHz 存儲容量:2 GB (max) 存儲類型:DDR2, L2 Cache 接口類型:Ethernet, PS/2, SATA, Serial, USB 工作電源電壓:5 V, 12 V 功耗:13 W 最大工作溫度:+ 70 C 尺寸:165.1 mm x 114.3 mm |
| 10104389-12103LF | 功能描述:DDR3 240P SMT ASSY 制造商:amphenol fci 系列:* 零件狀態:在售 標準包裝:28 |
| 10104389-13206LF | 功能描述:240 Position DIMM DDR3 SDRAM Socket Surface Mount 制造商:amphenol fci 系列:10104389 包裝:帶卷（TR） 零件狀態:有效 連接器樣式:DIMM 針腳數:240 存儲器類型:DDR3 SDRAM 標準:MO-269 安裝類型:表面貼裝 特性:板鎖，鎖存器 安裝特性:正常，標準 - 頂部 觸頭鍍層:金 觸頭鍍層厚度:15μin（0.38μm） 標準包裝:1,680 |
發布緊急采購，3分鐘左右您將得到回復。