- 您現在的位置：買賣IC網 > PDF目錄373842 > ZXF36L01W24TC (ZETEX PLC) VARIABLE Q FILTER PDF資料下載
參數資料
| 型號： | ZXF36L01W24TC |
| 廠商： | ZETEX PLC |
| 元件分類： | 運動控制電子 |
| 英文描述： | VARIABLE Q FILTER |
| 中文描述： | SWITCHED CAPACITOR FILTER, BANDPASS, PDSO24 |
| 封裝： | SO-24 |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 832K |
| 代理商： | ZXF36L01W24TC |
ZXF36L01
ISSUE 3 - JANUARY 2002
8
DESIGNING FOR A VALUE OF Q
As menti
oned on the configuration pages, there is a
proportional, but non-linear relationship between the
ratio of Rf and Ri, and Q.
These resistors define the gain of an inverting amplifier
that determines the peak value gain and therefore the Q
of the filter,Q is defined as:
Q
f
dB Bandwidth
O
=
3
This value of required gain is critical. As the maximum
value of Q is approached, too much gain will cause the
filter to oscillate at the centre frequency, fo. A small
reduction of gain will cause the value of Q to fall
significantly. Therefore, for high values of Q or tight
tolerances of lower values of Q, the resistor ratio must
be trimmed as shown.
Frequency dependant effects must be accounted for in
determining the appropriate gain. As the frequency
increases because of internal phase shift effects the
effectivecircuitgainreducesandthus QFactorreduces.
The frequency effect is not a problem for circuits where
the fo remains constant, as the phase shifts are
accounted for permanently. For designs where Q is high
and fo is to be ‘swept’, care must be taken that a gain
appropriate at the highest frequency does not cause
oscillation at the lowest.
Suggestion for gain setting component values.
several example conditions:
Example1
fo = 48kHz,
R = 10k
, C = 320pF
Rf/Ri = 36.6k
/ 18 k
=> 2.033
Q=60,
Example2
fo = 140kHz,
R = 10k
, C = 100pF
Rf/Ri = 37k
/ 18k
=> 2.055
Q=15,
It can be seen from these examples that the higher Q
exampleactuallyhasalowerinvertingamplifiergain.
As mentioned before, the frequency will affect the
value of gain. The Q Factor v Frequency graph
illustrates this effect.
These examples show that the gain required is
nominally 2. For the specified range of Q: 0.5 to 50
(valuesupto250areobtainable),thegainvaluesvary
from 1.9 to 2.5 correspondingly.
Due to internal gain errors, when the absolute value
of Q is increased, the device to device variation in Q
will also increase.
Pin 11
Pin 9
22k
2k
10k
Pin 10
This diagram shows the exponential relationship between gain and Q Factor. (fo = 140 kHz)
相關PDF資料 |
PDF描述 |
|---|---|
| ZXFBF04 | 4 Channel Buffer Device |
| ZXFBF04N14 | 4 Channel Buffer Device |
| ZXFBF04N14TA | 4 Channel Buffer Device |
| ZXFBF04N14TC | 4 Channel Buffer Device |
| ZXFBF05 | 71-254420-41S |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ZXF36L01W24TR | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:IC-SM-VARIABLE Q FILTER |
| ZXFBF04 | 制造商:ZETEX 制造商全稱:ZETEX 功能描述:4 Channel Buffer Device |
| ZXFBF04N14 | 制造商:ZETEX 制造商全稱:ZETEX 功能描述:4 Channel Buffer Device |
| ZXFBF04N14TA | 功能描述:運算放大器 - 運放 4 Chnl High Spd Bfr RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| ZXFBF04N14TC | 功能描述:IC BUFFER QUAD 100MHZ 14-SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:2pA 電壓 - 輸入偏移:1000µV 電流 - 電源:85µA 電流 - 輸出 / 通道:20mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 6 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOICN 包裝:剪切帶 (CT) 產品目錄頁面:680 (CN2011-ZH PDF) 其它名稱:MCP6L04T-E/SLCT |
發布緊急采購，3分鐘左右您將得到回復。