
YDA135CATALOG
CATALOG No.:LSI-4DA135A50
2007.3
YDA135
D-20
STEREO 5W-20W DIGITAL AUDIO POWER AMPLIFIER CONTROLLER
■
Outline
YDA135 is digital audio power amplifier controller IC that is output power of 20W/channel on a 12V power
supply operation.
This IC is combined with the general purpose Power MOSFET (hereafter called Power MOSFET) that are
connected through BTL can configure an audio power amplifier with output power of 5W or 20W.
This IC accepts analog signal, converts it into digital pulse signal by the digital modulation circuitry and outputs
the digital pulse signal for driving Power MOSFET. The Power MOSFET that is driven by this IC outputs large
current digital pulses. The digital pulse signal is converted to audio signal through an external low pass filter,
and sent to the speakers.
By using a general purpose Power MOSFET, very low cost digital amplifier system is configured. By adapting
Yamaha's proprietary modulation system, the device provides low distortion and high signal to noise ratio at
the highest level among digital amplifiers in the equivalent class.
This IC has the overcurrent detection function that detects overcurrent state by voltage drop of external
resistors that detects the output current.
This IC has the high temperature detection function that detects high temperature by resistor value change of
external element that detects temperature.
The operation of this IC is limited by using two control signals, SLEEP or MUTE. SLEEP signal stops all
functions of this IC, and restrain to the power consumption at the minimum. MUTE signal brings Power
MOSFET into nonconductive state, and mute the output of the device.
This IC is configured by two power supply ; 5V for signal processing circuits, and 12V for Power MOSFET
driving circuits.
■
Features
·High output power
·CS(Channel separation)
20W @ VDDP=12.0V, RL=4Ω, THD+N<10%
80 dB @ 1kHz
·High efficiency operation
·Any gain setting by external resistors
80 % @ VDDP=12.0V, RL=4Ω, Po=20W
·Sleep function by SLEEP terminal
85 % @ VDDP=12.0V, RL=8Ω, Po=10W
·Output mute function by MUTE terminal
·Low distortion(THD+N)
0.03 % @ 1kHz, RL=4Ω, Po=7W
·High signal to noise ratio
·Over current detection function
(Power supply short-circuiting, Ground
short-circuiting, Load short-circuiting)
100 dB @ VDDP=12.0V, Input sensitivity1.0V, RL=4Ω
97 dB @ VDDP=12.0V, Input sensitivity150mV, RL=4Ω
·High temperature detection function
·Pop noise suppression function at turn-on and
·Low consumption current (12V/5V power supply)
When Power MOSFET (FW332) is connected.
turn-off
·Lead-free 48-pin LQFP (YDA135-VZ)
30mA /7mA @ VDDP=12.0V no signal
0.1mA /7mA @ VDDP=12.0V at mute
1μA/1μA @ VDDP=12.0V at sleep