- 您現在的位置：買賣IC網 > PDF目錄9990 > XRT75L04DIV (Exar Corporation)IC LIU E3/DS3/STS-1 4CH 176TQFP PDF資料下載
參數資料
| 型號： | XRT75L04DIV |
| 廠商： | Exar Corporation |
| 文件頁數： | 9/98頁 |
| 文件大小： | 0K |
| 描述： | IC LIU E3/DS3/STS-1 4CH 176TQFP |
| 標準包裝： | 72 |
| 類型： | 線路接口裝置（LIU） |
| 驅動器/接收器數： | 4/4 |
| 規程： | DS3，E3，STS-1 |
| 電源電壓： | 3.135 V ~ 3.465 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 176-LQFP |
| 供應商設備封裝： | 176-TQFP（24x24） |
| 包裝： | 托盤 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁
á
XRT75L04D
REV. 1.0.1
FOUR CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH SONET DESYNCHRONIZER
13
92
101
129
120
E3_0
E3_1
E3_2
E3_3
I
E3 Mode Select Input
A "High" on this pin configures Channel_n to operate in E3 mode.
A "Low" on this pin configures Channel_n to operate in either STS-1 or DS3
mode depending on the settings on pins 93,102,128 and 119 pins.
NOTES:
1.
This pin is internally pulled down
2.
This pin is ignored and should be tied to GND if configured to operate
in HOST mode.
93
102
128
119
STS-1/DS3_0
STS-1/DS3_1
STS-1/DS3_2
STS-1/DS3_3
I
STS-1/DS3 Select Input
A “High” on these pins configures the Channel_n to operate in STS-1 mode.
A “Low” on these pins configures the Channel_n to operate in DS3 mode.
These pins are ignored if the E3_n pins are set to “High”.
NOTES:
1.
This pin is internally pulled down
2.
This pin is ignored and should be tied to GND if configured to operate
in HOST mode.
136
SR/DR
I
Single-Rail/Dual-Rail Select:
Setting this “High” configures both the Transmitter and Receiver to operate in
Single-rail mode and also enables the B3ZS/HDB3 Encoder and Decoder. In
Single-rail mode, TNEG_n pin should be grounded.
Setting this “Low” configures both the Transmitter and Receiver to operate in
Dual-rail mode and disables the B3ZS/HDB3 Encoder and Decoder.
NOTE: This pin is internally pulled down.
SERIAL MICROPROCESSOR INTERFACE
86
CS
RxCLKINV
I
Microprocessor Serial Interface - Chip Select
Toggle this pin “Low” to enable the communication with the Microprocessor
Serial Interface.( see figures 10 & 11)
NOTE: If configured in Hardware Mode, this pin functions as RxClkINV.
88
SClk
TxCLKINV
I
Serial Interface Clock Input
The data on the SDI pin is sampled on the rising edge of this signal. Addition-
ally, during Read operations the Microprocessor Serial Interface updates the
SDO output on the falling edge of this signal.
NOTE: If configured in Hardware Mode, this pin functions as TxClkINV.
87
SDI
RxON
I
Serial Data Input:
Data is serially input through this pin.
The input data is sampled on the rising edge of the SClk pin (pin 88).
NOTES:
1.
This pin is internally pulled down
2.
If configured in Hardware Mode, this pin functions as RxON.
85
SDO
RxMON
I/O
Serial Data Output:
This pin serially outputs the contents of the specified Command Register during
Read Operations. The data is updated on the falling edge of the SClk and this
pin is tri-stated upon completion of data transfer.
NOTE: If configured in Hardware Mode, this pin functions as RxMON.
OPERATING MODE SELECT
相關PDF資料 |
PDF描述 |
|---|---|
| XRT75L04DIVTR-F | IC LIU E3/DS3/STS-1 4CH 176TQFP |
| VI-B6K-IV-F2 | CONVERTER MOD DC/DC 40V 150W |
| VI-B6K-IV-F1 | CONVERTER MOD DC/DC 40V 150W |
| VI-B6J-IV-F3 | CONVERTER MOD DC/DC 36V 150W |
| IDT72815LB15PFI | IC FIFO SYNC DUAL 512X18 128TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XRT75L04DIV-F | 功能描述:外圍驅動器與原件 - PCI 4-Ch DS3, E3, STS-1 RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
| XRT75L04DIVTR | 功能描述:時鐘合成器/抖動清除器 4 CHNL E3/DS3/STS 1 JITTER ATTENUATOR RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75L04DIVTR-F | 功能描述:時鐘合成器/抖動清除器 RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75L04ES | 功能描述:時鐘合成器/抖動清除器 4CH T3/E3/STS1 LIU+JA 3.3V RoHS:否 制造商:Skyworks Solutions, Inc. 輸出端數量: 輸出電平: 最大輸出頻率: 輸入電平: 最大輸入頻率:6.1 GHz 電源電壓-最大:3.3 V 電源電壓-最小:2.7 V 封裝 / 箱體:TSSOP-28 封裝:Reel |
| XRT75L04IV | 功能描述:外圍驅動器與原件 - PCI 4CH E3/DS3/STS1 JITTER ATTENUATOR RoHS:否 制造商:PLX Technology 工作電源電壓: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:FCBGA-1156 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。