REV. 1.0.2 66MHZ PCI BUS OCTAL UART WITH POWER MANAGEMENT SUPPORT TIMERCNTL [7:0] Register The bits [3:0] of this register are used" />
參數資料
型號: XR17V258IVTR-F
廠商: Exar Corporation
文件頁數: 14/69頁
文件大?。?/td> 0K
描述: IC UART PCI BUS OCTAL 144LQFP
標準包裝: 750
特點: *
通道數: 8
FIFO's: 64 字節
規程: RS485
電源電壓: 3.3V,5V
帶自動流量控制功能:
帶IrDA 編碼器/解碼器:
帶故障啟動位檢測功能:
帶調制解調器控制功能:
安裝類型: 表面貼裝
封裝/外殼: 144-LQFP
供應商設備封裝: 144-LQFP(20x20)
包裝: 帶卷 (TR)
XR17V258
21
REV. 1.0.2
66MHZ PCI BUS OCTAL UART WITH POWER MANAGEMENT SUPPORT
TIMERCNTL [7:0] Register
The bits [3:0] of this register are used to issue commands. The commands are self-clearing, so reading this
register does not show the last written command. Reading this register returns a value of 0x01 when the Timer
interrupt is enabled and there is a pending Timer interrupt. It returns a value of 0x00 at all other times. The
default settings of the Timer, upon power-up, a hardware reset or upon the issue of a ’Timer Reset’ command
are:
Timer Interrupt Disabled
Re-triggerable mode selected
Internal crystal oscillator outputs selected as clock source
Timer output not routed to MPIO[0]
Timer stopped
TABLE 10: TIMER CONTROL REGISTERS
TIMERCNTL [7:4] Reserved
TIMERCNTL [3:0] These bits are used to invoke a series of commands that control the function of the Timer/Counter.
The commands 1100 to 1111 are reserved.
0001: Enable Timer Interrupt
0010: Disable Timer Interrupt
0011: Select One-shot mode
0100: Select Re-triggerable mode
0101: Select Internal Crystal Oscillator output as clock input for the Timer
0110: Select External Clock input through the TMRCK pin for the Timer
0111: Route Timer output to MPIO[0] pin
1000: De-route Timer output from MPIO[0]
1001: Start Timer
1010: Stop Timer
1011: Reset Timer
TIMER OPERATION
The following paragraphs describe the operation of the 16-bit Timer/Counter. The following conventions will be
used in this discussion:
’N’ is the 16-bit value programmed in the TIMER MSB, LSB registers
P +Q = N, where ’P’ and ’Q’ are approximately half of ’N’.
If N is even, P = Q = N/2.
If N is odd, P = (N – 1)/2 and Q = (N + 1)/2.
‘N’ can take any value from 0x0002 to 0xFFFF.
Timer Operation in One-Shot Mode:
In the one-shot mode, the Timer output will stay HIGH when started (default state) and will continue to stay
HIGH until it times out (reaches the terminal count of ‘N’ clocks), at which time it will become LOW and stay
LOW. If the Timer is re-started before the Timer times out, the counter is reset and the Timer will wait for
another time-out period before setting its output LOW (See Figure 7). If the Timer times out, re-starting the
Timer does not have any effect and a ’Stop Timer’ command needs to be issued first which will set the Timer
output to its default HIGH state. The Timer must be programmed while it is stopped since the following
operations are blocked after the Timer has been started:
Any write to TIMER MSB, LSB registers
Issue of any command other than ’Start Timer’, ’Stop Timer’ and ’Reset Timer’
相關PDF資料
PDF描述
XR16L788IQTR-F IC UART FIFO 64B OCTAL 100QFP
XR17C154IV-F IC UART PCI BUS QUAD 144LQFP
XR17C154CV-F IC UART PCI BUS QUAD 144LQFP
ATMEGA165P-16AUR IC AVR MCU 16K 16MHZ 64-TQFP
ATMEGA165PV-8AUR IC AVR MCU 16K 8MHZ 64-TQFP
相關代理商/技術參數
參數描述
XR17V352 制造商:EXAR 制造商全稱:EXAR 功能描述:HIGH PERFORMANCE DUAL PCI EXPRESS UART
XR17V352IB-0A-EVB 功能描述:界面開發工具 Eval Board for XR17V352IB Series RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
XR17V352IB113-F 功能描述:UART 接口集成電路 2 Channel PCIe UART w/256 Byte FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
XR17V354 制造商:EXAR 制造商全稱:EXAR 功能描述:HIGH PERFORMANCE QUAD PCI-EXPRESS UART
XR17V354IB-0A-EVB 功能描述:界面開發工具 Eval Board for XR17V354IB-0A RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V