
XECOM
(7)
XE1486
A - Answer Command
-
Bn - Select Communications Standard
n=0
Selects CCITT standards
n=1
Selects Bell standards*
D - Dial Command
-
L =Re-dial last number
P =Pulse dial
T =Tone dial
S=n = Dial stored number
W =Wait for dial tone
, =Pause for the duration of S8
@ = Wait for silence
! =Switch hook flash
; =Return to the command state
En - Command Echo
n=0
Do not echo commands
n=1
Enable command echo*
Hn - Switch Hook Control
-
n=0 Switch hook relay opens*
n=1 The switch hook relay closes
In - Modem Identification
Ln - Speaker Volume
-
n=0 Lowest speaker volume
n=1 Low speaker volume
n=2 Moderate speaker volume*
n=3 High speaker volume
Mn - Speaker Activity
-
n=0
Speaker off
n=1
Speaker on until carrier received*
n=2
Speaker remains on
n=3
Speaker on until carrier detected.
Nn - Data Rate
-
n=0 Handshake only at DTE rate
n=1 Initiate handshaking at rate set by S37;
Fallback if unsuccessful*
On - On Line
n=0
Return On Line with no retrain*
n=1 Initiate retrain returning On Line.
Qn - Responses
n=0 Send responses*
n=1 No Responses
Sr - Interrogate Register
-
Sr=n - Set Register Value
-
Vn - Result Codes
-
n=0
n=1 English Word Result Codes*
Numeric Result Codes
Wn - Connect Message Rate
-
n=0
Send "CONNECT" at DTE Rate*
n=1 Report line and DTE speed, Link protocol
n=2
"CONNECT" Reports Link speed
Xn - Result Code Set
-
n=0 Result codes 0 to 4
n=1 Result codes 0 to 5 and 10
n=2 Result codes 0 to 6 and 10
n=3 Result codes 0 to 5, 7 and 10
n=4 Full Result codes*
Yn - Long Space Disconnect
-
n=0 Long Space Disconnect Disabled*
n=1 Disconnect on long space
Zn - Reset
-
n=0 Reset to user profile 0*
n=1 reset to user profile 1
&Cn - DCD Operation
n=0 DCD is forced active.
n=1 DCD indicates a valid carrier*
&Dn - DTR
n=0 DTR is ignored by the modem.
n=1 Switch to command mode if DTR revoked.
n=2 Modem disconnects if DTR revoked.*
n=3 Perform soft reset when DTR revoked
&Fn - Return to Factory Defaults
n=0 Restore configuration 0*
n=1 Restore configuration 1
&Gn - Guard Tone
n=0 Guard Tone Disabled*
n=1 550 Hz Guard Tone
n=2 1800 Hz Guard Tone
&Kn - Flow Control
n=0 Disabled
n=3 RTS/CTS
n=4 XON/XOFF
n=5 Transparent XON/XOFF
n=6 RTS/CTS and XON/XOFF
&Pn - Dial Pulse Make/Break Ratio
n=0 39/61% @ 10 pps*
n=1 33/67% @ 10 pps
n=2 39/61% @ 20 pps
n=3 33/67% @ 20 pps
&Qn - Line Connection
n=0 Direct mode (no data buffering)*
n=5 Use Error Correction
n=6 Normal Mode (Speed buffering)
XE1486 AT Command List