
14/20 
XC6413/XC6414 
Series
SERIES 
EN/CE INPUT LOGIC 
XC6413/14 * A ~ D 
High Active with Pull-Down 
XC6413/14 * E ~ K 
High Active with No Pull-Down 
XC6413/14 * L ~ P 
Low Active with Pull-Up 
XC6413/14 * R ~ U 
Low Active with No Pull-Up 
■
OPERATIONAL EXPLANATION (Continued)
<EN / CE Pin (Continued)> 
In stand-by mode, the above input current can be reduced by connecting a pull-up resistor between V
ROUT
 and V
DOUT
.  
Note that as the XC6413/14*E to K types of the XC6413/14A to D series are ' High Active / No Pull-Down' and XC6413/14*R 
to U types of the XC6413/14A to D series are ' Low Active / No Pull-Up', operations will become unstable with the CE pin 
open (See the chart below).    
We suggest that you use this IC with either a V
IN
 voltage or a V
SS
 voltage input at the EN or CE pin.  If this IC is used with 
the correct specifications for the EN or CE pin, the IC will operate normally.  However, supply current may increase as a 
result of through current in the IC's internal circuitry if a voltage other than V
IN
 or V
SS
 is applied. 
<Toggle Operation> 
The XC6413/14 A and B series have a built-in toggle ON/OFF switch which repeats an on/off operation via the EN pin's 
leading edge signal when the EN logic is HIGH active, and via the EN pin's falling edge signal when the EN logic is LOW active 
(Please also refer the figure below).  The EN input signal duration should be over 500nsec.  If the EN input signal is less than 
500nsec, it is possible that the circuit fails to respond and the toggle function does not operate.  To operate the toggle function 
properly when the EN pin voltage noise is large, a RC filter should be used to reduce the noise in the signal to the EN pin. 
XC6413/14B series can reset FF (flip flop), used for the toggle operation, internally by using a signal of the detector function.  
The signal of the detector function resets FF after converted to 1 shot signal in the IC.  The regulator block start to output 
when a signal is given via the EN pin again.  
EN Logic High Active 
(*A~D Series) 
[XC6413 Series] 
[XC6414 Series] 
Internal Circuit Response Time 
Approximate 20
μ
sec 
500nsec or more 
EN Pin Signal 
V
ROUT 
Voltage 
V
ROUT 
Voltage
Internal Circuit Response Time
Approximate 10
μ
sec
V
ROUT 
Voltage
V
ROUT 
Voltage
EN Pin Signal 
500nsec or more
V
IN 
Voltage