- 您現在的位置：買賣IC網 > PDF目錄1973 > XC4085XL-3BG560I (Xilinx Inc)IC FPGA I-TEMP 3.3V 3SPD 560MBGA PDF資料下載
參數資料
| 型號： | XC4085XL-3BG560I |
| 廠商： | Xilinx Inc |
| 文件頁數： | 20/68頁 |
| 文件大小： | 0K |
| 描述： | IC FPGA I-TEMP 3.3V 3SPD 560MBGA |
| 產品變化通告： | XC4000(XL,XLA,E) Discontinuation 15/Nov/2004 |
| 標準包裝： | 12 |
| 系列： | XC4000E/X |
| LAB/CLB數： | 3136 |
| 邏輯元件/單元數： | 7448 |
| RAM 位總計： | 100352 |
| 輸入/輸出數： | 448 |
| 門數： | 85000 |
| 電源電壓： | 3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 工作溫度： | -40°C ~ 100°C |
| 封裝/外殼： | 560-LBGA，金屬 |
| 供應商設備封裝： | 560-MBGA（42.5x42.5） |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
R
May 14, 1999 (Version 1.6)
6-31
XC4000E and XC4000X Series Field Programmable Gate Arrays
6
Double-Length Lines
The double-length lines consist of a grid of metal segments,
each twice as long as the single-length lines: they run past
two CLBs before entering a switch matrix. Double-length
lines are grouped in pairs with the switch matrices stag-
gered, so that each line goes through a switch matrix at
every other row or column of CLBs (see Figure 28).
There are four vertical and four horizontal double-length
lines associated with each CLB. These lines provide faster
signal routing over intermediate distances, while retaining
routing exibility. Double-length lines are connected by way
of the programmable switch matrices. Routing connectivity
is shown in Figure 27.
Quad Lines (XC4000X only)
XC4000X devices also include twelve vertical and twelve
horizontal quad lines per CLB row and column. Quad lines
are four times as long as the single-length lines. They are
interconnected via buffered switch matrices (shown as dia-
monds in Figure 27 on page 30). Quad lines run past four
CLBs before entering a buffered switch matrix. They are
grouped in fours, with the buffered switch matrices stag-
gered, so that each line goes through a buffered switch
matrix at every fourth CLB location in that row or column.
(See Figure 29.)
The buffered switch matrixes have four pins, one on each
edge. All of the pins are bidirectional. Any pin can drive any
or all of the other pins.
Each buffered switch matrix contains one buffer and six
pass transistors. It resembles the programmable switch
matrix shown in Figure 26, with the addition of a program-
mable buffer. There can be up to two independent inputs
and up to two independent outputs. Only one of the inde-
pendent inputs can be buffered.
The place and route software automatically uses the timing
requirements of the design to determine whether or not a
quad line signal should be buffered. A heavily loaded signal
is typically buffered, while a lightly loaded one is not. One
scenario is to alternate buffers and pass transistors. This
allows both vertical and horizontal quad lines to be buffered
at alternating buffered switch matrices.
Due to the buffered switch matrices, quad lines are very
fast. They provide the fastest available method of routing
heavily loaded signals for long distances across the device.
Longlines
Longlines form a grid of metal interconnect segments that
run the entire length or width of the array. Longlines are
intended for high fan-out, time-critical signal nets, or nets
that are distributed over long distances. In XC4000X
devices, quad lines are preferred for critical nets, because
the buffered switch matrices make them faster for high
fan-out nets.
Two horizontal longlines per CLB can be driven by 3-state
or open-drain drivers (TBUFs). They can therefore imple-
ment unidirectional or bidirectional buses, wide multiplex-
ers, or wired-AND functions. (See “Three-State Buffers” on
page 26 for more details.)
Each horizontal longline driven by TBUFs has either two
(XC4000E) or eight (XC4000X) pull-up resistors. To acti-
vate these resistors, attach a PULLUP symbol to the
long-line net. The software automatically activates the
appropriate number of pull-ups. There is also a weak
keeper at each end of these two horizontal longlines. This
CLB
PSM
CLB
Doubles
Singles
Doubles
X6601
Figure 28: Single- and Double-Length Lines, with
Programmable Switch Matrices (PSMs)
CLB
X9014
Figure 29: Quad Lines (XC4000X only)
Product Obsolete or Under Obsolescence
相關PDF資料 |
PDF描述 |
|---|---|
| XC4VLX100-10FFG1513C | IC FPGA VIRTEX-4 100K 1513-FBGA |
| XC4VLX25-12FFG676C | IC FPGA VIRTEX-4 LX 25K 676-FBGA |
| XC5202-5PQ100C | IC - FPGA SPEED GRADE 5 COM TEMP |
| XC56309AG100AR2 | IC DSP 24BIT 100MHZ 144-LQFP |
| XC56L307VF160 | IC DSP 24BIT FIXED POINT 196-BGA |
相關代理商/技術參數 |
參數描述 |
|---|---|
| XC4085XL-3PG559C | 制造商:Xilinx 功能描述: |
| XC4085XL-3PG559I | 制造商:Xilinx 功能描述: |
| XC4085XLA-07BG432C | 制造商:Xilinx 功能描述: |
| XC4085XLA-07BG560C | 制造商:Xilinx 功能描述:FPGA, 3136 CLBS, 55000 GATES, 294 MHz, PBGA560 |
| XC4085XLA-07BG560C0314 | 制造商:Xilinx 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。