- 您現在的位置：買賣IC網 > PDF目錄9414 > X9440WV24I-2.7 (Intersil)IC DUAL PROG COMP 10K 24TSSOP PDF資料下載
參數資料
| 型號： | X9440WV24I-2.7 |
| 廠商： | Intersil |
| 文件頁數： | 1/21頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DUAL PROG COMP 10K 24TSSOP |
| 標準包裝： | 75 |
| 系列： | XDCP™ |
| 接片： | 64 |
| 電阻（歐姆）： | 10k |
| 電路數： | 2 |
| 溫度系數： | 標準值 ±300 ppm/°C |
| 存儲器類型： | 非易失 |
| 接口： | 6 線 SPI（芯片選擇，設備位址） |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 24-TSSOP |
| 包裝： | 管件 |
1
FN8200.0
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-352-6832
| Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
X9440
Mixed Signal with SPI Interface
Dual Digitally Controlled Potentiometer
(XDCP) & Voltage Comparator
FEATURES
Two digitally controlled potentiometers and two
voltage comparators in one package
SPI serial interface
Register oriented format
—Direct read/write wiper position
—Store as many as four positions per pot
Fast response comparator
Enable, latch, or shutdown comparator outputs
through the ACR
Auto-recall of WCR and ACR data from R0
Hardware write protection, WP
Separate analog and digital/system supplies
Direct write cell
—Endurance–100,000 data changes per bit per
register
—Register data retention–100 years
16-bytes of EEPROM memory
Power saving feature and low noise
Two 10k
or two 2.5k potentiometers
Resolution: 64 taps each pot
24-lead TSSOP and 24-Lead SOIC packages
DESCRIPTION
The X9440 integrates two non volatile digitally con-
trolled potentiometers (XDCP) and two voltage com-
parators on a CMOS monolithic microcircuit.
The X9440 contains two resistor arrays, each com-
posed of 63 resistive elements. Between each ele-
ment and at either end are tap points accessible to the
wiper elements. The position of the wiper element on
the array is controlled by the user through the SPI
serial bus interface.
Each potentiometer has an associated voltage com-
parator. The comparator compares the external input
voltage VNI with the wiper voltage VW and sets the out-
put voltage level to a logic high or low.
Each resistor array and comparator has associated
with it a wiper counter register (WCR), analog control
register (ACR), and eight 6 bit data registers that can
be directly written and read by the user. The contents
of the wiper counter register controls the position of
the wiper on the resistor array. The contents of the
analog control register controls the comparator and its
output. The potentiometer is programmed with a SPI
serial interface.
BLOCK DIAGRAM
VOUT (0,1)
(R0-R3)0,1
Interface
and
Control
Circuitry
SCK
S0
SI
A1
CS
HOLD
VH (0,1)
VL (0,1)
WP
VW (0,1)
VNI (0,1)
+
–
WCR0,1
(R0-R3)0,1
ACR0,1
A0
Data Sheet
March 28, 2005
相關PDF資料 |
PDF描述 |
|---|---|
| X9448WV24I-2.7 | IC DUAL PROG COMP 10K 24TSSOP |
| X9448WV24I | IC DUAL PROG COMP 10K 24TSSOP |
| X9440WV24I | IC DUAL PROG COMP 10K 24TSSOP |
| X9440WS24 | IC DUAL PROG COMP 10K 64TP SO24 |
| X9448WS24-2.7 | IC DUAL PROG COMP 10K 64TP SO24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X9440YP24 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Mixed Signal with SPI Interface |
| X9440YP242.7 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Interface IC |
| X9440YP24-2.7 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Mixed Signal with SPI Interface |
| X9440YP24I | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Mixed Signal with SPI Interface |
| X9440YP24I2.7 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Interface IC |
發布緊急采購，3分鐘左右您將得到回復。