- 您現在的位置：買賣IC網 > PDF目錄371253 > X40431 10NS, PLCC, COM TEMP (SEE C-10)(EPLD) PDF資料下載
參數資料
| 型號： | X40431 |
| 英文描述： | 10NS, PLCC, COM TEMP (SEE C-10)(EPLD) |
| 文件頁數： | 10/25頁 |
| 文件大?。?/td> | 144K |
| 代理商： | X40431 |
X4043/45
Characteristics subject to change without notice.
10 of 25
REV 1.1.17 9/14/01
www.xicor.com
Page Write
The device is capable of a page write operation. It is
initiated in the same manner as the byte write opera-
tion; but instead of terminating the write cycle after the
first data byte is transferred, the master can transmit
an unlimited number of 8-bit bytes. After the receipt of
each byte, the device will respond with an acknowl-
edge, and the address is internally incremented by
one. The page address remains constant. When the
counter reaches the end of the page, it “rolls over” and
goes back to ‘0’ on the same page. This means that the
master can write 16 bytes to the page starting at any
location on that page. If the master begins writing at
location 10, and loads 12 bytes, then the first 5 bytes
are written to locations 10 through 15, and the last 7
bytes are written to locations 0 through 6. Afterwards,
the address counter would point to location 7 of the
page that was just written. If the master supplies more
than 16 bytes of data, then new data over-writes the
previous data, one byte at a time.
Figure 11. Page Write Operation
Figure 12. Writing 12-bytes to a 16-byte page starting at location 10
S
t
a
r
t
S
t
o
p
Slave
Address
Byte
Address
Data
(n)
A
C
K
A
C
K
SDA Bus
Signals from
the Slave
Signals from
the Master
0
Data
(1)
A
C
K
(1
≤
n
≤
16)
A
C
K
Address
n-1
Address
10
5 Bytes
7 Bytes
Address
= 6
Address Pointer
Ends Here
Addr = 7
The master terminates the data byte loading by issuing
a stop condition, which causes the device to begin the
nonvolatile write cycle. As with the byte write operation,
all inputs are disabled until completion of the internal
write cycle. See Figure 11 for the address, acknowl-
edge, and data transfer sequence.
Stops and Write Modes
Stop conditions (that terminate write operations) must
be sent by the master after sending at least 1 full data
byte, plus the subsequent ACK signal. If a stop is
issued in the middle of a data byte, or before 1 full data
byte plus its associated ACK is sent, then the device
will reset itself without performing the write. The con-
tents of the array will not be effected.
Figure 10. Byte Write Sequence
.
S
t
a
r
t
S
t
o
p
Slave
Address
Byte
Address
Data
A
C
K
A
C
K
A
C
K
SDA Bus
Signals from
the Slave
Signals from
the Master
0
相關PDF資料 |
PDF描述 |
|---|---|
| X4043M8-1.8 | 25NS, SOIC, COM TEMP(EPLD) |
| X4043P8 | 10NS, PDIP, COM TEMP(EPLD) |
| X4043P8-2.7 | Analog IC |
| X4043P8-2.7A | F22V10C FAMILY,500 GATE SPLD,5V,24-PIN(EPLD) |
| X4043P8-4.5A | 10NS, TSSOP, IND TEMP(EPLD) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| X40431S14-A | 功能描述:IC VOLT MON TRPL EEPROM 14-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X40431S14-AT1 | 功能描述:IC VOLT MON TRPL EEPROM 14-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X40431S14-B | 功能描述:IC VOLT MON TRPL EEPROM 14-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X40431S14-BT1 | 功能描述:IC VOLT MON TRPL EEPROM 14-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
| X40431S14-C | 功能描述:IC VOLT MON TRPL EEPROM 14-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 監控器 系列:- 標準包裝:100 系列:- 類型:簡單復位/加電復位 監視電壓數目:1 輸出:- 復位:低有效 復位超時:最小為 100 ms 電壓 - 閥值:4.38V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:8-TSSOP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。