- 您現在的位置：買賣IC網 > PDF目錄361880 > WM8199CDR (Wolfson Microelectronics) TVS BIDIRECT 400W 60V SMA PDF資料下載
參數資料
| 型號： | WM8199CDR |
| 廠商： | Wolfson Microelectronics |
| 英文描述： | TVS BIDIRECT 400W 60V SMA |
| 中文描述： | 20MSPS 16位數字化儀防治荒漠化公約 |
| 文件頁數： | 17/30頁 |
| 文件大小： | 358K |
| 代理商： | WM8199CDR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
WM8199
Production Data
w
PD Rev 3.2 November 2003
17
CONTROL INTERFACE
The internal control registers are programmable via the serial digital control interface. The register
contents can be read back via the serial interface on pin OP[7]/SDO.
It is recommended that a software reset is carried out after the power-up sequence, before writing to
any other register. This ensures that all registers are set to their default values (as shown in Table
5).
SERIAL INTERFACE: REGISTER WRITE
Figure 16 shows register writing in serial mode. Three pins, SCK, SDI and SEN are used. A six-bit
address (a5, 0, a3, a2, a1, a0) is clocked in through SDI, MSB first, followed by an eight-bit data
word (b7, b6, b5, b4, b3, b2, b1, b0), also MSB first. Each bit is latched on the rising edge of SCK.
When the data has been shifted into the device, a pulse is applied to SEN to transfer the data to the
appropriate internal register. Note all valid registers have address bit a4 equal to 0 in write mode.
SCK
SEN
SDI
a5
0
a3
Address
a2
a1
a0
b7
b6
b5
b4
b3
b2
b1
b0
Data Word
Figure 16 Serial Interface Register Write
A software reset is carried out by writing to Address “000100” with any value of data, (i.e. Data Word
= XXXXXXXX).
SERIAL INTERFACE: REGISTER READ-BACK
Figure 17 shows register read-back in serial mode. Read-back is initiated by writing to the serial bus
as described above but with address bit a4 set to 1, followed by an 8-bit dummy data word. Writing
address (a5, 1, a3, a2, a1, a0) will cause the contents (d7, d6, d5, d4, d3, d2, d1, d0) of
corresponding register (a5, 0, a3, a2, a1, a0) to be output MSB first on pin SDO (on the falling edge
of SCK). Note that pin SDO is shared with an output pin, OP[7], therefore OEB should always be
held low when register read-back data is expected on this pin. The next word may be read in to SDI
while the previous word is still being output on SDO.
SCK
SEN
SDI
a5
1
a3 a2 a1 a0
Address
x
x
x
Data Word
x
x
x
x
x
d7 d6 d5 d4 d3 d2 d1 d0
Output Data Word
SDO/
OP[7]
OEB
Figure 17 Serial Interface Register Read-back
TIMING REQUIREMENTS
To use this device a master clock (MCLK) of up to 40MHz and a per-pixel synchronisation clock
(VSMP) of up to 20MHz are required. These clocks drive a timing control block, which produces
internal signals to control the sampling of the video signal. MCLK to VSMP ratios and maximum
sample rates for the various modes are shown in Table 4.
相關PDF資料 |
PDF描述 |
|---|---|
| WM8199CDS | TVS UNIDIRECT 400W 64V SMA |
| WM8199SCDR | 20MSPS 16-bit CCD Digitiser |
| WM8199SCDS | 20MSPS 16-bit CCD Digitiser |
| WM8716 | High Performance 24-bit, 192kHz Stereo DAC |
| WM8716EDS | High Performance 24-bit, 192kHz Stereo DAC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| WM8199CDS | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:20MSPS 16-bit CCD Digitiser |
| WM8199SCDR | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:20MSPS 16-bit CCD Digitiser |
| WM8199SCDS | 制造商:WOLFSON 制造商全稱:WOLFSON 功能描述:20MSPS 16-bit CCD Digitiser |
| WM8199SCDS/RV | 功能描述:視頻模擬/數字化轉換器集成電路 16-Bit 20MSPS 3-Channel AFE RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
| WM8199SCDS/V | 功能描述:視頻模擬/數字化轉換器集成電路 16-Bit 20MSPS 3-Channel AFE RoHS:否 制造商:Texas Instruments 輸入信號類型:Differential 轉換器數量:1 ADC 輸入端數量:4 轉換速率:3 Gbps 分辨率:8 bit 結構: 輸入電壓:3.3 V 接口類型:SPI 信噪比: 電壓參考: 電源電壓-最大:3.45 V 電源電壓-最小:3.15 V 最大功率耗散: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:TCSP-48 封裝:Reel |
發(fā)布緊急采購，3分鐘左右您將得到回復。