- 您現在的位置：買賣IC網 > PDF目錄381205 > US3005 (Unisem Group) 5 BIT PROGRAMMABLE SYNCHRONOUS BUCK CONTROLLER IC WITH DUAL LDO CONTROLLER PDF資料下載
參數資料
| 型號： | US3005 |
| 廠商： | Unisem Group |
| 英文描述： | 5 BIT PROGRAMMABLE SYNCHRONOUS BUCK CONTROLLER IC WITH DUAL LDO CONTROLLER |
| 中文描述： | 5位可編程同步降壓控制器IC具有雙LDO控制器 |
| 文件頁數： | 10/14頁 |
| 文件大?。?/td> | 99K |
| 代理商： | US3005 |
4-10
Rev. 1.2
12/8/00
US3004,US3005
Appl ication Information
An example of how to calculate the components for the
application circuit is given below.
Assuming, two sets of output conditions that this regu-
lator must meet,
a) Vo=2.8V , Io=14.2A,
Vo=185mV,
Io=14.2A
b) Vo=2V , Io=14.2A,
Vo=140mV,
Io=14.2A
The regulator design will be done such that it meets the
worst case requirement of each condition.
Output Capacitor Selection
The first step is to select the output capacitor. This is
done primarily by selecting the maximum ESR value
that meets the transient voltage budget of the total
Vo
specification. Assuming that the regulators DC initial
accuracy plus the output ripple is 2% of the output volt-
age, then the maximum ESR of the output capacitor is
calculated as :
ESR
≤
=
100
142
7
.
m
The Sanyo MVGX series is a good choice to achieve
both the price and performance goals. The 6MV1500GX
, 1500uF, 6.3V has an ESR of less than 36 m
typ .
Selecting 6 of these capacitors in parallel has an ESR
of
≈
6 m
which achieves our low ESR goal.
Other type of Electrolytic capacitors from other manu-
facturers to consider are the Panasonic “FA” series or
the Nichicon “PL” series.
Reducing the Output Capacitors Using Voltage Level
Shifting Technique
The trace resistance or an external resistor from the output
of the switching regulator to the Slot 1 can be used to
the circuit advantage and possibly
reduce the number
of output capacitors, by level shifting the DC regu-
lation point when transitioninig from light load to
full load and vice versa
. To accomplish this, the out-
put of the regulator is typically set about half the DC
drop that results from light load to full load. For example,
if the total resistance from the output capacitors to the
Slot 1 and back to the GND pin of the device is 5m
and
if the total
I, the change from light load to full load is
14A, then the output voltage measured at the top of the
resistor divider which is also connected to the output
capacitors in this case, must be set at half of the 70 mV
or 35mV higher than the DAC voltage setting. This in
tentional voltage level shifting during the load transient
eases the requirement for the output capacitor ESR at
the cost of load regulation. One can show that the new
ESR requirement eases up by
half the total trace re-
sistance.
For example, if the ESR requirement of the
output capacitors without voltage level shifting must be
7m
then after level shifting the new ESR will only need
to be 9.5m
if the trace resistance is 5m
(7+5/2=9.5).
However, one must be careful that the combined “volt-
age level shifting” and the transient response is still within
the maximum tolerance of the Intel specification. To in-
sure this, the maximum trace resistance must be less
than:
Rs
≤
2(Vspec - 0.02*Vo -
Vo)/
I
Where :
Rs=Total maximum trace resistance allowed
Vspec=Intel total voltage spec
Vo=Output voltage
Vo=Output ripple voltage
I=load current step
For example, assuming:
Vspec=
±
140 mV=
±
0.1V for 2V output
Vo=2V
Vo=assume 10mV=0.01V
I=14.2A
Then the Rs is calculated to be:
Rs
≤
2(0.140 - 0.02*2 - 0.01)/14.2=12.6m
However, if a resistor of this value is used, the maximum
power dissipated in the trace (or if an external resistor is
being used) must also be considered. For example if
Rs=12.6 m
, the power dissipated is
(Io^2)*Rs=(14.2^2)*12.6=2.54W. This is a lot of power to
be dissipated in a system. So, if the Rs=5m
, then the
power dissipated is about 1W which is much more ac-
ceptable. If level shifting is not implemented, then the
maximum output capacitor ESR was shown previously
to be 7m
which translated to
≈
6 of the 1500uF,
6MV1500GX type Sanyo capacitors. With Rs=5m
, the
maximum ESR becomes 9.5m
which is equivalent to
≈
4 caps. Another important consideration is that
if a
trace is being used to implement the resistor, the
power dissipated by the trace increases the case
temperature of the output capacitors which could
seriously effect the life time of the output capaci-
tors.
Output Inductor Selection
The output inductance must be selected such that un-
der low line and the maximum output voltage condition,
the inductor current slope times the output capacitor
ESR is ramping up faster than the capacitor voltage is
相關PDF資料 |
PDF描述 |
|---|---|
| US3005CW | 5 BIT PROGRAMMABLE SYNCHRONOUS BUCK CONTROLLER IC WITH DUAL LDO CONTROLLER |
| US3007 | 5 BIT PROGRAMMABLE SYNCHRONOUS BUCK PLUS NON SYNCHRONOUS , LDO CONTROLLER AND 200MmA LDO ON BOARD |
| US3007CW | 5 BIT PROGRAMMABLE SYNCHRONOUS BUCK PLUS NON SYNCHRONOUS , LDO CONTROLLER AND 200MmA LDO ON BOARD |
| US3011 | 5 BIT PROGRAMMABLE SYNCHRONOUS BUCK CONTROLLER IC |
| US3011CW | 5 BIT PROGRAMMABLE SYNCHRONOUS BUCK CONTROLLER IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| US3005CW | 制造商:UNISEM 制造商全稱:UNISEM 功能描述:5 BIT PROGRAMMABLE SYNCHRONOUS BUCK CONTROLLER IC WITH DUAL LDO CONTROLLER |
| US3007 | 制造商:UNISEM 制造商全稱:UNISEM 功能描述:5 BIT PROGRAMMABLE SYNCHRONOUS BUCK PLUS NON SYNCHRONOUS , LDO CONTROLLER AND 200MmA LDO ON BOARD |
| US3007CW | 制造商:UNISEM 制造商全稱:UNISEM 功能描述:5 BIT PROGRAMMABLE SYNCHRONOUS BUCK PLUS NON SYNCHRONOUS , LDO CONTROLLER AND 200MmA LDO ON BOARD |
| US3008 | 制造商:UNITPOWER 制造商全稱:UNITPOWER 功能描述:N-Ch 30V Fast Switching MOSFETs |
| US-3008 | 功能描述:PROTO-BOARD 8PIN THRU-HOLE SIP RoHS:是 類別:原型開發產品 >> 適配器，可互換接口板 系列:3000, UNI-SIP™ 標準包裝:1 系列:- 原型板類型:- Package Accepted:- 尺寸/尺寸:- 位置數:- 孔直徑:- 板厚度:- 材質:- |
發布緊急采購，3分鐘左右您將得到回復。