- 您現在的位置：買賣IC網 > PDF目錄381009 > US1176 (Unisem Group) 7.5A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE REGULATOR WITH SHUTDOWN INPUT PDF資料下載
參數資料
| 型號： | US1176 |
| 廠商： | Unisem Group |
| 英文描述： | 7.5A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE REGULATOR WITH SHUTDOWN INPUT |
| 中文描述： | 7.5A的超低壓差型正面的關斷輸入可調調壓器 |
| 文件頁數： | 5/5頁 |
| 文件大?。?/td> | 35K |
| 代理商： | US1176 |
US1176
2-5
Rev. 1.1
9/24/99
The US1176 keeps a constant 1.25V between the Vsense
pin and the Vadj pin. By placing a resistor R1 across
these two pins and connecting the Vsense and Vout pin
together , a constant current flows through R1, adding
to the Iadj current and into the R2 resistor producing a
voltage equal to the (1.25/R1)*R2 + Iadj*R2 .This voltage
is then added to the 1.25V to set the output voltage.
This is summarized in the above equation. Since the
minimum load current requirement of the US1176 is 10
mA , R1 is typically selected to be a 121
resistor so
that it automatically satisfies this condition. Notice that
since the Iadj is typically in the range of 50uA it only
adds a small error to the output voltage and should be
considered when very precise output voltage setting is
required.
Load Regulation
Since the US1176 has separate pins for the output (Vout)
and the sense (Vsense), it is ideal for providing true re-
mote sensing of the output voltage at the load.This
means that the voltage drops due to parasitic resistance
such as PCB traces between the regulator and the load
are compensated for using remote sensing. Figure 3
shows a typical application of the US1176 with remote
sensing.
Figure 3 - Schematic showing connection for best
load regulation
Stability
The US1176 requires the use of an output capacitor as
part of the frequency compensation in order to make the
regulator stable. Typical designs for the microproces-
sor applications use standard electrolytic capacitors with
typical ESR in the range of 50 to 100 m
and an output
capacitance of 500 to 1000uF. Fortunately as the ca-
pacitance increases, the ESR decreases resulting in a
fixed RC time constant. The US1176 takes advantage of
this phenomena in making the overall regulator loop
stable.
For most applications a minimum of 100uF aluminum
electrolytic capacitor such as Sanyo, MVGX series
,Panasonic FA series as well as the Nichicon PL series
insures both stability and good transient response.
Shutdown Operation
The US1176 can be disabled by pulling the S.D pin low
using an open collector device such as a low cost 2N3904
general purpose transistor as shown in the application
circuit. The current sink of the pin is equal to:
Isink=(Vctrl-1.4)/R where, R=50 k
typ.
Thermal Design
The US1176 incorporates an internal thermal shutdown
that protects the device when the junction temperature
exceeds the allowable maximum junction temperature.
Although this device can operate with junction tempera-
tures in the range of 150
°
C ,it is recommended that the
selected heat sink be chosen such that during maxi-
mum continuos load operation the junction temperature
is kept below this number. The example below shows
the steps in selecting the proper surface mount pack-
age.
Assuming, the following conditions:
Vout=2.7V
Vin=3.3V
Vctrl=5V
Iout=2A DC Avg
Calculate the maximum power dissipation using the fol-
lowing equation:
Pd=Iout*(Vin-Vout) + (Iout/60)*(Vctrl - Vout)
Pd=2*(3.3-2.7) + (2/60)*(5-2.7)=1.28 W
Using table below select the proper package and the
amount of copper board needed.
Pkg
Copper
θ
JA
(
°
C/W) Max Pd Max Pd
Area
(
Ta=25
°
C
) (
Ta=45
°
C
)
M or P 1.4"X1.4" 25
M or P 1.0"X1.0" 30
M or P 0.7"X0.7" 35
M or P Pad Size 45
4.4W 3.6W
3.7W 3.0W
3.1W 2.6W
2.4W 2.0W
Note: Above table is based on the maximum junction
temperature of 135
°
C.
As shown in the above table, any of the two packages
will do the job. For lower cost applications the Power
Flex package is recommended.
1176app3-1.0
R1
R2
Vin
Vctrl
RL
US1176
Vsense
Adj
Vout
Vctrl
Vin
相關PDF資料 |
PDF描述 |
|---|---|
| US1207-18CM | 1A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE & FIXED REGULATOR |
| US1207-25CM | 1A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE & FIXED REGULATOR |
| US1207-33CM | 1A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE & FIXED REGULATOR |
| US1206-18CD | 1A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE & FIXED REGULATOR |
| US1206-18CM | 1A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE & FIXED REGULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| US1176CM | 制造商:UNISEM 制造商全稱:UNISEM 功能描述:7.5A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE REGULATOR WITH SHUTDOWN INPUT |
| US1176CP | 制造商:UNISEM 制造商全稱:UNISEM 功能描述:7.5A ULTRA LOW DROPOUT POSITIVE ADJUSTABLE REGULATOR WITH SHUTDOWN INPUT |
| US12 | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:RECTIFIERS ASSEMBLIES |
| US1202512H | 制造商:Toyo Fan 功能描述: |
| US1205 | 制造商:UNISEM 制造商全稱:UNISEM 功能描述:300 mA LOW DROPOUT POSITIVE ADJUSTABLE REGULATOR |
發布緊急采購，3分鐘左右您將得到回復。