參數資料
型號: UPD78F9210CS-CAB-A
廠商: Renesas Electronics America
文件頁數: 50/175頁
文件大?。?/td> 0K
描述: MCU 8BIT 1KB FLASH 16PIN
標準包裝: 400
系列: 78K0S/Kx1+
核心處理器: 78K0S
芯體尺寸: 8-位
速度: 10MHz
外圍設備: LVD,POR,PWM,WDT
輸入/輸出數: 13
程序存儲器容量: 1KB(1K x 8)
程序存儲器類型: 閃存
RAM 容量: 128 x 8
電壓 - 電源 (Vcc/Vdd): 2 V ~ 5.5 V
數據轉換器: A/D 4x10b
振蕩器型: 內部
工作溫度: -40°C ~ 85°C
封裝/外殼: 16-DIP(0.300",7.62mm)
包裝: 托盤
CHAPTER 7 8-BIT TIMER H1
User’s Manual U16994EJ6V0UD
141
<4>
When 8-bit timer counter H1 and the CMP11 register match, TOH1 output becomes inactive and the
compare register to be compared with 8-bit timer counter H1 is changed from the CMP11 register to the
CMP01 register.
At this time, 8-bit timer counter H1 is not cleared and the INTTMH1 signal is not
generated.
<5>
By performing procedures <3> and <4> repeatedly, a pulse with an arbitrary duty can be obtained.
<6>
To stop the count operation, set TMHE1 = 0.
If the setting value of the CMP01 register is N, the setting value of the CMP11 register is M, and the count clock
frequency is fCNT, the PWM pulse output cycle and duty are as follows.
PWM pulse output cycle = (N+1)/fCNT
Duty = Active width : Total width of PWM = (M + 1) : (N + 1)
Cautions 1. In PWM output mode, the setting value for the CMP11 register can be changed during timer
count operation.
However, three operation clocks (signal selected using the CKS12 to
CKS10 bits of the TMHMD1 register) or more are required to transfer the register value after
rewriting the CMP11 register value.
2. Be sure to set the CMP11 register when starting the timer count operation (TMHE1 = 1) after
the timer count operation was stopped (TMHE1 = 0) (be sure to set again even if setting the
same value to the CMP11 register).
(2) Timing chart
The operation timing in PWM output mode is shown below.
Caution
Make sure that the CMP11 register setting value (M) and CMP01 register setting value (N) are
within the following range.
00H
≤ CMP11 (M) < CMP01 (N) ≤ FFH
相關PDF資料
PDF描述
P87C54X2BBD,157 IC 80C51 MCU 256 RAM 44LQFP
EFM32TG110F16 MCU 32BIT 16KB FLASH 24-QFN
C8051F301-GMR IC 8051 MCU 8K FLASH 11QFN
P89LPC933HDH,512 IC 80C51 MCU 4KB FLASH 28TSSOP
P89LPC9321FDH,512 IC 80C51 MCU 8KB FLASH 28TSSOP
相關代理商/技術參數
參數描述
UPD78F9210GR(T)-JJG-A 制造商:Renesas Electronics Corporation 功能描述: 制造商:NEC Electronics Corporation 功能描述:8BIT MCU 1K FLASH 128B RAM 78F9210
UPD78F9210GR-JJG-A 功能描述:MCU 8BIT 1KB FLASH MEM 16-SSOP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:78K0S/Kx1+ 標準包裝:38 系列:Encore!® XP® 核心處理器:eZ8 芯體尺寸:8-位 速度:5MHz 連通性:IrDA,UART/USART 外圍設備:欠壓檢測/復位,LED,POR,PWM,WDT 輸入/輸出數:16 程序存儲器容量:4KB(4K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 3.6 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 105°C 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 包裝:管件 其它名稱:269-4116Z8F0413SH005EG-ND
UPD78F9210MA-FAA-AX 制造商:Renesas Electronics Corporation 功能描述:78K0S/KY1+ MCU, 1KB FLASH, 0.125KB RAM, 16-SSOP - Trays 制造商:Renesas Electronics Corporation 功能描述:IC MCU 8BIT 1KB FLASH 16SSOP 制造商:Renesas Electronics Corporation 功能描述:MCU 8BIT 10MHZ 1KB 16SSOP
UPD78F9211CS-CAB-A 功能描述:MCU 8BIT 2KB FLASH 16PIN RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:78K0S/Kx1+ 標準包裝:300 系列:78K0R/Ix3 核心處理器:78K/0R 芯體尺寸:16-位 速度:40MHz 連通性:3 線 SIO,I²C,LIN,UART/USART 外圍設備:DMA,LVD,POR,PWM,WDT 輸入/輸出數:27 程序存儲器容量:16KB(16K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:1K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:A/D 8x10b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:38-SSOP 包裝:托盤
UPD78F9211FH-2A2-A 制造商:Renesas Electronics Corporation 功能描述: