參數資料
型號: UPD6P5MC-5A4
廠商: NEC Corp.
英文描述: 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION
中文描述: 4位單片機的紅外遙控傳輸
文件頁數: 6/32頁
文件大?。?/td> 232K
代理商: UPD6P5MC-5A4
6
μ
PD6P5
Data Sheet U14760EJ1V0DS00
1. PIN FUNCTIONS
1.1 Normal Operation Mode
Pin No.
Symbol
Function
Output Format
When Reset
1
2
15-20
K
I/O0
-K
I/O7
CMOS
push-pull
Note 1
High-level output
3
S
0
High-impedance
(OFF mode)
4
S
1
/LED
CMOS push-pull
High-level output
(LED)
5
REM
CMOS push-pull
Low-level output
6
V
DD
7
8
X
OUT
X
IN
Low level
(oscillation stopped)
9
GND
10
S
2
Input
(high-impedance,
STOP mode
release cannot be
used)
11-14
K
I0
-K
I3
Note 2
Input (low-level)
Notes 1.
Note that the drive capability of the low-level output side is held low.
2.
In order to prevent malfunction, be sure to input a low level to more than one of pins K
I0
to K
I3
when
POC is released due to supply voltage startup.
These pins refer to the 8-bit I/O ports. I/O switching can
be made in 8-bit units.
In INPUT mode, a pull-down resistor is added.
In OUTPUT mode, they can be used as a key scan output
from key matrix.
Refers to the input port.
Can also be used as a key return input from key matrix.
In INPUT mode, the availability of the pull-down resistor
of the S
0
and S
1
ports can be specified by software in
terms in 2-bit units.
If INPUT mode is canceled by software, this pin is placed
in OFF mode and enters the high-impedance state.
Refers to the I/O port.
In INPUT mode (S
1
), this pin can also be used as a key
return input from key matrix.
The availability of the pull-down resistor of the S
0
and S
1
ports can be specified by software in 2-bit units.
In OUTPUT mode (LED), this pin becomes the remote
control transmission display output (active low). When
the remote control carrier is output from the REM output,
this pin outputs the low level from the LED output
synchronously with the REM signal.
Refers to the infrared remote control transmission output.
The output is active high.
Carrier frequency: f
X
/8, f
X
/64, f
X
/96, high-level,
f
X
/16, f
X
/128, f
X
/192 (usable on software)
Refers to the power supply.
These pins are connected to system clock ceramic
resonators.
Refers to the ground.
Refers to the input port.
The use of the STOP mode release of the S
2
port can be
specified by software. When using this pin as a key input
from a key matrix, enable the use of the STOP mode
release (at this time, a pull-down resistor is connected
internally.)
When the STOP mode release is disabled, this pin can
be used as the input port which does not release the
STOP mode even if the release condition is established
(at this time, a pull-down resistor is not connected internally.)
These pins refer to the 4-bit input ports.
They can be used as a key return input from key matrix.
The use of the pull-down resistor can be specified by
software in 4-bit units.
相關PDF資料
PDF描述
UPD70208HLP-16 V40HLTM, V50HLTM 16/8, 16-BIT MICROPROCESSOR
UPD70216HGF-10-3B9 V40HLTM, V50HLTM 16/8, 16-BIT MICROPROCESSOR
UPD70216HGF-12-3B9 V40HLTM, V50HLTM 16/8, 16-BIT MICROPROCESSOR
UPD70216HGF-16-3B9 V40HLTM, V50HLTM 16/8, 16-BIT MICROPROCESSOR
UPD70216HGF-20-3B9 V40HLTM, V50HLTM 16/8, 16-BIT MICROPROCESSOR
相關代理商/技術參數
參數描述
UPD6P8 制造商:NEC 制造商全稱:NEC 功能描述:MOS INTEGRATED CIRCUIT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION
UPD6P8AMC-5A4-A 制造商:NEC 制造商全稱:NEC 功能描述:MOS INTEGRATED CIRCUIT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION
UPD6P8BMC-5A4-A 制造商:NEC 制造商全稱:NEC 功能描述:MOS INTEGRATED CIRCUIT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION
UPD6P8MC-5A4-A 制造商:NEC 制造商全稱:NEC 功能描述:MOS INTEGRATED CIRCUIT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR INFRARED REMOTE CONTROL TRANSMISSION
UPD6P9M1MC-5A4 制造商:Renesas Electronics Corporation 功能描述:MCU 4-Bit 6X CISC 4KB EPROM 2.5V/3.3V 20-Pin SSOP