參數資料
型號： UPD17207GF
廠商： NEC Corp.
英文描述： 4-BIT SINGLE-CHIP MICROCONTROLLER WITH LCD CONTROLLER/DRIVER AND A/D CONVERTER FOR INFRARED REMOTE CONTROL TRANSMITTERS
中文描述： 4位單片機與LCD控制器/驅動器和A / D轉換器紅外遙控遞質
文件頁數： 42/120頁
文件大?。?/td> 516K
代理商： UPD17207GF
μ
PD17201A, 17207
42
Remarks 1.
The INT and RESET pins are multiplexed with test pins (refer to
3.4 NOTES ON USING RESET
AND INT PINS
).
In this figure, the RESET pin is connected to a pull-up resistor by mask option.
2.
7.3.3
Countermeasures against Noise during Transmission (Carrier Output)
When a signal is transmitted from the transmitter of a remote controller, a peak current of 0.5 to 1 A may flow through
the infrared LED. Since two batteries are usually used as the power source of the transmitter, several
of equivalent
resistance (r) exists in the power source as shown in Fig. 7-6. This resistance increases from 10 to
20
if the supply voltage drops to 2 V. While the carrier is output from the REM pin (while the infrared LED lights),
therefore, a high-frequency noise may be generated on the power lines due to the voltage fluctuation that may take
place especially during switching.
To minimize the influence on the microcontroller of this high-frequency noise, take the following measures:
1
Separate the power lines of the microcontroller from the power lines of the infrared LED with the terminals of
the batteries at the center. Use thick power lines and keep the wiring short.
Locate the oscillator as close as possible to the microcontroller and shield it with GND lines (as indicated by
the portion inside the dotted line in the figure below).
Locate the capacitor for stabilization of the power supply closely to the power lines of the microcontroller. Also,
use a capacitor to eliminate high-frequency noise.
To prevent data from changing, do not execute an interrupt that requires read/write processing and stack, such
as key scan interrupt, and the CALL/RET instruction, while the carrier is output.
To improve the reliability in case of program hang-up, use the watchdog timer (connect the WDOUT and
RESET pins).
2
3
4
5
Fig. 7-6 Example of Countermeasures against Noise
0.5 to 1 A
Infrared LED
REM
V
DD
RESET
WDOUT
Microcontroller
+
_
r
Batteries
V
SS
相關PDF資料
PDF描述
UPD17202AGF-011 Circular Connector; No. of Contacts:56; Series:MS27467; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Socket; Circular Shell Style:Straight Plug; Insert Arrangement:25-4 RoHS Compliant: No
UPD17202AGF-011-3BE Circular Connector; No. of Contacts:56; Series:MS27467; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Pin; Circular Shell Style:Straight Plug; Insert Arrangement:25-4 RoHS Compliant: No
UPD17203A 4-BIT SINGLE-CHIP MICROCONTROLLER WITH LARGE-CAPACITANCE STATIC RAM AND 3-CHANNEL TIMER FOR INFRARED REMOTE CONTROLLER
UPD17203AGC 4-BIT SINGLE-CHIP MICROCONTROLLER WITH LARGE-CAPACITANCE STATIC RAM AND 3-CHANNEL TIMER FOR INFRARED REMOTE CONTROLLER
UPD17227GT 4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER
相關代理商/技術參數
參數描述
UPD1720G 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Consumer IC
UPD17215 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER
UPD17215CT 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER
UPD17215GT 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER
UPD17216 制造商:NEC 制造商全稱:NEC 功能描述:4-BIT SINGLE-CHIP MICROCONTROLLER FOR SMALL GENERAL-PURPOSE INFRARED REMOTE CONTROL TRANSMITTER
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*