參數資料
型號: UDQ2547EB
廠商: Allegro MicroSystems, Inc.
英文描述: PROTECTED QUAD POWER DRIVERS
中文描述: 保護四功率驅動器
文件頁數: 4/8頁
文件大?。?/td> 76K
代理商: UDQ2547EB
2547
PROTECTED
QUAD POWER DRIVERS
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
CIRCUIT DESCRIPTION AND APPLICATION
These devices monitor their outputs for open or shorted conditions.
Both conditions are sensed by comparing the input and output states.
Note that the FAULT output is operational only if the ENABLE input is
high. When a fault condition is sensed, the FAULT output will go to a
low state. An external FAULT output filter capacitor (0.1
μ
F) is recom-
mended to eliminate erroneous switching.
INCANDESCENT LAMP DRIVER
High incandescent lamp turn-ON/in-rush currents can contribute to
poor lamp reliability and destroy semiconductor lamp drivers.
Warming (parallel) or current-limiting (series) resistors protect both
driver and lamp but use significant power either when the lamp is OFF
or when the lamp is ON, respectively. Lamps with steady-state current
ratings up to 600 mA can be driven without the need for warming or
current-limiting resistors, if lamp turn-ON time is not a concern.
When an incandescent lamp is initially turned ON, the cold filament
is at minimum resistance and would normally allow a 10x to 12x in-rush
current. With these drivers, during turn-ON, the high in-rush current is
sensed by the internal low-value sense resistor, drive current to the
output stage is diverted by the shunting transistor, the output stage
operates in a linear mode, and the load current is limited to approxi-
mately 1.3 A. During lamp warmup, the filament resistance increases
to its maximum value, the output driver goes into saturation and applies
maximum rated voltage to the lamp.
INDUCTIVE LOAD DRIVER
With the addition of external clamp diodes, bifilar (unipolar)
stepper motors and other inductive loads can be driven directly.
The external diodes prevent damage to the output transistors by
suppressing the high-voltage spikes that occur when turning
OFF an inductive load. For rapid current decay (fast turn-OFF speeds),
the use of Zener diodes will raise the flyback voltage and improve
performance. However, the peak voltage must not exceed the speci-
fied minimum sustaining voltage (V
SUPPLY
+ V
Z
+ V
F
V
OUT(SUS)
).
OVER-CURRENT CONDITIONS
In the event of a shorted load, or stalled motor, the load current
will attempt to increase. As described above, the drive current to the
affected output stage is linearly reduced (limiting the load current to
about 1.3 A), causing the output stage to go linear. As the junction
temperature of the output stage increases, the thermal shutdown circuit
will shut OFF the affected output. If the fault condition is corrected, the
output driver will return to its normal saturated condition.
NORMAL LAMP IN-RUSH CURRENT
TIME
Dwg. WP-005A
NOT TO SCALE
L
CURRENT LIMIT
THERMAL SHUTDOWN
THERMAL HYSTERESIS
SHORT CIRCUIT
相關PDF資料
PDF描述
UDQ5706A QUAD 2-INPUT PERIPHERAL/POWER DRIVER .TRANSIENT-PROTECTED OUTPUTS
UDR-500 500 Watts - 40 Volts, Pulsed Radar 400 - 450 MHz
UDS-2982H High temperature 8 A Triacs
UDN-2580ASERIES 8A SCRS
UDN-2585 4A SCRS
相關代理商/技術參數
參數描述
UDQ2549B 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:PROTECTED QUAD POWER DRIVER
UDQ2549EB 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:PROTECTED QUAD POWER DRIVER
UDQ2559B 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:PROTECTED QUAD POWER DRIVER
UDQ2559B-T 功能描述:IC POWER DRIVER PROT QUAD 16-DIP RoHS:是 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 內部開關 系列:- 標準包裝:1,000 系列:- 類型:高端/低端驅動器 輸入類型:SPI 輸出數:8 導通狀態電阻:850 毫歐,1.6 歐姆 電流 - 輸出 / 通道:205mA,410mA 電流 - 峰值輸出:500mA,1A 電源電壓:9 V ~ 16 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 供應商設備封裝:PG-DSO-20-45 包裝:帶卷 (TR)
UDQ2559EB 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:PROTECTED QUAD POWER DRIVER