參數資料
型號: UDN2987A
廠商: Allegro MicroSystems, Inc.
英文描述: 8-CHANNEL SOURCE DRIVER WITH OVER-CURRENT PROTECTION
中文描述: 8通道源驅動器,過電流保護
文件頁數: 4/8頁
文件大小: 84K
代理商: UDN2987A
2987
8-CHANNEL
SOURCE DRIVER
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
APPLICATIONS INFORMATION
AND CIRCUIT DESCRIPTION
As with all power integrated circuits, the UDN2987A
and UDN2987LW have a maximum allowable output
current rating. The 500 mA rating does not imply that
operation at that value is permitted or even obtainable.
The channel output current trip point is specified as -370
mA, minimum; therefore, attempted operation at current
levels greater than -370 mA may cause a fault indication
and channel shutdown. The device is tested at a maxi-
mum of -350 mA and that is the recommended maximum
output current per driver. It provides protection for current
overloads or shorted loads up to 35 V.
All outputs are enabled by pulling the OE/R input high.
When OE/R is low or allowed to float (internal pull-down),
all outputs are inhibited and the latches are reset. Note
that the RESET pulse duration (OE/R low) should be
at least 1
μ
s. This will ensure safe operation under
attempted RESET conditions with a shorted load. The
latches are also reset during power up, regardless of the
state of the OE/R input.
The load current causes a small voltage drop across
the internal low-value sense resistor. This voltage is
compared to the voltage drop across a reference resistor
with a constant current. The two resistors are matched to
eliminate errors due to manufacturing tolerances or
temperature effects. Each channel includes a comparator
and its own latch. An over-current fault (V
SENSE
> V
REF
)
will set the affected latch and shut down only that channel.
All other channels will continue to operate normally. The
latch includes a 1
μ
s delay (t
d
) to prevent unwanted
triggering due to crossover currents generated when
switching inductive loads. For an abrupt short circuit, the
delay and output switching times will allow a brief,
permissable current in excess of the trip current before the
output driver is turned OFF.
A common thermal shutdown disables all outputs
if the chip temperature exceeds +165
°
C. At thermal
shutdown, all latches are reset. The outputs are disabled
until the chip cools down to about +150
°
C (thermal
hysteresis).
A common open-collector FAULT output is used to
indicate any channel over-current condition or chip
thermal shutdown.
ALLOWABLE OUTPUT CURRENT
AS A FUNCTION OF DUTY CYCLE
(UDN2987A shown, multiply by 78% for UDN2987LW)
At +25
°
C
At +50
°
C
相關PDF資料
PDF描述
UDN2987LW 8-CHANNEL SOURCE DRIVER WITH OVER-CURRENT PROTECTION
UDN3625M POWERHALL SENSOR/DRIVERS FOR BRUSHLESS DC MOTORS
UDN3626M POWERHALL SENSOR/DRIVERS FOR BRUSHLESS DC MOTORS
UDN5703A QUAD 2-INPUT PERIPHERAL/POWER DRIVERS
UDN-5703A QUAD 2-INPUT PERIPHERAL/POWER DRIVERS
相關代理商/技術參數
參數描述
UDN-2987A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Octal Peripheral Driver
UDN2987A-6 制造商:Allegro MicroSystems 功能描述:LED DRVR 5V/9V/12V/15V/18V/24V 20-Pin PDIP
UDN2987A-6-T 功能描述:IC SOURCE DRIVER 8CHAN 20-DIP RoHS:是 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 內部開關 系列:- 標準包裝:1,000 系列:- 類型:高端/低端驅動器 輸入類型:SPI 輸出數:8 導通狀態電阻:850 毫歐,1.6 歐姆 電流 - 輸出 / 通道:205mA,410mA 電流 - 峰值輸出:500mA,1A 電源電壓:9 V ~ 16 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 供應商設備封裝:PG-DSO-20-45 包裝:帶卷 (TR)
UDN2987A-6-T 制造商:Allegro MicroSystems 功能描述:Source Driver IC
UDN2987LW 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:8-CHANNEL SOURCE DRIVER WITH OVER-CURRENT PROTECTION