
UCC5610
The power amplifier output stage allows the UCC5610 to
source full termination current and sink active negation
current when all termination lines are actively negated.
The UCC5610 is pin for pin compatible with Unitrode’s
other 18 line SCSI terminators, allowing lower capaci-
tance and lower voltage upgrades to existing systems.
The UCC5610, as with all Unitrode terminators, is com-
pletely hot pluggable and appears as high impedance at
the terminating channels with V
TRMPWR
= 0V or open.
Internal circuit trimming is utilized, first to trim the 110
ohm termination impedance to a 7% tolerance, and then
most importantly, to trim the output current to a 4% toler-
ance, as close to the max SCSI-3 spec as possible,
which maximizes noise margin in FAST-20 SCSI opera-
tion.
Other features include thermal shutdown and current
limit.
This device is offered in low thermal resistance versions
of the industry standard 28 pin wide body SOIC, 24 pin
wide body DIP and 28 pin PLCC.
ABSOLUTE MAXIMUM RATINGS
Termpwr Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +7V
Signal Line Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . 0V to +7V
Regulator Output Current . . . . . . . . . . . . . . . . . . Self-regulating
Storage Temperature . . . . . . . . . . . . . . . . . . .
65°C to +150°C
Operating Temperature . . . . . . . . . . . . . . . . .
55°C to +150°C
Lead Temperature (Soldering, 10 Sec.). . . . . . . . . . . . . +300°C
Unless otherwise specified all voltages are with respect to
Ground. Currents are positive into, negative out of the speci-
fied terminal.
Consult Packaging Section of Unitrode Integrated Circuits dat-
abook for thermal limitations and considerations of packages.
RECOMMENDED OPERATING CONDITIONS
Termpwr Voltage . . . . . . . . . . . . . . . . . . . . . . . . 2.75V to 5.25V
Signal Line Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . 0V to +5V
Disconnect Input Voltage . . . . . . . . . . . . . . . . . . 0V to Termpwr
Description Continued
CONNECTION DIAGRAMS
PLCC-28 (Top View)
QP Package
* QP package pins 12 - 18 serve as both heatsink and signal
ground.
* DWP package pin 28 serves as signal ground; pins 7, 8, 9,
20, 21, 22 serve as heatsink/ground.
SOIC-28 (Top View)
DWP Package
Note: Drawings are not to scale.
DIL-24 (Top View)
N or J Package
2
Powered by ICminer.com Electronic-Library Service CopyRight 2003