- 您現在的位置：買賣IC網 > PDF目錄380964 > UCC1583J Very low drop and low noise voltage regulator low ESR capacitors compatible, with inhibit function PDF資料下載
參數資料
| 型號： | UCC1583J |
| 英文描述： | Very low drop and low noise voltage regulator low ESR capacitors compatible, with inhibit function |
| 中文描述： | 電流模式開關電源控制器 |
| 文件頁數： | 5/10頁 |
| 文件大?。?/td> | 371K |
| 代理商： | UCC1583J |
5
UCC1580-1,-2,-3,-4
UCC2580-1,-2,-3,-4
UCC3580-1,-2,-3,-4
UVLO and Startup
For self biased off-line applications, -2 and -4 versions
(UVLO on and off thresholds of 15V and 8.5V typical)
are recommended. For all other applications, -1 and -3
versions provide the lower on threshold of 9V. The IC re-
quires a low startup current of only 160
μ
A when VDD is
under the UVLO threshold, enabling use of a large trickle
charge resistor (with corresponding low power dissipa-
tion) from the input voltage. VDD has an internal clamp
at 15V which can sink up to 10mA. Measures should be
taken not to exceed this current. For -2 and -4 versions,
this clamp must be activated as an indication of reaching
the UVLO on threshold. The internal reference (REF) is
brought up when the UVLO on threshold is crossed. The
startup logic ensures that LINE and REF are above and
SHTDWN is
below their respective thresholds before
outputs are asserted. LINE input is useful for monitoring
actual input voltage and shutting off the IC if it falls be-
low a programmed value. A resistive divider should be
used to connect the input voltage to the LINE input. This
feature can protect the power supply from excessive
currents at low line voltages.
Figure 1. Output time relationships.
APPLICATION INFORMATION
UDG-95070-2
Note: Waveforms are not to scale.
SS:
A capacitor from SS to ground programs the soft
start time. During soft start, EAOUT follows the amplitude
of SS’s slowly increasing waveform until regulation is
achieved.
VDD:
Chip power supply pin. VDD should be bypassed
to PGND. The –1 and –3 versions require VDD to ex-
ceed 9V to start and remain above 8.5V to continue run-
ning. A shunt clamp from VDD to GND limits the supply
voltage to 15V. The –2 and –4 versions do not start until
the shunt clamp threshold is reached and operation con-
tinues as long as VDD is greater than 8.5V.
PIN DESCRIPTIONS (cont.)
Powered by ICminer.com Electronic-Library Service CopyRight 2003
相關PDF資料 |
PDF描述 |
|---|---|
| UCC2583N | Very low drop voltage regulators with inhibit |
| UCC2583Q | Very low drop voltage regulators with inhibit |
| UCC2583QTR | Very low drop voltage regulators with inhibit |
| UCC28701D | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| UCC35701N | Precision 500 mA regulators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UCC160V10UF | 制造商:NCH 功能描述:RL150X610 10/160V/105 KME10x16 |
| UCC160V33UF | 制造商:United Chemi-Con 功能描述:AL160X633 CE02WF(M) SEE COMMENT |
| UCC16V100UF | 制造商:United Chemi-Con 功能描述:RL710X016 8X11.5 85C AMMO |
| UCC16V10UF | 制造商:United Chemi-Con 功能描述:RL610X016 +/-20% 105C |
| UCC1776 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Quad FET Driver |
發布緊急采購，3分鐘左右您將得到回復。