- 您現(xiàn)在的位置：買賣IC網 > PDF目錄379476 > UC3866L (Texas Instruments, Inc.) Resonant-Mode Power Supply Controllers PDF資料下載
參數資料
| 型號： | UC3866L |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | Resonant-Mode Power Supply Controllers |
| 中文描述： | 諧振模式電源控制器 |
| 文件頁數： | 4/9頁 |
| 文件大小： | 438K |
| 代理商： | UC3866L |
4
UC1861-1868
UC2861-2868
UC3861-3868
ELECTRICAL CHARACTERISTICS
Unless otherwise stated, all specifications apply for –55
°
C
≤
T
A
≤
125
°
C for the
UC186x, –25
°
C
≤
T
A
≤
85
°
C for the UC286x, and 0
°
C
≤
T
A
≤
70
°
C for the UC386x, V
CC
=12V, C
VCO
=1nF, Range=7.15k, R
MIN
=86.6k,
C=200pF, R=4.02k, and Csr=0.1
μ
F. T
A
=T
J .
PARAMETER
TEST CONDITIONS
UVLO
Vcc Turn-on Threshold
UCx861, UCx862, UCx865, UCx866
UCx863, UCx864, UCx867, UCx868
Vcc Turn-off Threshold
UCx861, UCx862, UCx865, UCx866
UCx863, UCx864, UCx867, UCx868
Icc Start
V
CC
= V
CC
(on) – 0.3V
Icc Run
V
ID
= 100mV
MIN
TYP
MAX
UNITS
15
7
9.5
6
16.5
8.0
10.5
7.0
150
25
18
9
11.5
8
300
32
V
V
V
V
μ
A
mA
Note 1: Currents are defined as positive into the pin.
Note 2: Pulse measurement techniques are used to insure that T
J
= T
A
.
Note 3: VID = V(NI) – V(INV).
Note 4: This parameter is not 100% tested in production but guaranteed by design.
Note 5: Vi = 0 to 4V tr(Vi)
10ns
tpd = t(Vo = 6V) – t(Vi = 3V)
UVLO & 5V GENERATOR (See Figure 1):
When power
is applied to the chip and Vcc is less than the upper
UVLO threshold, Icc will be less than 300
μ
A, the 5V gen-
erator will be off, and the outputs will be actively held low.
When Vcc exceeds the upper UVLO threshold, the 5V
generator turns on. Until the 5V pin exceeds 4.9V, the
outputs will still remain low.
The 5V pin should be bypassed to signal ground with a
0.1
μ
F capacitor. The capacitor should have low equiva-
lent series resistance and inductance.
FAULT AND SOFT-REFERENCE (See Figure 1):
The
Soft-Ref pin serves three functions: system reference, re-
start delay, and soft-start. Designed to source or sink
200
μ
A, this pin should be used as the input reference for
the error amplifier circuit. This pin requires a bypass ca-
pacitor of at least 0.1
μ
F. This yields a minimum soft-start
time of 1ms.
Under-Voltage Lockout sets both the fault and restart de-
lay latches.
This holds the outputs low and discharges
the Soft-Ref pin. After UVLO, the fault latch is reset by the
low voltage on the Soft-Ref pin. The reset fault latch re-
sets the delay latch and Soft-Ref charges via the 0.5mA
current source.
The fault pin is input to a high speed comparator with a
threshold of 3V. In the event of a detected fault, the fault
latch is set and the outputs are driven low. If Soft-Ref is
above 4V, the delay latch is set. Restart delay is timed as
Soft-Ref is discharged by 20
μ
A. When Soft-Ref is fully
discharged, the fault latch is reset if the fault input signal
is low. The Fault pin can be used as a system shutdown
pin.
If a fault is detected during soft-start, the fault latch is set
and the outputs are driven low. The delay latch will re-
main reset until Soft-Ref charges to 4V. This sets the de-
lay latch, and restart delay is timed.
delay for a single fault event is longer than for recurring
faults since Soft-Ref must be discharged from 5V instead
of 4V.
Note that restart
The restart delay to soft-start time ratio is 24:1 for a fault
occurring during normal operation and 19:1 for faults oc-
curring during soft-start. Shorter ratios can be pro-
grammed down to a limit of approximately 3:1 by the
addition of a 20k
or larger resistor from Soft-Ref to
ground.
A 100k
resistor from Soft-Ref to 5V will have the effect
of permanent shut down after a fault since the internal
20
μ
A current source can't pull Soft-Ref low. This feature
can be used to require recycling Vcc after a fault. Care
must be taken to insure Soft-Ref is indeed low at start up,
or the fault latch will never be reset.
APPLICATION INFORMATION
相關PDF資料 |
PDF描述 |
|---|---|
| UC3866LTR | Resonant-Mode Power Supply Controllers |
| UC3866NTR | Resonant-Mode Power Supply Controllers |
| UC3866QTR | Resonant-Mode Power Supply Controllers |
| UC3867J | Resonant-Mode Power Supply Controllers |
| UC3867JTR | Resonant-Mode Power Supply Controllers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UC3866N | 功能描述:電壓模式 PWM 控制器 Resonant-Mode RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| UC3866NG4 | 功能描述:電壓模式 PWM 控制器 Resonant-Mode RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| UC3867DW | 功能描述:電壓模式 PWM 控制器 Resonant-Mode RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| UC3867DWG4 | 功能描述:電壓模式 PWM 控制器 Resonant-Mode RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
| UC3867DWTR | 功能描述:電壓模式 PWM 控制器 Resonant-Mode RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel |
發(fā)布緊急采購，3分鐘左右您將得到回復。