- 您現在的位置：買賣IC網 > PDF目錄380957 > UC2543DWTR Voltage Detector PDF資料下載
參數資料
| 型號： | UC2543DWTR |
| 英文描述： | Voltage Detector |
| 中文描述： | 電壓檢測器 |
| 文件頁數： | 1/6頁 |
| 文件大?。?/td> | 480K |
| 代理商： | UC2543DWTR |
Power Supply Supervisory Circuit
Includes Over-voltage,
Under-voltage, And Current
Sensing Circuits
Internal 1% Accurate
Reference
Programmable Time Delays
SCR “Crowbar” Drive Of
300mA
Remote Activation Capability
Optional Over-voltage Latch
Uncommitted Comparator
Inputs For Low Voltage
Sensing (UC1544 Series
Only)
The monolithic integrated circuits contain all the functions necessary to monitor
and control the output of a sophisticated power supply system. Over-voltage (O.V.)
sensing with provision to trigger an external SCR “crowbar” shutdown; an under-
voltage (U.V.) circuit which can be used to monitor either the output or to sample
the input line voltage; and a third op amp/comparator usable for current sensing
(C.L.) are all included in this IC, together with an independent, accurate reference
generator.
Both over- and under-voltage sensing circuits can be externally programmed for
minimum time duration of fault before triggering. All functions contain open collec-
tor outputs which can be used independently or wire-or’ed together, and although
the SCR trigger is directly connected only to the over-voltage sensing circuit, it
may be optionally activated by any of the other outputs, or from an external signal.
The O.V. circuit also includes an optional latch and external reset capability.
The UC1544/2544/3544 devices have the added versatility of completely uncom-
mitted inputs to the voltage sensing comparators so that levels less than 2.5V may
be monitored by dividing down the internal reference voltage. The current sense
circuit may be used with external compensation as a linear amplifier or as a high-
gain comparator. Although nominally set for zero input offset, a fixed threshold may
be added with an external resistor. Instead of current limiting, this circuit may also
be used as an additional voltage monitor.
The reference generator circuit is internally trimmed to eliminate the need for ex-
ternal potentiometers and the entire circuit may be powered directly from either the
output being monitored or from a separate bias voltage.
BLOCK DIAGRAM
Note: For each terminal, first number refers to 1543 series, second to 1544 series.
* On 1543 series, this function is internally connected to V
REF
4/97
UC1543 UC1544
UC2543 UC2544
UC3543 UC3544
DESCRIPTION
FEATURES
Powered by ICminer.com Electronic-Library Service CopyRight 2003
相關PDF資料 |
PDF描述 |
|---|---|
| UC2543J | 5V, 500mA low drop voltage regulator |
| UC2543L | 5V, 500mA low drop voltage regulator |
| UC2543N | 5V, 500mA low drop voltage regulator |
| UC2543Q | 5V, 500mA low drop voltage regulator |
| UC2543QTR | 5V, 500mA low drop voltage regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| UC2543DWTRG4 | 制造商:Texas Instruments 功能描述:VOLT SUPERVISOR MONITOR 2.5V 16SOIC - Tape and Reel |
| UC2543J | 制造商:Rochester Electronics LLC 功能描述:PWR SUPPLY SUPERVISORY CIRCUIT - Bulk 制造商:Texas Instruments 功能描述: |
| UC2543L | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage Detector |
| UC2543N | 功能描述:監控電路 Power Supply Supervisory Circuit RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| UC2543NG4 | 功能描述:監控電路 Power Supply Supervisory Circuit RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。