
INSTALLATION:
SPECIFICATIONS:
APPLICATION:
This information is subject to change without formal notice. If you need additional help, A&J Washroom accessories, Inc. has a technical support staff that is ready to assist you at Fax (845) 562-3391,
email: quoting@ajwashroom.com or visit our web at http://www.ajwashroom.com
Copyright 2000 A&J Washroom Accessories, Inc.
Fo m U840A/ 000
r :
2
Body:
Fabricated of type 304 #22 ga stainless steel with #4
satin finish. Concealed inner dispensing mechanism is type
304 #18 ga stainless steel.
Back:
Fabricated of type 304 #18 ga stainless steel with
multiple welds to cabinet body forming a one piece
construction.
Hood:
Fabricated of type 304 #18 ga stainless steel finished to
match cabinet body. Hood is secured with stainless steel hinge
rivets to cabinet body. Top roll of tissue will not drop down
unless the bottom roll has been depleted. When unit is closed,
this will provide a theft resistant, non-control operation and
reduce vandalism.
Locks:
Pin tumbler, commercial quality locks keyed like all
other A & J cabinets.
Spindles:
(U005A) Fabricated of one-piece molded high
impact black ABS material.
Recommend:
Type CP801,CP802, CP807, CP808 or CP809
toilet tissue.
Overall Size:
6”W x 12”H x 6 3/4”D
152mm x 305mm x 171mm
Capacity:
2 Standard size rolls up to 5 3/4” diameter.
*
Sheet capacity may vary from roll to roll depending on the
manufacturer and sheet style selected.
Provide an area on mounting surface at desired or specified
location. Open cabinet, remove spindles and hold unit to wall
at desired location. Transfer mounting points and drill pilot
holes. Secure unit with proper fasteners per each application.
Load toilet tissue on rollers, place in concealed track and
close hood. Raise lower roll against upper and take hand
away. Lower roll should fall into place with upper roll
remaining up above the hood line. If loaded properly, top roll
will not fall for use until bottom roll has been depleted. When
servicing dispenser, full rolls must be used on both spindles to
insure proper operation.
All toilet tissue dispensers that meet ADA code cannot have
any type of control delivery. (4.16)
To provide a surface mounted stainless steel, hooded, dual roll
toilet tissue dispenser that has a non-control delivery. When
mounted properly, unit will comply with ADA Code 4.16.
6”
152mm
12”
305 mm
6 3/4”
171mm
2
9
3
m
)
RECOMMEND
MOUNTINGHEG
ED
HT
S
S
(28” (711mm) FOR PHYSICALLY IMPAIRED)
Two
Spindles
Architectural
Janitorial Washroom Accessories
&
R
INC.
Accessories
Washroom
U840A
TOILET TISSUE DISPENSER
QTY:
JOB #:
Item: