- 您現在的位置：買賣IC網 > PDF目錄373740 > TSM006IDT (意法半導體) Primary PWM Controller PDF資料下載
參數資料
| 型號： | TSM006IDT |
| 廠商： | 意法半導體 |
| 英文描述： | Primary PWM Controller |
| 中文描述： | 小學PWM控制器 |
| 文件頁數： | 6/13頁 |
| 文件大?。?/td> | 179K |
| 代理商： | TSM006IDT |
TSM006
Functional Description
6/13
4 Functional Description
TSM006: PWM Controller IC.
UVLO function
The Under Voltage Lock Out function disables the
whole device when supply voltage is lower than
the threshold.
Vref block
The Vref block provides a 5V reference voltage.
An internal Vref status signal is active when Vref
is lower than 4.7V and is used to drive the output
driver low when Vref is not valid.
Current sense input
A voltage proportional to the output inductor
current is applied to the CS pin. The control IC
uses this information to perform current mode
control. The PWM function will be stopped if the
CS pin voltage is greater than 1.0V.
Current leading edge blanking
An internal delay is built into the IC to mask the
first 100ns of the current sense signal. This delay
is made of a capacitor charged with a current
source. The capacitor is discharged when CT
reaches its maximum level.
COMP input
This pin is connected to the current comparator
for current mode control. The pin should be
connected to the collector (primary side) of an
optocoupler which anode (secondary side) is
driven by the output of error amplifier.
The COMP input is used to set the reference level
for the current sense comparator. The current
sense threshold is set to (Vcomp - 2 * Vbe) / 3.
During the soft start period, COMP voltage is
clamped to the SS pin plus two Vbe voltage.
Startup latch
The startup latch is set when the IC exits from
standby mode or UVLO state. It is reset when the
CT capacitor is discharged for the first time.
Output driver
The OUT totem pole output is capable to sink and
source more than 1.0A (peak) in order to direct
drive a power MOSFET.
Oscillator
A capacitor from the RT/CT pin to GND and a
resistor to the VREF set the oscillating frequency.
The maximum duty cycle at the OUT pin is limited
at 77%.
Frequency modulation
A FM generator adds a small amount of jitter on
the oscillator frequency in a way that reduces the
conducted and radiated EMI. The FM frequency is
set by an external capacitor connected to the FM
pin.
Slope compensation
A buffered Rt/Ct voltage is brought to the
Cslope pin. This signal is used to provide the
necessary slope compensation.
Soft start
A capacitor from the SS pin to GND provides the
soft start function. The capacitor starts to charge
when VIN reaches the UVLO threshold and Vref is
good.
The soft start block enables the IC to start with a
progressive PWM duty cycle. The soft start
comparator drives the output driver low when the
SS pin voltage is greater than the CT pin voltage
minus one Vbe voltage.
During soft start, the COMP pin voltage is
clamped to the SS pin voltage plus two Vbe
voltage, limiting the maximum peak current.
External reference pin
An external resistor at REX pin sets the internal
current reference.
相關PDF資料 |
PDF描述 |
|---|---|
| TSM100 | SINGLE OPERATIONAL AMPLIFIER AND SINGLE COMPARATOR |
| TSM100I | SINGLE OPERATIONAL AMPLIFIER AND SINGLE COMPARATOR |
| TSM100ID | SINGLE OPERATIONAL AMPLIFIER AND SINGLE COMPARATOR |
| TSM1011 | Constant Voltage and Constant Current Controller for Battery Chargers and Adapters |
| TSM1011AID | Constant Voltage and Constant Current Controller for Battery Chargers and Adapters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSM007 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Primary PWM Controller |
| TSM007ID | 功能描述:IC REG CTRLR ISO PWM CM 8-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| TSM007IDT | 功能描述:電流型 PWM 控制器 Primary Standard RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| TSM007IN | 功能描述:電流型 PWM 控制器 Primary Standard RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| TSM-008-20 | 制造商:Power Dynamics Inc 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。