- 您現在的位置：買賣IC網 > PDF目錄372460 > TSL208R (Electronic Theatre Controls, Inc.) 512 X 1 LINEAR SENSOR ARRAY PDF資料下載
參數資料
| 型號： | TSL208R |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 512 X 1 LINEAR SENSOR ARRAY |
| 中文描述： | 512 × 1傳感器陣列線性 |
| 文件頁數： | 2/8頁 |
| 文件大?。?/td> | 102K |
| 代理商： | TSL208R |
TSL208R
512 1 LINEAR SENSOR ARRAY
TAOS031C – OCTOBER 2002
2
Copyright 2002, TAOS Inc.
The LUMENOLOGY Company
www.taosinc.com
Terminal Functions
TERMINAL
NAME
I/O
DESCRIPTION
NO.
AO
4
O
Analog output.
CLK
3
I
Clock. The clock controls the charge transfer, pixel output and reset.
GND
5
I
Ground (substrate). All voltages are referenced to the substrate.
SI
2
I
Serial input. SI defines the start of the data out sequence.
SO
6
O
Serial output. SO signals the end of the data out sequence.
VDD
1, 7
I
Supply voltage for both analog and digital circuits.
Detailed Description
The sensor consists of 512 photodiodes arranged in a linear array. Light energy impinging on a photodiode
generates photocurrent, which is integrated by the active integration circuitry associated with that pixel. During
the integration period, a sampling capacitor connects to the output of the integrator through an analog switch.
The amount of charge accumulated at each pixel is directly proportional to the light intensity and the integration
time. The integration time is the interval between two consecutive output periods.
The output and reset of the integrators is controlled by a 512-bit shift register and reset logic. An output cycle
is initiated by clocking in a logic 1 on SI for one positive going clock edge (see Figures1 and 2)
. As the SI pulse
is clocked through the 512-bit shift register, the charge on the sampling capacitor of each pixel is sequentially
connected to a charge-coupled output amplifier that generates a voltage output, AO. When the bit position goes
low, the pixel integrator is reset. On the 513th clock rising edge, the SI pulse is clocked out of the shift register
and the output assumes a high-impedance state. Note that this 513th clock pulse is required to terminate the
output of the 512th pixel and return the internal logic to a known state. A subsequent SI pulse can be presented
as early as the 514th clock pulse, thereby initiating another pixel output cycle.
The voltage developed at analog output (AO) is given by:
V
out
= V
drk
+ (R
e
) (E
e
) (t
int
)
where:
V
out
V
drk
R
e
E
e
t
int
is the analog output voltage for white condition
is the analog output voltage for dark condition
is the device responsivity for a given wavelength of light given in V/(
μ
J/cm
2
)
is the incident irradiance in
μ
W/cm
2
is integration time in seconds
AO is driven by a source follower with an internal 330-
pulldown resistor (no external resistor is required). The
output is nominally 0 V for no light input, 2 V for normal white-level, and 3.4 V for saturation light level. When
the device is not in the output phase, AO is in a high impedance state.
A 0.1
μ
F bypass capacitor should be connected between V
DD
and ground as close as possible to the device.
For proper operation, after meeting the minimum hold time condition, SI must go low before the next rising edge of the clock.
相關PDF資料 |
PDF描述 |
|---|---|
| TSL265 | Optoelectronic |
| TSM-102-04-L-DH-A | TERMINAL STRIPS |
| TSM-135-01-L-DV-XX | TERMINAL STRIPS |
| TSM-135-01-L-SH-A | TERMINAL STRIPS |
| TSM-135-01-L-SH-P | TERMINAL STRIPS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSL210 | 功能描述:光頻率和光電壓 Linear Array 200 DPI RoHS:否 制造商:ams 峰值波長:1000 nm 工作電源電壓:5 V 最大工作溫度:+ 85 C 最小工作溫度:- 25 C 安裝風格: 封裝 / 箱體: |
| TSL213 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TSL213A | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TSL214 | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| TSL215 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:128 】 1 INTEGRATED OPTO SENSOR |
發布緊急采購，3分鐘左右您將得到回復。