- 您現在的位置：買賣IC網 > PDF目錄98302 > TSC2100IDA (TEXAS INSTRUMENTS INC) SPECIALTY CONSUMER CIRCUIT, PDSO32 PDF資料下載
參數資料
| 型號： | TSC2100IDA |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PDSO32 |
| 封裝： | GREEN, PLASTIC, TSSOP-32 |
| 文件頁數： | 20/77頁 |
| 文件大小： | 1079K |
| 代理商： | TSC2100IDA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁
TSC2100
SLAS378 NOVEMBER 2003
www.ti.com
27
AUDIO DATA CONVERTERS
The TSC2100 includes a stereo audio DAC and a mono audio ADC. Both ADC and DAC can operate with a maximum
sampling rate of 53 kHz and support all audio standard rates of 8 kHz, 11.025 kHz, 12kHz, 16kHz, 22.05 kHz, 24 kHz,
32kHz, 44.1 kHz, and 48 kHz. By utilizing the flexible clock generation capability and internal programmable interpolation,
a wide variety of sampling rates up to 53 kHz can be obtained from many possible MCLK inputs. In addition, the DAC and
ADC can independently operate at different sampling rates as indicated in control register REG00H/Page2.
When the ADC or DAC is operating, the TSC2100 requires an applied audio MCLK input. The user should also set
BITD13/REG06H/Page2 to indicate which Fsref rate is being used. If the codec ADC or DAC is powered up, then the
touch screen ADC uses MCLK and BCLK for its internal clocking, and the internal oscillator is powered down to save power.
Typical audio DACs can suffer from poor out-of-band noise performance when operated at low sampling rates, such as
8 kHz or 11.025 kHz. The TSC2100 includes programmable interpolation circuitry to provide improved audio performance
at such low sampling rates, by first upsampling low-rate data to a higher rate, filtering to reduce audible images, and then
passing the data to the internal DAC, which is actually operating at the Fsref rate. This programmable interpolation is
determined using BITD5D3/REG00H/Page2.
For example, if playback of 11.025-kHz data is required, the TSC2100 can be configured such that Fsref = 44.1 kHz. Then
using BITD5D3/REG00H/Page2, the DAC sampling rate (Fs) can be set to Fsref/4, or Fs = 11.025 kHz. In operation,
the 11.025-kHz digital input data is received by the TSC2100, upsampled to 44.1 kHz, and filtered for images. It is then
provided to the audio DAC operating at 44.1 kHz for playback. In reality, the audio DAC further upsamples the 44.1 kHz
data by a ratio of 128 x and performs extensive interpolation filtering and processing on this data before conversion to a
stereo analog output signal.
PLL
The TSC2100 has an on-chip PLL to generate the needed internal ADC and DAC operational clocks from a wide variety
of clocks available in the system. The PLL supports an MCLK varying from 2 MHz to 50 MHz and is register programmable
to enable generation of required sampling rates with fine precision.
ADC and DAC sampling rates are given by
DAC_FS = Fsref/N1 and ADC_FS = Fsref/N2
where, Fsref must fall between 39 kHz and 53 kHz, and N1, N2 =1, 1.5, 2, 3, 4, 5, 5.5, 6 are register programmable.
The PLL can be enabled or disabled using register programming.
D When PLL is disabled
Fsref + MCLK
128
Q
Q = 2, 3…17
Note: For ADC, with N2 = 1.5 or 5.5, odd values of Q are not allowed.
In this mode, the MCLK can operate up to 50 MHz, and Fsref should fall within 32 kHz to 53 kHz.
D When PLL is enabled
Fsref + MCLK
K
2048
P
P = 1, 2, 3, …, 8
K = J.D
J = 1, 2, 3, ….,64
D = 0, 1, 2, …, 9999
P, J, and D are register programmable, where J is integer part of K before the decimal point, and D is four-digit fractional
part of K after the decimal point, including lagging zeros.
Examples:
If K = 8.5, Then J = 8, D = 5000
If K = 7.12, Then J = 7, D = 1200
If K = 7.012, Then J = 7, D = 120
The PLL is programmed through Registers 1BH and 1CH of Page2.
相關PDF資料 |
PDF描述 |
|---|---|
| TSC2100IRHBR | SPECIALTY CONSUMER CIRCUIT, PQCC32 |
| TSC2100IRHB | SPECIALTY CONSUMER CIRCUIT, PQCC32 |
| TSC2100IDAG4 | SPECIALTY CONSUMER CIRCUIT, PDSO32 |
| TSC2100IRHBG4 | SPECIALTY CONSUMER CIRCUIT, PQCC32 |
| TSC2100IRHBRG4 | SPECIALTY CONSUMER CIRCUIT, PQCC32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSC2100IDAG4 | 功能描述:觸摸屏轉換器和控制器 Prog 4-Wire w/Ster Codec & Hdph/Spk Amp RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC2100IDAR | 功能描述:觸摸屏轉換器和控制器 Prog 4-Wire w/Ster Codec & Hdph/Spk Amp RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC2100IDARG4 | 功能描述:觸摸屏轉換器和控制器 Prog 4-Wire w/Ster Codec & Hdph/Spk Amp RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC2100IRHB | 功能描述:觸摸屏轉換器和控制器 Prog 4-Wire w/Ster Codec & Hdph/Spk Amp RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC2100IRHBG4 | 功能描述:觸摸屏轉換器和控制器 Prog 4-Wire w/Ster Codec & Hdph/Spk Amp RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
發布緊急采購，3分鐘左右您將得到回復。