- 您現在的位置：買賣IC網 > PDF目錄98301 > TSC2008IYZGT (TEXAS INSTRUMENTS INC) SPECIALTY CONSUMER CIRCUIT, BGA12 PDF資料下載
參數資料
| 型號： | TSC2008IYZGT |
| 廠商： | TEXAS INSTRUMENTS INC |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, BGA12 |
| 封裝： | 2 X 1.50 MM, GREEN, DSBGA-12 |
| 文件頁數： | 19/40頁 |
| 文件大?。?/td> | 1028K |
| 代理商： | TSC2008IYZGT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
POWER DISSIPATION
0
2
4
6
8
10
12
14
SampleOutputRate(kHz)
400
350
300
250
200
150
100
50
0
SupplyCurrent(
A)
m
12-BitAUXConversionwithMAV
SCLK=16MHz
VDD=1.8V
T =+25 C
A
°
0
10
20
30
40
50
60
70
80
90
SampleOutputRate(kHz)
400
350
300
250
200
150
100
50
0
SupplyCurrent(
A)
m
12-BitAUXConversionwithoutMAV
SCLK=16MHz
VDD=1.8V
T =+25 C
A
°
THROUGHPUT RATE AND SPI BUS TRAFFIC
SBAS406B – JUNE 2008 – REVISED MARCH 2009.......................................................................................................................................................... www.ti.com
There are two major power modes for the TSC2008: full-power (PD0 = '1') and auto power-down (PD0 = '0').
Unlike its predecessor, the TSC2046/2046E (where operation is synchronous to SCLK and therefore power
depends on the SCLK frequency), the TSC2008 uses an internal clock for conversion and is asynchronous to
SCLK. TSC2008 power consumption depends on the sample rate and is minimally affected by the SCLK
frequency. Figure 30 shows a timing example using 12-bit resolution and 24 SCLKs per cycle. There are
approximately 2.5 SCLKs of acquisition time used at the end of the 8-bit command cycle. When the
preprocessing filter is on, the next six acquisition cycles are controlled by the internal conversion clock instead of
relying on the external SCLK. A conversion time follows each acquisition time. Because there are six more
conversions to be completed, and also because of the power used from preprocessing, the power consumption
when the filter is on is higher than the power consumed without the filter at the same output rate, as shown in
Figure 34. This timing sequence also applies to Figure 31 to Figure 33. Thus, using the TSC2008, power
consumption can be very low, even with a low SCLK frequency.
Figure 34. Sample Output Rate vs Supply Current (with and without MAV filter)
Another important consideration for power dissipation is the reference mode of the converter. In the single-ended
reference mode, the touch panel drivers are on only when the analog input voltage is being acquired (see
Figure 30 and Table 4). The external device (for example, a resistive touch screen), therefore, is only powered
during the acquisition period. In the differential reference mode, the external device must be powered throughout
the acquisition and conversion periods (see Figure 30). If the conversion rate is high, using this mode could
substantially increase power dissipation.
Although the internal A/D converter has a sample rate of up to 200kSPS, the throughput presented at the bus is
much lower. The rate is reduced because preprocessing manages the redundant work of filtering out noise. The
throughput is further limited by the SPI bus bandwidth, which is determined by the supply voltage and what the
host processor can support. The effective throughput is approximately 20kSPS at 8-bit resolution, or 10kSPS at
12-bit resolution. The preprocessing saves a large portion of the SPI bandwidth for the system to use on other
devices.
Each sample and conversion takes 19 CCLK cycles (12-bit), or 16 CCLK cycles (8-bit). The TSC2008 contains
an internal clock that drives the state machines that perform the many functions of the device. This clock is
divided down to provide a clock that runs the A/D converter. The 8-bit ADC mode uses a 4MHz clock and the
12-bit ADC mode uses a 2MHz clock. The actual frequency of this internal clock is slower than the name
suggests, and varies with the supply voltage. For a typical internal 4MHz OSC clock, the frequency actually
ranges from 3.66MHz to 3.82MHz. For VDD = 1.2V, the frequency reduces to 3.19MHz, which gives a
3.19MHz/16 = 199kSPS raw A/D converter sample rate.
26
Copyright 2008–2009, Texas Instruments Incorporated
Product Folder Link(s): TSC2008
相關PDF資料 |
PDF描述 |
|---|---|
| TSC2008TRGVRQ1 | SPECIALTY CONSUMER CIRCUIT, PQCC16 |
| TSC2046EIPWG4 | SPECIALTY CONSUMER CIRCUIT, PDSO16 |
| TSC2046IGQCR | SPECIALTY CONSUMER CIRCUIT, PBGA48 |
| TSC2046IPWR | SPECIALTY CONSUMER CIRCUIT, PDSO16 |
| TSC2046IPW | SPECIALTY CONSUMER CIRCUIT, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSC2008-Q1 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.2V to 3.6V, 12-Bit, Nanopower, 4-Wire Micro TOUCH SCREEN CONTROLLER with SPIa?￠ |
| TSC2008RGVR | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.2V to 3.6V, 12-Bit, Nanopower, 4-Wire Micro TOUCH SCREEN CONTROLLER with SPI? |
| TSC2008RGVT | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1.2V to 3.6V, 12-Bit, Nanopower, 4-Wire Micro TOUCH SCREEN CONTROLLER with SPI⑩ |
| TSC2008TRGVRQ1 | 功能描述:觸摸屏轉換器和控制器 AC Nano-Pwr Touch Screen Controller RoHS:否 制造商:Microchip Technology 類型:Resistive Touch Controllers 輸入類型:3 Key 數據速率:140 SPS 分辨率:10 bit 接口類型:4-Wire, 5-Wire, 8-Wire, I2C, SPI 電源電壓:2.5 V to 5.25 V 電源電流:17 mA 工作溫度:- 40 C to + 85 C 封裝 / 箱體:SSOP-20 |
| TSC2011 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:Nanopower, 4-Wire Resistive Touch and Haptic Controller with I2Ca?￠ Serial Interface |
發布緊急采購，3分鐘左右您將得到回復。