參數資料
型號: TSA1001
廠商: 意法半導體
英文描述: 10-BIT, 25MSPS, 35mW A/D CONVERTER
中文描述: 10位,25Msps時為35mW的A / D轉換器
文件頁數: 13/19頁
文件大?。?/td> 165K
代理商: TSA1001
13/19
TSA1001 APPLICATION NOTE
DETAILED INFORMATION
The TSA1001 is a High Speed analog to digital
converter based on a pipeline architecture and the
latest deep submicron CMOS process to achieve
the best performances in terms of linearity and
power consumption.
The pipeline structure consists of 9 internal con-
version stages in which the analog signal is fed
and sequencially converted into digital data.
Each 8 first stages consists of an Analog to Digital
converter, a Digital to Analog converter, a Sample
and Hold and a gain of 2 amplifier. A 1.5bit conver-
sion resolution is achieved in each stage. The lat-
est stage simply is a comparator. Each resulting
LSB-MSB couple is then time shifted to recover
from the conversion delay. Digital data correction
completes the processing by recovering from the
redundancy of the (LSB-MSB) couple for each
OPERATIONAL MODES DESCRIPTION
stage. The corrected data are outputed through
the digital buffers.
Signal input is sampled on the rising edge of the
clock while digital outputs are delivered on the fall-
ing edge of the Data Ready signal.
The advantages of such a converter reside in the
combination of pipeline architecture and the most
advanced technologies. The highest dynamic per-
formances are achieved while consumption re-
mains at the lowest level.
Some functionalities have been added in order to
simplify as much as possible the application
board. These operational modes are described in
the following table.
The TSA1001 is pin to pin compatible with the
8bits/40Msps
TSA0801,
TSA1002 and the 12bits/50Msps TSA1201. This
ensures a conformity within the product family and
above all, an easy upgrade of the application.
the
10bits/50Msps
Data Format Select (DFSB)
When set to low level (VIL), the digital input DFSB
provides a two’s complement digital output MSB.
This can be of interest when performing some fur-
ther signal processing.
When set to high level (VIH), DFSB provides a
standard binary output coding.
Output Enable (OEB)
When set to low level (VIL), all digital outputs re-
main active and are in low impedance state.
When set to high level (VIH), all digital outputs
buffers are in high impedance state. This results in
lower consumption while the converter goes on
sampling.
When OEB is set to low level again, , the data is
then valid on the output with a very short Ton de-
lay.
The timing diagram summarizes this operating cy-
cle.
Out of Range (OR)
This function is implemented on the output stage
in order to set up an "Out of Range" flag whenever
the digital data are over the full scale range.
Typically, there is a detection of all the data being
at ’0’ or all the data being at ’1’. This ends up with
an output signal OR which is in low level state
Inputs
Outputs
Analog input differential level
(VIN-VINB)
-RANGE
RANGE> (VIN-VINB) >-RANGE
(VIN-VINB)
>
-RANGE
>
RANGE> (VIN-VINB) >-RANGE
X
DFSB
H
H
H
L
L
L
X
OEB
L
L
L
L
L
L
H
OR
H
H
L
H
H
L
HZ
DR
CLK
CLK
CLK
CLK
CLK
CLK
HZ
Most Significant Bit (MSB)
D9
D9
D9
Complemented D9
Complemented D9
Complemented D9
HZ
>
>
RANGE
(VIN-VINB)
RANGE
(VIN-VINB)
相關PDF資料
PDF描述
TSA1001CF 10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1001CFT 10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1001IF 10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1002 10-BIT, 50MSPS, 50mW A/D CONVERTER
TSA1002CF 10-BIT, 50MSPS, 50mW A/D CONVERTER
相關代理商/技術參數
參數描述
TSA1001CF 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1001CFT 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1001IF 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1001IFT 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 25MSPS, 35mW A/D CONVERTER
TSA1002 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:10-BIT, 50MSPS, 50mW A/D CONVERTER