參數資料
型號: TS87C51RB2-VLEB
廠商: ATMEL CORP
元件分類: 微控制器/微處理器
英文描述: 8-BIT, OTPROM, 40 MHz, MICROCONTROLLER, PQFP44
封裝: 1.40 MM HEIGHT, VQFP-44
文件頁數: 6/83頁
文件大?。?/td> 8336K
代理商: TS87C51RB2-VLEB
14
8021G–AVR–03/11
ATmega329P/3290P
6.5.1
The X-register, Y-register, and Z-register
The registers R26...R31 have some added functions to their general purpose usage. These reg-
isters are 16-bit address pointers for indirect addressing of the data space. The three indirect
address registers X, Y, and Z are defined as described in Figure 6-3.
Figure 6-3.
The X-, Y-, and Z-registers
In the different addressing modes these address registers have functions as fixed displacement,
automatic increment, and automatic decrement (see the instruction set reference for details).
6.6
Stack Pointer
The Stack is mainly used for storing temporary data, for storing local variables and for storing
return addresses after interrupts and subroutine calls. Note that the Stack is implemented as
growing from higher to lower memory locations. The Stack Pointer Register always points to the
top of the Stack. The Stack Pointer points to the data SRAM Stack area where the Subroutine
and Interrupt Stacks are located. A Stack PUSH command will decrease the Stack Pointer.
The Stack in the data SRAM must be defined by the program before any subroutine calls are
executed or interrupts are enabled. Initial Stack Pointer value equals the last address of the
internal SRAM and the Stack Pointer must be set to point above start of the SRAM, see Figure
See Table 6-1 for Stack Pointer details.
The AVR Stack Pointer is implemented as two 8-bit registers in the I/O space. The number of
bits actually used is implementation dependent. Note that the data space in some implementa-
tions of the AVR architecture is so small that only SPL is needed. In this case, the SPH Register
will not be present.
15
XH
XL
0
X-register
70
7
0
R27 (0x1B)
R26 (0x1A)
15
YH
YL
0
Y-register
70
7
0
R29 (0x1D)
R28 (0x1C)
15
ZH
ZL
0
Z-register
70
7
0
R31 (0x1F)
R30 (0x1E)
Table 6-1.
Stack Pointer instructions
Instruction
Stack pointer
Description
PUSH
Decremented by 1
Data is pushed onto the stack
CALL
ICALL
RCALL
Decremented by 2
Return address is pushed onto the stack with a subroutine call or
interrupt
POP
Incremented by 1
Data is popped from the stack
RET
RETI
Incremented by 2
Return address is popped from the stack with return from
subroutine or return from interrupt
相關PDF資料
PDF描述
TS80C52X2-LLCB 8-BIT, MROM, 30 MHz, MICROCONTROLLER, PQFP44
TS80C51RA2-VLBB 8-BIT, 40 MHz, MICROCONTROLLER, PQCC44
TS87C52X2-VLEB 8-BIT, OTPROM, 40 MHz, MICROCONTROLLER, PQFP44
TS87C54X2-VLBB 8-BIT, OTPROM, 40 MHz, MICROCONTROLLER, PQCC44
TSC80C31-12KA 8-BIT, 12 MHz, MICROCONTROLLER, PDIP40
相關代理商/技術參數
參數描述
TS87C51RC-1 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
TS87C51RC2 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:High Performance 8-bit Microcontrollers
TS87C51RC24 功能描述:IC MCU 8BIT 32K 24MHZ OTP 44MQFP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:87C 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:260 系列:73S12xx 核心處理器:80515 芯體尺寸:8-位 速度:24MHz 連通性:I²C,智能卡,UART/USART,USB 外圍設備:LED,POR,WDT 輸入/輸出數:9 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:2K x 8 電壓 - 電源 (Vcc/Vdd):2.7 V ~ 5.5 V 數據轉換器:- 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:68-VFQFN 裸露焊盤 包裝:管件
TS87C51RC-24 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-Bit Microcontroller
TS87C51RC2-EAD 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microcontroller