- 您現在的位置：買賣IC網 > PDF目錄373700 > TS29150 (Electronic Theatre Controls, Inc.) 5.0 AMP POSITIVE VOLTAGE REGULATOR PDF資料下載
參數資料
| 型號： | TS29150 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| 中文描述： | 5.0放大器正電壓穩壓器 |
| 文件頁數： | 3/5頁 |
| 文件大?。?/td> | 124K |
| 代理商： | TS29150 |
TS29150
3-5
2003/12 rev. A
Application Information
The TS29150 series are high performance with low
dropout voltage regulator suitable for moderate to high
current and voltage regulator application. Its 350mA(typ)
dropout voltage at full load and over temperature makes
it especially valuable in battery power systems and as
high efficiency noise filters in post regulator applications.
Unlike normal NPN transistor design, where the base to
emitter voltage drop and collector to emitter saturation
voltage limit the minimum dropout voltage, dropout
performance of the PNP output of these devices is limited
only by low Vce saturation voltage.
The TS29150 series is fully protected from damage due
to fault conditions. Linear current limiting is provided.
Output current during overload conditions is constant.
Thermal shutdown the device when the die temperature
exceeds the maximum safe operating temperature.
Transient protection allows device survival even when the
input voltage spikes above and below nominal. The
output structure of these regulators allows voltages in
excess of the desired output voltage to be applied without
reverse current flow.
Typical Application Circuit
Capacitor Requirement
The TS29150 series requires an output capacitor to
maintain stability and improve transient response is
necessary. The value of this capacitor is dependent upon
the output current, lower currents allow smaller
capacitors. TS29150 series regulators are stable with the
10uF minimum capacitor value at full load. Where the
regulator is powered from a source with high AC
impedance, a 0.1uF capacitor connected between input
and ground is recommended. The capacitor should have
good characteristics to above 250KHz. The capacitance
values will be improved transient response, ripple
rejection and output noise.
Minimum Load Current
The TS29150 series is specified between finite loads. If
the output current is too small leakage currents
dominate and the output voltage rises. A 10mA
minimum load current swamps any expected leakage
current across the operating temperature range.
Thermal Characteristics
TS29150 series linear regulators are simple to use, the
most complicated design parameters to consider are
thermal characteristics, thermal design requires the
following application specification parameters:
Maximum ambient temperature, Ta
Output current, Iout
Output voltage, Vout
Input voltage, Vin
We calculate the power dissipation of the regulator
from these numbers and the device parameters from
this data sheet. A heatsink may be required depending
on the maximum power dissipation and maximum
ambient temperature of the application. Under all
possible operating conditions, the junction temperature
must be within the range specified under absolute
maximum ratings. To determine if the heatsink is
required, the power dissipated by the regulator, P
D
must be calculated.
The below formula shows the voltages and currents for
calculating the P
D
in the regulator:
Iin = I
L
/ I
G
P
D
= (Vin-Vout) * I
L
+ (Vin) * I
G
Ex. P
D
= (3.3V-2.5V) * 1.5A + 3.3V * 11mA
= 1200mW + 36mW
= 1236mW
Remark: I
L
is output load current,
I
G
is ground current.
Vin is input voltage
Vout is output voltage
The next parameter which must be calculated is the
maximum allowable temperature rise, T
R
(max). this is
calculated by the using to formula:
T
R
(max) = T
J
(max) – T
A
(max)
Where: T
J
(max) is the maximum allowable junction
temperature, which is 125
o
C for commercial
grade parts.
T
A
(max) is the maximum ambient temperature
which will be encountered in the application.
相關PDF資料 |
PDF描述 |
|---|---|
| TS29150CM | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| TS29150CZ | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| TS29151CZ5-33 | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
| TS29152CZ5-33 | CAP TANT 33UF 6.3V 20% POLY SMD |
| TS29153CZ5-33 | 5.0 AMP POSITIVE VOLTAGE REGULATOR |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TS29150_07 | 制造商:TSC 制造商全稱:Taiwan Semiconductor Company, Ltd 功能描述:1.5A Ultra Low Dropout Voltage Regulator with Multi-Function |
| TS29150CM | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1.5A Ultra Low Dropout Fixed Positive Voltage Regulator |
| TS29150CM33 | 功能描述:低壓差穩壓器 - LDO 1.5A Ultra LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TS29150CM33 RN | 制造商:SKMI/Taiwan 功能描述:D2PACK;1.5AMP ULTRA LOW DROPOU |
| TS29150CM50 | 功能描述:低壓差穩壓器 - LDO 1.5A Ultra LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。