- 您現在的位置：買賣IC網 > PDF目錄385014 > TPS76733Q (Texas Instruments, Inc.) FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS PDF資料下載
參數資料
| 型號： | TPS76733Q |
| 廠商： | Texas Instruments, Inc. |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS |
| 中文描述： | 快速瞬態響應1 -低壓差電壓調節器 |
| 文件頁數： | 17/20頁 |
| 文件大?。?/td> | 292K |
| 代理商： | TPS76733Q |
TPS76715Q, TPS76718Q, TPS76725Q, TPS76727Q
TPS76728Q, TPS76730Q TPS76733Q, TPS76750Q, TPS76701Q
FAST-TRANSIENT-RESPONSE 1-A LOW-DROPOUT VOLTAGE REGULATORS
SLVS208C – MAY 1999 – REVISED SEPTEMBER 1999
17
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
reset indicator
The TPS767xx features a RESET output that can be used to monitor the status of the regulator. The internal
comparator monitors the output voltage: when the output drops to between 92% and 98% of its nominal
regulated value, the RESET output transistor turns on, taking the signal low. The open-drain output requires
a pullup resistor. If not used, it can be left floating. RESET can be used to drive power-on reset circuitry or as
a low-battery indicator. RESET does not assert itself when the regulated output voltage falls outside the
specified 2% tolerance, but instead reports an output voltage low relative to its nominal regulated value (refer
to timing diagram for start-up sequence).
regulator protection
The TPS767xx PMOS-pass transistor has a built-in back diode that conducts reverse currents when the input
voltage drops below the output voltage (e.g., during power down). Current is conducted from the output to the
input and is not internally limited. When extended reverse voltage is anticipated, external limiting may be
appropriate.
The TPS767xx also features internal current limiting and thermal protection. During normal operation, the
TPS767xx limits output current to approximately 1.7 A. When current limiting engages, the output voltage scales
back linearly until the overcurrent condition ends. While current limiting is designed to prevent gross device
failure, care should be taken not to exceed the power dissipation ratings of the package. If the temperature of
the device exceeds 150
°
C(typ), thermal-protection circuitry shuts it down. Once the device has cooled below
130
°
C(typ), regulator operation resumes.
power dissipation and junction temperature
Specified regulator operation is assured to a junction temperature of 125
°
C; the maximum junction temperature
should be restricted to 125
°
C under normal operating conditions. This restriction limits the power dissipation
the regulator can handle in any given application. To ensure the junction temperature is within acceptable limits,
calculate the maximum allowable dissipation, P
D(max)
, and the actual dissipation, P
D
, which must be less than
or equal to P
D(max)
.
The maximum-power-dissipation limit is determined using the following equation:
PD(max)
TJmax
TA
RJA
Where
T
J
max
is the maximum allowable junction temperature
R
θ
JA
is the thermal resistance junction-to-ambient for the package, i.e., 172
°
C/W for the 8-terminal
SOIC and 32.6
°
C/W for the 20-terminal PWP with no airflow.
T
A
is the ambient temperature.
The regulator dissipation is calculated using:
PD
VI
VO
IO
Power dissipation resulting from quiescent current is negligible. Excessive power dissipation will trigger the
thermal protection circuit.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS77215DGKR | 150-mA LDO REGULATORS WITH 8-PIN MSOP PACKAGING |
| TPS77118DGKRG4 | 150-mA LDO REGULATORS WITH 8-PIN MSOP PACKAGING |
| TPS77128DGKRG4 | Aluminum Electrolytic Radial Lead High Ripple Capacitor; Capacitance: 82uF; Voltage: 200V; Case Size: 12.5x25 mm; Packaging: Bulk |
| TPS77215DGKRG4 | Aluminum Electrolytic Radial Lead High Ripple Capacitor; Capacitance: 120uF; Voltage: 250V; Case Size: 12.5x40 mm; Packaging: Bulk |
| TPS77218DGKRG4 | Aluminum Electrolytic Radial Lead High Ripple Capacitor; Capacitance: 270uF; Voltage: 250V; Case Size: 18x40 mm; Packaging: Bulk |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS76733QD | 功能描述:低壓差穩壓器 - LDO Fast-Transient Response 1-A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS76733QDG4 | 功能描述:低壓差穩壓器 - LDO Fast-Transient Response 1-A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS76733QDR | 功能描述:低壓差穩壓器 - LDO Fast-Transient Response 1-A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS76733QDRG4 | 功能描述:低壓差穩壓器 - LDO Fast-Transient Response 1-A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| TPS76733QPWP | 功能描述:低壓差穩壓器 - LDO Fast-Transient Response 1-A RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。