- 您現在的位置：買賣IC網 > PDF目錄365926 > TPS61005DGSR SMPS Controller PDF資料下載
參數資料
| 型號： | TPS61005DGSR |
| 英文描述： | SMPS Controller |
| 中文描述： | 開關電源控制器 |
| 文件頁數： | 16/22頁 |
| 文件大小： | 392K |
| 代理商： | TPS61005DGSR |
TPS61000, TPS61001, TPS61002, TPS61003, TPS61004, TPS61005, TPS61006, TPS61007
SINGLE-AND DUAL-CELL BOOST CONVERTER WITH START-UP INTO FULL LOAD
SLVS279B – MARCH 2000 – REVISED AUGUST 2000
16
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
With those parameters it is possible to calculate the value for the inductor:
L
VBATx VOUT– VBAT
ILx f x VOUT
(4)
Parameter f is the switching frequency and
I
L
is the ripple current in the inductor, i.e., 20% x I
L
.
In this example, the desired inductor will have the value of 12
μ
H. With this calculated value and the calculated
currents, it is possible to chose a suitable inductor. Care has to be taken that load transients and losses in the
circuit can lead to higher currents as estimated in equation 3. Also, the losses in the inductor caused by magnetic
hysteresis losses and copper losses are a major parameter for total circuit efficiency.
The following inductors from different suppliers were tested. All will work with the TPS6100x converter within
their specified parameters:
Table 1. Recommended Inductors
VENDOR
Coilcraft
PART NUMBER
DO1608P Series
DS1608P Series
DO3308 Series
Coiltronics
UP1B Series
UP2B Series
Murata
LQH3N Series
Sumida
CD43 Series
CD54 Series
CDR74B Series
TDK
NLC453232T Series
capacitor selection
The major parameter necessary to define the output capacitor is the maximum allowed output voltage ripple of
the converter. This ripple is determined by two parameters of the capacitor, the capacitance and the ESR. It is
possible to calculate the minimum capacitance needed for the defined ripple, supposing that the ESR is zero.
Cmin
IOUTx VOUT– VBAT
f x
V x VOUT
(5)
Parameter f is the switching frequency and
V is the maximum allowed ripple.
With a chosen ripple voltage of 15 mV, a minimum capacitance of 10
μ
F is needed. The total ripple will be larger
due to the ESR of the output capacitor. This additional component of the ripple can be calculated using the fol-
lowing equation:
VESR
IOUTx RESR
(6)
相關PDF資料 |
PDF描述 |
|---|---|
| TPS61006DSGR | Analog IC |
| TPS61010DGSR | Analog IC |
| TPS61011DGSR | Analog IC |
| TPS61012DGSR | Analog IC |
| TPS61013DGSR | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS61005DGSRG4 | 功能描述:直流/直流開關調節器 Lo-In Voltage Boost Converter RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61005DGST | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SINGLE- AND DUAL-CELL BOOST CONVERTER WITH START-UP INTO FULL LOAD |
| TPS61006 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:SINGLE-CELL BOOST CONVERTER WITH START-UP INTO FULL LOAD |
| TPS61006DGS | 功能描述:直流/直流開關調節器 3.3V 100mA Boost RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| TPS61006DGS | 制造商:Texas Instruments 功能描述:BOOST CONVERTER 3.3V SMD 61006 |
發布緊急采購，3分鐘左右您將得到回復。