參數資料
型號: TPS60101PWPR
英文描述: Analog IC
中文描述: 模擬IC
文件頁數: 15/22頁
文件大?。?/td> 421K
代理商: TPS60101PWPR
TPS60100
REGULATED 3.3 V 200-mA LOW-NOISE
CHARGE PUMP DC/DC CONVERTER
SLVS213B – MAY 1999 – REVISED SEPTEMBER 1999
15
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
detailed description (continued)
shutdown
Driving ENABLE low places the device in shutdown mode. This disables all switches, the oscillator, and control
logic. The device typically draws 0.05-
μ
A (1-
μ
A max) of supply current in this mode. Leakage current drawn from
the output is as low as 1
μ
A max. The device exits shutdown once ENABLE is set high level. The typical no-load
shutdown exit time is 10
μ
s. When the device is in shutdown, the load is isolated from the input and the output
is high impedance.
external clock signal
If the device shall operate at a user defined frequency, an external clock signal can be used. Therefore, SYNC
needs to be connected to IN and the external oscillator signal can drive 3V8. The maximum external frequency
is limited to 800 kHz. The switching frequency of the converter is half of the external oscillator frequency. It is
recommended to operate the charge pump in constant-frequency mode if an external clock signal is used so
that the output noise contains only well-defined frequency components.
IN
IN
C1+
C1–
ENABLE
PGND GND
OUT
OUT
FB
C2+
C2–
SYNC
SKIP COM 3V8
INPUT
1.8 V to 3.6 V
CIN
10
μ
F
OUTPUT
3.3 V 200 mA
CO = 22
μ
F
C2F
2.2
μ
F
C1F
2.2
μ
F
+
OFF/ON
TPS60100
+
External Clock
Figure 32. Typical Operating Circuit TPS60100 With External Synchronization
undervoltage lockout
The TPS60100 has an undervoltage lockout feature that deactivates the device and places it in shutdown mode
when the input voltage falls below 1.6 V.
Powered by ICminer.com Electronic-Library Service CopyRight 2003
相關PDF資料
PDF描述
TPS60110PWPR Analog IC
TPS60111PWPR Analog IC
TPS60124 Regulated 3.0-V High Efficiency Charge Pump With Low Battery Indicator
TPS60125 Regulated 3.0-V High Efficiency Charge Pump With Power Good Indicator
TPS60212DGSR DC-to-DC Voltage Converter
相關代理商/技術參數
參數描述
TPS60101PWPRG4 功能描述:電荷泵 Reg 3.3V Lo-Ns Chrg Pump DC-DC Cnvtr RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube
TPS60110 制造商:TI 制造商全稱:Texas Instruments 功能描述:REGULATED 5-V 300-mA LOW-NOISE CHARGE PUMP DC/DC CONVERTER
TPS60110_13 制造商:TI 制造商全稱:Texas Instruments 功能描述:REGULATED 5-V 300-mA LOW-NOISE CHARGE PUMP DC/DC CONVERTER
TPS60110EVM-132 功能描述:電源管理IC開發工具 3 batt cells/1 Li-Ion cell RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
TPS60110PWP 功能描述:電荷泵 Reg 5V Lo-Ns Charge Pump DC-DC Cnvtr RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube