- 您現在的位置：買賣IC網 > PDF目錄385947 > TPS60100EVM (Texas Instruments, Inc.) TPS60100 DC/DC Converter Evaluation Module(TPS60100 DC/DC轉換器的評估模塊) PDF資料下載
參數資料
| 型號： | TPS60100EVM |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | TPS60100 DC/DC Converter Evaluation Module(TPS60100 DC/DC轉換器的評估模塊) |
| 中文描述： | TPS60100的DC / DC轉換器評估板（TPS60100的DC / DC轉換器的評估模塊） |
| 文件頁數： | 8/10頁 |
| 文件大?。?/td> | 52K |
| 代理商： | TPS60100EVM |
Layout of the EVM
1-4
TPS60100 and TPS60110 EVM
(see Table 1–2). Each connector has the supply (In) signal at the first pin, the
logic input at the second pin, and the ground (GND) signal at the third pin. So
it is possible to use jumpers to connect the pin either to input (supply voltage)
or to ground. It is also possible to connect any other signal by using an external
signal source and connecting it to the second pin. These five pins are logic lev-
el CMOS inputs; for the specification of the levels, refer to the datasheets. The
value of the signal connected to the logic pins can be higher than the supply
voltage, but do not exceed the maximum ratings (see datasheets).
Leaving the second pin of these five three-pin connectors open s not allowed
either connect it via a jumper to the first or third pin, or use an appropriate exter-
nal signal source with the appropriate signal level.
Table 1–2.Selected Modes by Connecting the Jumpers
Name
Connected to GND (Pin 3)
3V8
3.3 V at the output
(TPS60110: internal clock is used)
Com
Push-pull mode
EN
Device is disabled
Skip
Fixed-frequency mode
Sync
Device is internally synchronized
Connected to In (Pin 1)
3.8 V at the output
(TPS60110: Do not connect to IN)
Single-ended mode
Device is enabled
Pulse-skip mode
Device is externally synchronized, connect the external
clock to the second pin of connector 3V8.
1.3
Layout of the EVM
Figure 1–2 and Figure 1–3 show the placement of the components and the lay-
out of the EVM. Components are placed only on the top layer of the board. The
signal on the bottom is the ground signal (GND). For good performance, the
entire bottom layer is one GND plane, only interrupted by some vias.
Figure 1–2.Placement of the Components
相關PDF資料 |
PDF描述 |
|---|---|
| TPS60110EVM | TPS60110 DC/DC Converter Evaluation Module(TPS60110 DC/DC轉換器的評估模塊) |
| TPS60110(中文) | Regulated 5-V 300-mA Low-Noice Charge Pump DC/DC Converter(5V,300mA低噪聲電荷泵DC/DC轉換器) |
| TPS61020EVM | High-Efficiency Synchronous Boost Converters Evaluation Module(高效率同步升壓轉換器TPS61020評估模塊) |
| TPS61045DRB | DIGITALLY ADJUSTABLE LCD BOOST CONVERTER |
| TPS611 | Insulation Displacement (IDC) Connector; No. of Contacts:14; Contact Termination:IDC; Gender:Female; Contact Plating:Nickel; Leaded Process Compatible:Yes; Peak Reflow Compatible (260 C):Yes; Pitch Spacing:0.05" RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS60100EVM-131 | 功能描述:電源管理IC開發工具 2 batt cells RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| TPS60100PWP | 功能描述:電荷泵 Reg 3.3V Lo-Ns Chrg Pump DC-DC Cnvtr RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| TPS60100PWPG4 | 功能描述:電荷泵 Reg 3.3V Lo-Ns Chrg Pump DC-DC Cnvtr RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| TPS60100PWPR | 功能描述:電荷泵 Reg 3.3V Lo-Ns Chrg Pump DC-DC Cnvtr RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| TPS60100PWPRG4 | 功能描述:電荷泵 Reg 3.3V Lo-Ns Chrg Pump DC-DC Cnvtr RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。