- 您現在的位置：買賣IC網 > PDF目錄365925 > TPS5615CPWPR Voltage-Mode SMPS Controller PDF資料下載
參數資料
| 型號： | TPS5615CPWPR |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Voltage-Mode SMPS Controller |
| 中文描述： | 電壓模式開關電源控制器 |
| 文件頁數： | 26/34頁 |
| 文件大小： | 811K |
| 代理商： | TPS5615CPWPR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁當前第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
TPS56302
DUAL-OUTPUT LOW-INPUT-VOLTAGE
DSP POWER SUPPLY CONTROLLER WITH SEQUENCING
SLVS289A
–
MARCH 2000
–
REVISED OCTOBER 2000
26
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
output capacitor RMS current
Assuming the inductor ripple current totally goes through the output capacitor to ground, the RMS current in the
output capacitor can be calculated as:
12
I
I
=
O(rms)
Where I
O(rms)
is the maximum RMS current in the output capacitor (A);
I is the peak-to-peak inductor ripple
current (A).
Example:
I = 1 A, so I
O(rms)
= 0.29 A
input capacitor RMS current
The input capacitor RMS current is important for input capacitor design. Assuming the input ripple current totally
goes into the input capacitor to the power ground, the RMS current in the input capacitor can be calculated as:
II(rms)
IO
2
D
(1
D)
1
12
D
Iripple
2
Where I
I(rms)
is the input RMS current in the input capacitor (A); I
O
is the output current (A); I
ripple
is the
peak-to-peak output inductor ripple current; D is the duty cycle. From the equation, it can be seen that the
highest input RMS current usually occurs at the lowest input voltage, so it is the worst case design for input
capacitor ripple current.
Example:
I
O
= 5 A; D = 0.36; I
ripple
= 1 A,
Then, I
I(rms)
= 2.46 A
layout and component value consideration
Good power supply results will only occur when care is given to proper design and layout. Layout and
component value will affect noise pickup and generation and can cause a good design to perform with less than
expected results. With a range of current from milliamps to tens or even hundreds of amps, good power supply
layout and component selection, especially for a fast ripple controller, is much more difficult than most general
PCB design. The general design should proceed from the switching node to the output, then back to the driver
section, and, finally, to placing the low-level components. In the following list are several specific points to
consider before layout and component selection for TPS56302:
1.
All sensitive analog components should be referenced to ANAGND. These include components connected
to SLOWST, DROOP, IOUT, OCP, VSENSE, VREFB, VHYST, BIAS, and LOSENSE/LOHIB.
2.
The input voltage range for TPS56302 is low from 2.8-V to 5.5-V, so it has a voltage tripler (charge pump)
inside to deliver proper voltage for internal circuitry. To avoid any possible noise coupling, a low ESR
capacitor on V
CC
is recommended.
For the same reason in Item 2, the ANAGND and DRVGND should be connected as close as possible to
the IC.
3.
4.
The bypass capacitor should be placed close to the TPS56302.
相關PDF資料 |
PDF描述 |
|---|---|
| TPS5618CPWPR | Voltage-Mode SMPS Controller |
| TPS5625CPWPR | Voltage-Mode SMPS Controller |
| TPS60100PWPR | Analog IC |
| TPS60101PWPR | Analog IC |
| TPS60110PWPR | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TPS5615EVM-114 | 功能描述:HIGH-PERFORMANCE SYNCHRONOUS BUC RoHS:是 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC，步升 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓撲結構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
| TPS5615EVM-115 | 功能描述:HIGH-PERFORMANCE SYNCHRONOUS BUC RoHS:是 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC，步升 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓撲結構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
| TPS5615PWP | 功能描述:IC BUCK REG CNTRLR 28-HTSSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 專用型 系列:- 標準包裝:2,000 系列:- 應用:控制器，DSP 輸入電壓:4.5 V ~ 25 V 輸出數:2 輸出電壓:最低可調至 1.2V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:30-TFSOP（0.173"，4.40mm 寬） 供應商設備封裝:30-TSSOP 包裝:帶卷 (TR) |
| TPS5618EVM-106 | 功能描述:HIGH-PERFORMANCE SYNCHRONOUS BUC RoHS:是 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC，步升 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓撲結構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
| TPS5618EVM-113 | 功能描述:HIGH-PERFORMANCE SYNCHRONOUS BUC RoHS:是 類別:編程器，開發系統 >> 評估板 - DC/DC 與 AC/DC（離線）SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC，步升 輸出及類型:1，非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓撲結構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
發布緊急采購，3分鐘左右您將得到回復。